Well, Following my last post from a few months back (Hard down shift 3 to 2, 2002 Grand Caravan 3.3 automatic, 90K miles) it finally started slipping in reverse (engine hot only). The dealer is contacting the warranty department at Dodge to get repair approval (warranty ended 10K ago). The dealer...

Hello I pulled the DTC codes from my taurus. I get p0401 (egr insufficient flow) and p0402 (egr excessive flow) Will replacing the valve solve this problem; would a simple cleaning do. thanks for any helpful feedback

Can anybody here recommend some good auto shop software. I've been using Auto Shop Controller from http://autoshopcontroller.com/ but it's buggy and I'm ready to change to something else. Thanks, Steve Smith

i am wondering if there is a reliable way to check the O2 sensor on a 89 pontiac sunbird 2.0 OHC. i have read about a few different ways, but they all say you need a GOOD multimeter. my meter is not that good, it does quite alot and got me though my electronics course in college, but it isnt high...

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8049606327&sspagename=STRK%3AMESE%3AIT http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8049607455&sspagename=STRK%3AMESE%3AIT http://motors.search.ebay.com/_W0QQsassZ66fourdoor

take a what if situation, suppose I lost the oil from the oil pan on my low-slung automobile due to hitting an object in the roadway that punctured the crankcase and all the oil was lost. what "additive" if had been added previously to the oil would have prevented damage within reason from -...

new asian dating links at http://www.out-east.com

I have a Marksman alarm installed in my Car 5 years ago. The Remote Keyless Entry (Remote Transmitter) for the Auto alarm have been working fine until I changed my Car Battery recently. The electronics in the car are working fine, when I flip the Valet switch to ON, the 'LED' is Solid RED. Does...

In article >, "maxpower" > wrote: "Joy Suyehara" > wrote in message ... > Frequently, the gas pedal will stick as I'm driving. I can be cruising > on the...

My right flasher started flashing quickly and I discovered my brake light was out. I've got the replacement bulbs, but I can't figure out how to access them. Thanks Louis

there aren't many features that oil has that haven't been discussed - by the sidewalk superintendents, of which 99% of it is totally from a subjective standpoint. one thing, all this verbiage about "cold starts" / mettle against mettle, where did this stem from? I'm satisfied with oil filters...

'94 Camry, 4 cylinder, 143,000 miles, disk front, drum rear Brake pads are binding on both sides. Yesterday after short drive, left front wheel was extremely hot. Diagnosed as brake pistons sticking in calipers. Planning to replace with remanufactured calipers. Advisable to replace brake flex lines...

My girlfriend has a 1997 ford escort LX, runs fine except for a idling issue that crops up seemingly at random. It'll accellerate fine but suddenly at a stoplight the idle'll start to go up and down in a rythmic pattern. Get to the next stoplight and the issue is gone. And ideas?

Hello, I have a 2002 dodge stratus with cruise. When I press on my brakes, none of the three brake lights work. If I turn on headlights, tail lights light up fine. Turn signals work fine. cruise works fine. hazards also work fine. Just no brake lights. What I have already done.... 1. I first...

Hi all: I have a Ford Ranger 1998 and for the last year, I have been having an intermittent problem starting it. Normaly, the truck would start just fine, but after sitting for a while, it would really hesitate to start. I replaced the battery twice and then I realized that the problem was not...

I used to listen to a guy answering call in questions about autos, motorcycles and airplanes. I think his wife's name was Dixie. His nickname was motormouth? Any one know who I am talking about and if he is still on the air? Thanks

I need to do some exaust work and want to know is it ok to back my car up onto ramps so i can get more clearance to work on the exaust? Or is it a bad/impossible idea?

Google came up dry on these, and I'm afraid I do not have a manual. '97 Honda Accord, 4 cylinder. I need to pull the crankshaft pulley. Is the retaining bolt right or left hand thread? Do I need a puller to remove the pulley? And what torque when I reinstall? Thanks. -- B.B. --I am...

Hi, 2 weeks or so ago, I made a STUPID mistake: I drove my 2005 Toyota Camry with parking brake applied for approx 2 miles. At the time my mind was somewhere else(who knows) and didn't feel anything but a bit of being hold back. I did't realize that the parking brake was NOT released until I got...

Anyone know if this gauge is reliable? It is the Equus oil pressure gauge (electrical) which is not available at Walmart (Canada) like the other cheap mechanical o/p gauge. I want this electrical one and dont want those high ends like StewartWarner...