"Big Al" > wrote in message
...
:
: "kenG2" > wrote in message
: . ..
: > You need the correct key and a paper clip wire to stick in the little
hole
: > while in acc..,however the theives use a slide hammer equipped with a
: > tapered screw in the keyhole and then a screwdriver,,Seems like they had
: no
: > problem everytime they attempted(and failed) to steal my mustang with
the
: > transmission lock.
: > Ken
:
: Without the key on an old car like that you can pick the lock and avoid a
: lot of trouble. I'm no locksmith but I've done it lots of times.
:
: Al
:

On some of the older models, if the ignition is well worn you can slide the
key in and out rapidly while putting forward force on the key (as in turning
it on to start it) and with some blind luck you may hit just the right spot
and it will turn BUT this is much more common in older GM vehicles than in
Fords. In older GMs it was pretty easy much of the time.

KJK
: