|If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.|
||Thread Tools||Display Modes|
Well, I am having 123/100/100/50 (I am still searching for "the
right" Overall, this isn't the final one, probably "the right" one will be a
little bit stronger), "Allow..." unchecked, in-game 20.0/50, linear,
cockpitLookDeadZone 0.000000, profiler sensitivity 50%.
I am testing with Skippy on Spa.
Now, believe me, I do feel STRONG forces with these settings, but my
FFB meter is 98% of the time in green. Now, doesn't this tell you that I am
doing something RIGHT.
This is in tune with what I thought, and what I wrote about in
iRacing's forum, long time ago. Damper and Spring CALM DOWN FFB forces.
Instead of not using Damper and Spring, and keep FFB forces ERATIC,
WITHOUT A CONTROL, and therefore being forced to use VERY LOW strength, you
SHOULD use the FFB like it is INTENDED to be used, with Damper and Spring,
and only then you will get expected (by designers) results, and expected and
designed behaviour of your FFB wheel.
|Thread||Thread Starter||Forum||Replies||Last Post|
|FFB...almost done||Mario Petrinovic||Simulators||14||November 23rd 12 10:59 PM|
|FFB meter||Mario Petrinovic||Simulators||0||November 16th 12 11:33 PM|
|New PC's FFB||Mario Petrinovic||Simulators||40||May 27th 12 10:45 PM|
|BMW Air mass meter (AKA: air flow meter or MAF) issues and cheapalternatives||DCA||BMW||1||September 13th 07 05:21 PM|
|G25 v. ECCI - To FFB or not to FFB||[email protected]||Simulators||1||August 17th 07 02:35 PM|