If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Piston question.....
how good is Mahle brand for quality?
im getting ready to rebuild my 1600 and a friend has a set of 85.5 mahles he gave me with about 1500 miles on them... maybe less because he went to 90.5 and they were just sittin on a sshelf |
Ads |
#2
|
|||
|
|||
Piston question.....
Brian "Grimace" H. wrote:
> how good is Mahle brand for quality? > > im getting ready to rebuild my 1600 and a friend has a set of 85.5 mahles > he gave me with about 1500 miles on them... maybe less because he went to > 90.5 and they were just sittin on a sshelf Mahle is second to none. So good in fact that every new Harley Davidson has come with them for around 20 years. Tony |
#3
|
|||
|
|||
Piston question.....
thanks very much... i knew i had heard the name before but never
remembered whether it was good or bad.. this is my first aircooled rebuild.... "Anthony W" > wrote in message news:RqqOg.10251$Rw2.3341@trnddc02... > Brian "Grimace" H. wrote: >> how good is Mahle brand for quality? >> >> im getting ready to rebuild my 1600 and a friend has a set of 85.5 >> mahles he gave me with about 1500 miles on them... maybe less because >> he went to 90.5 and they were just sittin on a sshelf > > > Mahle is second to none. So good in fact that every new Harley Davidson > has come with them for around 20 years. > > Tony |
#4
|
|||
|
|||
Piston question.....
Brian "Grimace" H. wrote:
> thanks very much... i knew i had heard the name before but never > remembered whether it was good or bad.. this is my first aircooled > rebuild.... I'd worked on air cooled bikes for years but I found the VW engine to be very different. Be sure and ask lots of questions and don't put to much stock in the idiot's guide... Tony |
#5
|
|||
|
|||
Piston question.....
ive been asking questions on this NG and the sambas forums for about 8
months now... its so much to take in.... tell ya what if i went into air cooleds the way i do a 350small block id be f**** "Anthony W" > wrote in message news:LHrOg.7232$FS.4828@trnddc04... > Brian "Grimace" H. wrote: >> thanks very much... i knew i had heard the name before but never >> remembered whether it was good or bad.. this is my first aircooled >> rebuild.... > > I'd worked on air cooled bikes for years but I found the VW engine to be > very different. Be sure and ask lots of questions and don't put to much > stock in the idiot's guide... > > Tony |
#6
|
|||
|
|||
Piston question.....
Brian "Grimace" H. wrote:
> ive been asking questions on this NG and the sambas forums for about 8 > months now... > its so much to take in.... tell ya what if i went into air cooleds the > way i do a 350small block id be f**** There is a lot larger volume of info on SB Chevy engines. I will be checking out the Samba forums pretty soon. There has been a big brain drain from here in the past few years. Tony |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A Physics Question | Alan Baker | Driving | 1 | September 9th 06 05:49 AM |
2005 Mustang Fog Light Question | Craig Shaffer | Ford Mustang | 2 | June 23rd 06 06:24 PM |
1993 Saturn Fuel Filter Question OHC (SOHC)? | [email protected] | Saturn | 7 | May 21st 06 08:39 PM |
stuck caliper... | Abeness | Honda | 113 | December 7th 04 01:22 AM |
Rear disk caliper question | HAKSAW | Saturn | 11 | September 17th 04 05:35 AM |