In article ews.net>, DmitryKovtun wrote:
>
> "Howard Juneau" > wrote in
> message nk.net...
>>I haven't been able to get a JMC hydraulic clutch linkage to bleed
>>properly.
>> Unfortunately, I have no documentation for this unit, and find none
>> online.
>> If you've had any success in bleeding on of these units, please post the
>> procedure you used. Thanks!
>>
>>
>
> punch a small hole in the lowest part of the hose, then open the cap.
> That should cause the JMC to bleed out.

And how will he get to work again afterwards?