"Percival P. Cassidy" wrote:
> but the PCV valve end of the hose was rather hard, and I'm not
> sure that it's sealing well to the new PCV valve.
I've never messed with my PCV valve - not sure how you would even know
that it needs replacing. Does the computer throw a code or something?
Is there enough hose before the bend so you could cut maybe 1/2" from
the end of the hose (the hardened part) so you have a fresh (soft)
section to connect to the valve?
> Any good suggestions for a way around this?
Have a look he
http://www.lhforums.net/forums/showt...ger-yay-or-nay
One suggestion - make the 90-bend with a short piece of metal pipe
(something from the plumbing section of home despot or similar). Then
all you need is a short length of straight tube.