View Single Post
  #3  
Old November 11th 09, 04:44 AM posted to rec.autos.makers.saturn
Hackamore
external usenet poster
 
Posts: 2
Default crankshaft position sensor error?


Hi,

that would make sense... once I get it some gas it runs fine.

I'll check connections first... a free fix is always good.

but is it difficult to replace the crank sensor? if it's not sending the
signal to turn on the fuel pump it'll do exactly what mine's doing...
then when it finally flips on it runs fine.

the O2 sensor in front was a breeze.

ttyl

Oppie wrote:
> I had an intermittent crank angle sensor on my LW300 that was making me
> crazy. It didn't throw a code but caused a few backfires that killed two
> MAP sensors. No codes were thrown except lean bank 1 and lean bank 2.
> Both were a result of a damaged MAP. We finally figured out that when
> the engine died, fuel pump wasn't running. Fuel pump is supposed to run
> for about two seconds on key on and then continue while cranking while
> crank sensor pulses sensed. In my case pump came on at key on but not
> during cranking. I finally told Saturn to just change the sensor since
> they could not duplicate the failures. I got stuck on the road twice.
> Cost about $200 and has not been a problem in the last 2 years.
>
> Crank sensor is a magnetic sensor that senses gear teeth on the
> crankshaft. There are 36 equally spaced teeth with one tooth missing.
> The missing tooth corresponds to top dead center which the computer
> detects and is used to set all the engine timing. The crank sensor is
> the main timing element in the engine management system and coordinates
> timing of fuel injection and spark.
>
> In my case the coil was intermittently open. In other cases, gap between
> the sensor or internal magnetic strength may be off. I don't recall that
> there is any adjustment allowed, only replacement. Before you do replace
> the sensor, check that the electrical circuit is intact. That is that
> the wiring is not abraded or the connectors oxidized.
>
> Oppie
>
> "Hackamore" > wrote in message
> ...
>>
>> Hi,
>>
>> having some hard starting and it finally popped up a code.
>>
>> "crankshaft position sensor error"...
>>
>> what are the likely fixes?
>>
>> --
>>
>> Hackamore
>> http://www.hackamore.com
>> http://www.hackamoretravel.com

>



--

Hackamore
http://www.hackamore.com
http://www.hackamoretravel.com
Ads