June 25th 09, 01:03 PM
posted to rec.autos.makers.jeep+willys
|
|
Problem with 4WD instrument panel light
Will try it.
Thanks Doug
--
..
"DougW" > wrote in message
...
> Mabar wrote:
>> 2006 Jeep Wrangler Rubicon - about 66000 miles
>>
>> When transfer case lever is in 2WD High - 4WD light is ON on the
>> instrument panel
>>
>> When transfer case lever is in 4WD High - 4WD light is OFF on the
>> instrument panel. Exactly opposite of the way it should be. This
>> happened about 6 months ago, but corrected itself after a couple of
>> days
>> When transfer case lever is in 4WD LO - 4WD light is ON on the
>> instrument panel - correct
>>
>> 4WD system works correctly, transfer case lever is adjusted
>> correctly, and yes I am sure I am in 2WD high, 4WD high or 4WD lo
>> regardless of what the instrument panel light shows
>>
>> Would this be a bad switch? If so, where is it and how do I replace
>> it?
>> Thanks in advance for any help
>
> From what I have read it's not a switch, more of a variable resistor.
> Could be a bit of corrosion. I'd clean the connector on the tranfer
> case sender.
>
> Try here http://www.jeepfan.com/tech/JKLockerHacks.php
>
> --
> DougW
>
|