Help with Kadron/Solex 40 dual carbs
 

We were rebuilding these carbs and when we out it back together the
acceleration circuit wasn't pumping any gas out of the nozzle. When we
were rebuilding them we removed the little brass cap in the float chamber
and there was a little silver ball and a black plastic plunger. We put it
together with the balls under the black plungers and on one side the
little ball kept falling out a little whole. Does anyone know how it's
supposed to go together?

Thnx

>We were rebuilding these carbs and when we out it back together the
>acceleration circuit wasn't pumping any gas out of the nozzle. When we
>were rebuilding them we removed the little brass cap in the float chamber
>and there was a little silver ball and a black plastic plunger. We put it
>together with the balls under the black plungers and on one side the
>little ball kept falling out a little whole. Does anyone know how it's
>supposed to go together?
>
>Thnx

If its a rael problem try A.J. Simms at http://lowbugget.com/ hes the expert on
kadrons.

Mario

The balls go under the brass squirter tubes.



volksbuggydriver wrote:

> We were rebuilding these carbs and when we out it back together the
> acceleration circuit wasn't pumping any gas out of the nozzle. When we
> were rebuilding them we removed the little brass cap in the float chamber
> and there was a little silver ball and a black plastic plunger. We put it
> together with the balls under the black plungers and on one side the
> little ball kept falling out a little whole. Does anyone know how it's
> supposed to go together?
>
> Thnx
>