Kadron h40/44 eis accelerator check ball
 

Hi all ,
I'm trying to rebuild a set of solex kadron h40/44 eis carbs. I was getting no
gas when i moved the linkage or accelarator diafame. I pulled the nut that
shold have held the check ball for accelerator circuit .I used a 4 mm long
screw and stop came out. inside there was no ball but it did have small
plastic piece that was fit into the opening and seems to have a resess for a
ball.Not sure who or when last rebuild was. Does anyone know if this ball
bearing is the same size as one under the squirter tube. thanks


--
posted from
http://www.motorsforum.com/volkswage...all-77342-.htm
using MotorsForum's Web, RSS and Social Media Interface to
rec.autos.makers.vw.aircooled and other automotive groups

Kadron h40/44 eis accelerator check ball
 

replying to Larry Q, Larry Q wrote:
> Larry Q wrote:
>
> Hi all ,
> I'm trying to rebuild a set of solex kadron h40/44 eis carbs. I was getting
no
> gas when i moved the linkage or accelarator diafame. I pulled the nut that
shold
> have held the check ball for accelerator circuit .I used a 4 mm long screw
and
> stop came out. inside there was no ball but it did have small plastic piece
that
> was fit into the opening and seems to have a resess for a ball.Not sure who
or
> when last rebuild was. Does anyone know if this ball bearing is the same
size as
> one under the squirter tube. thanks


Just an update after pulling other carb apart found same small plastic piece
init. Best discription is like old golf tee. My carbs had come from So Cal in
1998 looked like they had never been apart. Still had the paint on the inlet
screw and gas filter screw . So I guess some where the ball was swapped for
these plastic pieces. Well carbs are back now just playing with fine adj.


--
posted from
http://www.motorsforum.com/volkswage...all-77342-.htm
using MotorsForum's Web, RSS and Social Media Interface to
rec.autos.makers.vw.aircooled and other automotive groups