bertbarndoor wrote:
>
> Here is a link to the article:
> http://www.tegger.com/hondafaq/tsb/crv/x00-901e.pdf
>
> Here is my previous post:
>
> What could this be?
>
> It all started about a week ago. Whenever I turned in one direction
> (can't remember if it was right or left) the left rear wheel would
> squeek (sounded like it was once per revolution, *squeak* *squeak*
> *squeak* faster or slower depending on my speed.
>
> Now, for the last 2 days, the wheel squeaks or groans in any direction.
> At low speeds, especially while reversing, it sounds like a major
> groan. (like a submarine close to buckleing under metal fatigue from
> extreme pressure in the movies) rrrrrrrrrrrrrr
> Speeding up, it becomes a screeching or squeaking.
>
> One more thing, not sure if it is related. I had a look at all the
> rotors and it seems that in the effected area, there is about a quarter
> to a half inch what isn't warn on the outside of the rotor and instead
> of the nice shiny metal look, there is some rust. On all my other
> rotors, there appears to be clean metal (where the pads contact) right
> to the edge of the outside of the rotor.
>
> Any ideas? I'm hoping part of the break pad is screwed up and that's
> it. Thanks,
>
> Rob
---------------------------

Look thru all of Tegger's FAQ and see the part about siezed caliper
sliders. Sounds like you've got one.
Change the Dual Pump Fluid every 30,000 miles or two years. Add edots to
the chart in the manual. They're missing.

'Curly'