"FBNE" > wrote in message
news
>I didn't break power to the motors and placed them bot in the full up
>position and then full down manually. No joy on either position. I
>am going to pickup a new relay (#43 I think) today and then start the
>VOM wire trace. Up until yesterday everything cycled fine. I have
>replaced the gear drive a number of times, so I am familiar with the
>difference of damaged cogs and total in-op. DO you have insight into
>the control module behind the right front light? Is there a
>troubleshoot for the module? It is too pricey to just buy and see if
>that is the problem.
>
>
No help to you there, but still think you have a limit switch issue.