View Single Post
  #9  
Old July 18th 04, 09:49 PM
David Teichholtz
external usenet poster
 
Posts: n/a
Default


"Gary Compton" > wrote in message
...
> David:
>
> How would you make a new hole? Seems difficult.



Nah.. Use a drill bit to measure the width of the current slot. After
marking where you want the new slot, use the bit that matched the width and
drill two holes, one at each end of the slot. Then use your pneumatic metal
cutting wheel (wizzer wheel) and cut the metal to connect the two holes.
Finish up with a file and you are done. A standard brake adjusting rubber
cap will then be used to seal the slot, exactly as the current one is
sealed.

-David


Ads