If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Help with blinker unit on C5
I am 99% sure that the blinker unit in my C5 is toast. I belive it sits
behind, or is part of the hazard light switch next to the center vent. My question is, how hard is it to replace that unit ? Do I have to pull the whole dash, or is there a secret to getting in there ? Is it just a relay or the whole hazard unit ? Thanks for any input, Kevin 2000 Black Coupe |
Ads |
#2
|
|||
|
|||
"Corvette" > wrote in message ... >I am 99% sure that the blinker unit in my C5 is toast. I belive it sits >behind, or is part of the hazard light switch next to the center vent. My >question is, how hard is it to replace that unit ? Do I have to pull the >whole dash, or is there a secret to getting in there ? Is it just a relay >or the whole hazard unit ? > > Thanks for any input, > > Kevin > 2000 Black Coupe You pretty much got it figured right, remove the console top and then the dash pad and the bracket that holds the Hazard switch to the dash pad, replace the switch/blinker and reverse the procedure to reassemble. I can give you some numbers or a PDF sheet if you think you need it. Time is about 6 hours if you don't break anything. -- Dad 05 C6 Silver/Red 6spd Z51 72 Shark Black/Black/4spd |
#3
|
|||
|
|||
"Corvette" > wrote in message ... >I am 99% sure that the blinker unit in my C5 is toast. I belive it sits >behind, or is part of the hazard light switch next to the center vent. My >question is, how hard is it to replace that unit ? Do I have to pull the >whole dash, or is there a secret to getting in there ? Is it just a relay >or the whole hazard unit ? > > Thanks for any input, > > Kevin > 2000 Black Coupe You pretty much got it figured right, remove the console top and then the dash pad and the bracket that holds the Hazard switch to the dash pad, replace the switch/blinker and reverse the procedure to reassemble. I can give you some numbers or a PDF sheet if you think you need it. Time is about 6 hours if you don't break anything. -- Dad 05 C6 Silver/Red 6spd Z51 72 Shark Black/Black/4spd |
#4
|
|||
|
|||
Thanks for the input. I thought somebody had posted a method where you could
get at it by removing just the vent, and not the whole dash. If it's 6 hours, then the dealer can do it, they quoted about $130 Kevin "Dad" > wrote in message ... > > "Corvette" > wrote in message > ... >>I am 99% sure that the blinker unit in my C5 is toast. I belive it sits >>behind, or is part of the hazard light switch next to the center vent. My >>question is, how hard is it to replace that unit ? Do I have to pull the >>whole dash, or is there a secret to getting in there ? Is it just a relay >>or the whole hazard unit ? >> >> Thanks for any input, >> >> Kevin >> 2000 Black Coupe > You pretty much got it figured right, remove the console top and then the > dash pad and the bracket that holds the Hazard switch to the dash pad, > replace the switch/blinker and reverse the procedure to reassemble. I can > give you some numbers or a PDF sheet if you think you need it. Time is > about 6 hours if you don't break anything. > -- > Dad > 05 C6 Silver/Red 6spd Z51 > 72 Shark Black/Black/4spd > > > |
#5
|
|||
|
|||
Thanks for the input. I thought somebody had posted a method where you could
get at it by removing just the vent, and not the whole dash. If it's 6 hours, then the dealer can do it, they quoted about $130 Kevin "Dad" > wrote in message ... > > "Corvette" > wrote in message > ... >>I am 99% sure that the blinker unit in my C5 is toast. I belive it sits >>behind, or is part of the hazard light switch next to the center vent. My >>question is, how hard is it to replace that unit ? Do I have to pull the >>whole dash, or is there a secret to getting in there ? Is it just a relay >>or the whole hazard unit ? >> >> Thanks for any input, >> >> Kevin >> 2000 Black Coupe > You pretty much got it figured right, remove the console top and then the > dash pad and the bracket that holds the Hazard switch to the dash pad, > replace the switch/blinker and reverse the procedure to reassemble. I can > give you some numbers or a PDF sheet if you think you need it. Time is > about 6 hours if you don't break anything. > -- > Dad > 05 C6 Silver/Red 6spd Z51 > 72 Shark Black/Black/4spd > > > |
#6
|
|||
|
|||
"Corvette" > wrote in message ... > Thanks for the input. I thought somebody had posted a method where you > could get at it by removing just the vent, and not the whole dash. If it's > 6 hours, then the dealer can do it, they quoted about $130 > > Kevin > If you want to get into it further I can send you a copy of the R&R sheet, good luck. -- Dad 05 C6 Silver/Red 6spd Z51 72 Shark Black/Black/4spd |
#7
|
|||
|
|||
"Corvette" > wrote in message ... > Thanks for the input. I thought somebody had posted a method where you > could get at it by removing just the vent, and not the whole dash. If it's > 6 hours, then the dealer can do it, they quoted about $130 > > Kevin > If you want to get into it further I can send you a copy of the R&R sheet, good luck. -- Dad 05 C6 Silver/Red 6spd Z51 72 Shark Black/Black/4spd |
#8
|
|||
|
|||
"Corvette" > wrote in message ... > Thanks for the input. I thought somebody had posted a method where you could > get at it by removing just the vent, and not the whole dash. If it's 6 > hours, then the dealer can do it, they quoted about $130 That would be 2 to 3 hours then, for them. > > Kevin > > > > "Dad" > wrote in message > ... > > > > "Corvette" > wrote in message > > ... > >>I am 99% sure that the blinker unit in my C5 is toast. I belive it sits > >>behind, or is part of the hazard light switch next to the center vent. My > >>question is, how hard is it to replace that unit ? Do I have to pull the > >>whole dash, or is there a secret to getting in there ? Is it just a relay > >>or the whole hazard unit ? > >> > >> Thanks for any input, > >> > >> Kevin > >> 2000 Black Coupe > > You pretty much got it figured right, remove the console top and then the > > dash pad and the bracket that holds the Hazard switch to the dash pad, > > replace the switch/blinker and reverse the procedure to reassemble. I can > > give you some numbers or a PDF sheet if you think you need it. Time is > > about 6 hours if you don't break anything. > > -- > > Dad > > 05 C6 Silver/Red 6spd Z51 > > 72 Shark Black/Black/4spd > > > > > > > > |
#9
|
|||
|
|||
"Corvette" > wrote in message ... > Thanks for the input. I thought somebody had posted a method where you could > get at it by removing just the vent, and not the whole dash. If it's 6 > hours, then the dealer can do it, they quoted about $130 That would be 2 to 3 hours then, for them. > > Kevin > > > > "Dad" > wrote in message > ... > > > > "Corvette" > wrote in message > > ... > >>I am 99% sure that the blinker unit in my C5 is toast. I belive it sits > >>behind, or is part of the hazard light switch next to the center vent. My > >>question is, how hard is it to replace that unit ? Do I have to pull the > >>whole dash, or is there a secret to getting in there ? Is it just a relay > >>or the whole hazard unit ? > >> > >> Thanks for any input, > >> > >> Kevin > >> 2000 Black Coupe > > You pretty much got it figured right, remove the console top and then the > > dash pad and the bracket that holds the Hazard switch to the dash pad, > > replace the switch/blinker and reverse the procedure to reassemble. I can > > give you some numbers or a PDF sheet if you think you need it. Time is > > about 6 hours if you don't break anything. > > -- > > Dad > > 05 C6 Silver/Red 6spd Z51 > > 72 Shark Black/Black/4spd > > > > > > > > |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
In dash audio unit... What is it? | Noozer | Audi | 2 | March 25th 17 03:18 PM |
The wiper control unit isn't where it should be??? | Tim Stevens | BMW | 2 | October 28th 04 06:22 PM |
Will this unit go in my 2000 A4? | Kyle Tucker | Audi | 2 | October 11th 04 07:37 PM |
How do I replace a 1999 A6 Avant front blinker bulb...? | Norman Weiler | Audi | 1 | June 18th 04 01:44 AM |