If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Removal of hot glue
From bodywork
Hot on the heels of my post about dampers, I seem to have been a bit 'enthusiastic' on the early morning run today. The bottom section of my Zender front spoiler became partially detached, and was persuaded the rest of the way. I am actually quite happy about this as (contrary to popular belief here) I am not a huge fan of plastic add ons. [1] This one appears to have been glued on, and there is residue around the dhin where it was mounted. Suggestions? [1] The pram handle stays. -- Catman MIB#14 SKoGA#6 TEAR#4 BOTAFOF#38 Apostle#21 COSOC#3 Tyger, Tyger Burning Bright (Remove rust to reply) 116 Giulietta 3.0l Sprint 1.7 156 TS 166 V6 2.5 145 2.0 Cloverleaf 156 V6 2.5 S2 Triumph Sprint ST 1050: It's blue, see. www.cuore-sportivo.co.uk |
Ads |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Plastic Glue | Yme | VW water cooled | 0 | March 20th 07 07:41 PM |
Glue on headliner | Bruce Fraser | VW air cooled | 3 | May 1st 06 04:42 AM |
Glue-on rear mirro | [email protected] | Technology | 5 | October 4th 05 12:53 PM |
heat & glue | TF | Corvette | 6 | June 2nd 05 10:54 PM |
Glue for Bezels? | Jim M | Corvette | 0 | March 11th 05 02:12 PM |