If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
1973 Charger egr valve should I .........
I recently purchased a 73 charger w/ a 318 and the egr valve was blocked off
w/ a piece of steel. my question is should I spend the 40.00 to replace this or leave well enough alone? will this help the performance any or is this valve just along for the ride? TIA Greg |
Ads |
#2
|
|||
|
|||
1973 Charger egr valve should I .........
Being an "Old Geezer", I and my friends were buying new Mopars back then. A buddy and I bought a matched set of 1974 Duster 360 4bbl cars. That being said, the first thing we always did when we got them home was disconnect or remove any and all polution control devices. Another little bit of trivia, the 3/4 and 1Ton Dodge trucks were not required to have EGR or Catalyst until 1979 models. The steel plate you are seeing came stock on those trucks to eliminate the lousy EGR system. Unless you are going for a "show correct" engine, or need to pass some communist emission test leave it as is! Good luck, Bruce |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reposts of murph1012 for those who couldn't see them - File 01 of 46 - 1973 Dodge Charger SE fvr.jpg (0/1) | Mike G[_2_] | Auto Photos | 0 | November 27th 06 08:59 AM |
Reposts of murph1012 for those who couldn't see them - File 01 of 46 - 1973 Dodge Charger SE fvr.jpg (1/1) | Mike G[_2_] | Auto Photos | 0 | November 27th 06 08:59 AM |
Valve,Butterfly valve,Globe valve,Check valve,Ball valve,Plug valve,Marine valve,Gate valve,Flow control valve | [email protected] | Alfa Romeo | 0 | April 17th 06 08:20 AM |
FS 1973 Charger BB | Dodge | 0 | October 15th 05 08:30 PM | |
FS 1973 Charger 400/Auto Slapstick | Dodge | 0 | December 10th 04 08:18 PM |