What metric do you use to estimate remaining brake pad life on a typical economy sedan?
On Mon, 10 Aug 2020 11:10:15 -0700 (PDT), N8N wrote:
> Another factor is riveted vs. bonded linings,
> you can run a bonded lining a lot thinner than a riveted one.
> 5mm might be thiiiiiis close to grinding the rivet heads.
That's a good point I hadn't remembered as I haven't seen riveted pads for
a long time, although I do remember them from the past.
They would groove a rotor in no time.
What I'm seeking is how long do YOU get on a set of front pads?
|