|
|
Following the ABS troubleshooting steps; Have any suggestions? by
scube
Hey all,
My Car is a 1993 honda Accord with manual transmission.
I've had a problem with my ABS functionality for a few years now.
My car was falling apart so I slowly started to fix all its problems.
CV Axles (for an ABS car), strut replacement, muffler replacement and
finally I got my cruise...
( 1 2 3)
|
|
24 |
1,010 |
|
|
92 Jimmy - no fuel problem by
Everlast
Looking for a method to test my Vortec CPI Spider.
Please see my posting under Chevrolet Trucks.
Thanks
|
|
0 |
376 |
|
|
Turbocharger for Toyota sedans by
There seem to be aftermarket turbocharger application kits for a number
of cars including VW, Honda, etc.
But I haven't seen any for the Camry series. Maybe I have just not looked
far enough.
I would seem to me that a low boost turbo application could improve the
power available from one of...
|
April 15th 06 04:03 PM
by
|
0 |
516 |
|
|
Corvair at auto auction by
Hugo Schmeisser
Yesterday my wife and I attended an auto auction held by RM Auctions
near Toronto.
Among the vehciles was a 1961 Corvair, which had been conveniently left
with it engine cover open. I hade never seen a Corvair engine in the
metal before, so I studied it for a while. Two questions...
( 1 2 3)
|
|
21 |
727 |
|
|
Odd leakdown test, good compression, advice needed by
devnull
Hello, Helped some relatives find an inexpensive and good car, exhaust
leak sound near the manifold or downpipe. Needed a timing belt. it
smoked like the dickens off idle, and had a nasty clatter near #3. I
figured it needed valve stem seals, maybe lifters, if it needed guides
throw on a $150 used...
|
|
5 |
1,125 |
|
|
PCV valve...? by
Nate Nagel
OK, as some of you probably are aware I have a '55 Studebaker with a '63
Studebaker engine in it. The PCV valve attached to this engine has
ceased to perform as a valve, it's more of a metered orifice at this
point. After several dousings with carb cleaner it still won't "check"
when I blow...
|
|
8 |
480 |
|
|
Trick To Fan?.... by
Peter Griffin
I'm doing the intake manifold gasket set on my 99 GMC 3500/5.8l, and can't
for the life of me get the clutch fan off.......What's the trick...4 pulley
bolts doesn't do the trick.....any input will be appreciated as always....
frank.....
|
April 14th 06 11:37 PM
by Elbert
|
3 |
447 |
|
|
Consequences of a bad engine mount? by
223rem
My 05 Maxima SE (25,000 miles) , when hot, sometimes sounds like a
very rough diesel at idle and row RPMs.
A dealership mechanic finally heard the vibration (I happened to be
near the dealership when the problem re-occured) and said it
could be a bad engine mount. I'm supposed to take the car
in...
|
|
2 |
542 |
|
|
Diagnosing ATF Leak ('93 Infiniti G20) by
bellman
I've noticed my G20 leaves behind a sizable puddle of ATF wherever it
is parked. This has been going on for a few months now. Oddly, I
haven't noticed a significant drop in ATF level on the dipstick. The
power steering fluid is also ok. Looking under the car, there is a
mess of ATF everywhere,...
|
|
2 |
338 |
|
|
head mounted LED torch/ flashlight by
jw 1111
Hi, I wish to buy a LED torch/ flashlight that is mounted on the head so
as to leave both hands free. Could anyone recommend a good one that's not
too
expensive please?
( 1 2 3)
|
April 14th 06 09:21 PM
by A Man
|
24 |
1,257 |
|
|
1990 FORD ECONOLINE 150 VAN Questions! by
gigi
Thanks in advance for taking the time to read my mammoth post.
I bought a Ford 1990 Van about 6 months ago. It only had 80,000 miles
on it, bought it from an old couple who just used it to take trips to
Florida. Anyways, the van runs great, never gave me a problem (besides
the fact that after...
|
|
5 |
482 |
|
|
rough running B2200 by
[email protected]
hey all...new here...
i have a 1987 mamazda2200 that i just can't get to run smooth. the
problem does not happen all the time making it tough to get a
didiagnostic
it lurches at acceleration, then when up to speed, more
missing....everything i can think of to change has been done...plug,
wires,...
|
|
3 |
331 |
|
|
'88 Legend: CV, Ball Joint Boots by
Ryan Biggs
Hello all,
I'm replacing an axle on my '88 Acura Legend. Both outer CV joint
boots were torn, but I believe only the left axle was making noise.
(Noise was mostly in right turns, and it sounded like it was coming
from the left.) I am also noticing that the upper ball joint boots are
both torn, as...
|
|
2 |
603 |
|
|
|
|
1 |
1,293 |
|
|
Best MPG : 5-speed vs. auto? by
SQ
Assuming an identical car, let's say a 4-cyl Honda or a Subaru or
Toyota, which would
get better MPG -- one with automatic tranny or 5-speed?
I understand that 5 speeds vs. 4 gives a better selection of rpms,
meaning at the same speed you can cruise with lower rpms, assuming the
same rear axle...
( 1 2 3 ... Last Page)
|
|
58 |
2,411 |
|
|
rotor replacement on a 1994 F-150 by
bitbucket
i'm going to help my brother replace the calipers, pads, and rotors (and am
thinking about swapping in some steel braided lines) on his '94 F-150. just
the front; i'm leaving the rear drum brakes along.
i'm far from an expert mechanic, but knowing my limitations and knowing when
to ask for help...
|
April 14th 06 04:18 PM
by
|
3 |
443 |
|
|
troubleshooting by
greasemonkey19
i have a 99 mitsubishi eclipse 2.0 dohc non turbo. i have a problem
with just driving the thing. it idles roughly and when u try
accelerating the RPM's go up very slowly and there is a popping sound
coming out the intake. also upon acceleration the car stutters as if it
wants to go but something is...
|
|
2 |
466 |
|
|
Older GTP - How much low end power to expect? by
Aaron407
I have a 95 Grand Prix GTP, but I have only owned it for about a year
and I'm not sure if it's performing as well as it should. I've done
regular oil changes, as well as had the fuel and air filters replaced,
changed the spark plugs, had the catalytic converter changed, and had
the mufflers...
|
|
3 |
560 |
|
|
89 vs. 92 trans compatibilty by
[email protected]
Hi all, just a quick question:
I have an been offered a parts car for free (89 Taurus 3.8L), the
engine and tranny are in good working condition (the vehicle is being
driven daily). By tranny in my 92 Taurus is on its last leg. I'm
curious if the two trannies are interchangable. I am by no...
|
|
2 |
426 |
|
|
URGENT!! Lock in YOUR FREE Position NOW!! by
mhvortex
Dear Friends
Ethos is in pre-launch; launch of this product is in a few days. You
can lock in your
position now....for FREE at:
http://www.4-ecorp.com/mhansen
Here are just a few of the FACTS:
|
April 13th 06 03:51 PM
by *
|
1 |
521 |