Jacob wrote:
> CORRECTION: I had the ohm meter on the 200k setting, which is why I
> could not get a reading. I didn't expect the resistance to be so high.
> I tested them on the 20k setting and got 7.0 ~ 10.0 for all the wires.
> I assume that is ok, since I read that below 25k is good. I wiggled
> them around and the resistance did not change much.
>
doesn't mean much - it's /leakage/ that's the problem and the average
ohm meter doesn't test that at all. at $34 for a new set of leads that
need replacing periodically anyway, i'd replace them to eliminate them
from the equation.