IIRC The cold start might receive power from the starter solenoid. So check
the wiring to there and also check to see that it does get power to that
wire wihle the starter is operating.
I am not sure where it grounds out if not through a thermostatic switch.

later,
dave
(One out of many daves)


"sealdogfish" > wrote in message
ups.com...
> Well I have temporarily resolved the problem, I was just buying this
> car last night so I wanted to make sure the problem wasnt too terrible
> before i bought it. It turns out the cold start injector was not
> getting any power and to make matters worse i mustve knocked the
> distributor feedback plug out but i found that early enough. So i
> shorted the injector straight to the battery when cranking and for a
> short while afterwards and it worked flawlessly (although a slightly
> rich mixture for a few seconds) So now my only problem is to find out
> why there is no voltage to the cold start. The temperature guage is
> also not working which i will have to sort out.
> Anyone got any ideas on why it would stall when stopped and in gear
> with the brake on? only did this twice in a 40 minute drive.
>
>