84 Pontiac - I've been replacing windshield washer pumps for 20 years on this thing. The impellers seem to be the main culprit. Tried both GM and aftermarket brands - they all seem to be consistently short lived. Any recommendatiosn for a brand that seems to last? Or how about a simple 'generic'...

1 Generally speaking: Is it standard practice to replace a plastic tanked radiator or do radiator shops repair these? Say for new cores etc... I'm kinda thinking in terms of old copper or brass radiators and don't know what the standard practices are for modern radiators w/ plastic end tanks. 2...

AMERICA IN DANGER! Secret Gas-Aerosol Rooms operated in US (in Philadelphia, Narberth, Lower Merion, PA) (in Wilmington and Newark, DE) (in Hampton, Williamsburg and Richmond, VA) AND ELSEWHERE.... details below... Bio-aerosols used to hurt and simulate panic attacks + ...! Soviets locked...

Okay so i'm beginning to notice some shimmy in my 00 Pontiac Grand Am and i'm running out of ideas as to what it may be... I figured it was out of balance first since I just had new Avon Tech M550's put on. Took it back in and they rebalanced. Problem still existed. Tried rotating tires to see if...

Hi I have a BMW 3 series and it keeps blowing fuse 37 which is the rear off side light, front offside light and instrument dash lights combined. There was a similar question asked some time back but I cant view the answers. So I could do with some help, I don't want to get nicked for a light...

The car has dual climate control which is nice except for when it stops working properly. I have not had any problems with the heat in the winter but the AC in the summer is a problem. It started as, slightly cool air on the drivers side and cold on the passengers side and worked OK up to about...

('99 Cavalier, replacing gas tank.) To uncouple the fuel line, I have remove a plastic 'quick disconnect' at the filter. Things are kind of rusty, and stuck together. Does the plastic part (the lock?) come off with the line, or does it stay with the filter? TIA, George

***************************************************** http://groups.google.ca/group/electricvehicle ***************************************************** Where can I buy some sollar pannels to put on the roof or on the hood of a car? The car I have right now, is a total junk. It's a gas and it's...

At 90,000km 4 doors sendan engine missiong good wroking condition. No dents. http://japanesejapan.at.infoseek.co.jp/1990%20BMW%20735i%2090k.jpg ------------ Kuroyanagi Shouten Ltd Japan. #510 Castle May, 3-1422 Ueda-Higashi Tenpaku, Nagoya Japan 468-0006

90,000km AT. No dents, engine, missiong good working condition. --------- Kuroyanagi Shouten Ltd Japan. #510 Castle May, 3-1422 Ueda-Higashi Tenpaku, Nagoya Japan 468-0006 fax +81 52 803 1870 tel +81 90-1417-1403 http://members.at.infoseek.co.jp/japanesejapan/index.html

When in traffic, push on the clutch, there is a clunking sound if feathering the clutch. Just replaced the clutch, pressure plate, pilot and throwout bearing, and slave cylinder. Plus the flywheel got resurfaced. Any ideas on the sound source? All the rest of the gears are smooth as can...

I have 90K miles on this Sport Trak. When I step on the brake I get what feels like a good pedal until a few seconds then it eases to the floor about 3/4 of the way. (yes I wrote of this a while back) The problem was not consistent but now after flushing all the fluid it seems its consistent...

I saw this on one of the other websites: Save $30 off your order over $150 at Office Depot http://www.golfer-review.com/deals.php?d=185&t=Save_%2430_off_any_%24150_purchase_from_Office_Depot_in_August%21%20#185 Discount offer excludes technology items. Special offers are limited to one per...

I can start my 1983 chevy cavalier 2.0 good. It idles a bit high but but I can rev up the engine very well. Within 60 seconds the idle drops to normal but I cannot rev the engine at all. If I push in the gas pedal it starts to die. Lifting my foot will keep it running. If I want to rev the...

'99 Cav 4-dr. I have to replace the gas tank. The book says "Remove the heat shield." Most of the fasteners therein are a little hard to make out - they're sort of truss-head things, with a small cavity in cap. They kind of look like rivets, but I'd think they'd say "drill out the f***ing...

Recnetly the check engine light came on and it was brought to a garage to see what the error was the car has close to 100k on it now and the error that came back was; Diagnostic Code: P0161 (Heated Oxygen Sensor Circuit - Bank 2 Sensor 2.) So I've gotten a universal oxygen sensor and I just need to...

and weaker in cold weather or is there and optimal temperature range?

Does anyone know where i can find more information on changing the timing belt(possibly with pictures) on an h22 properly. There are two main things i am concerned about: What is the best way to remove the crankshaft pulley bolt? Once i remove the timing belt, what happens if the crankshaft or...

I just started taking an interest in engines and the BMW cars a day ago, so forgive me if I sound "CAR" illiterate. I want to know the difference between BMW M6 model's 5.0 liter, 40 valve, 500hp, V10 and the BMW Z-4 3.0i model's 3.0 liter, DOHC, inline 6 cylinder engine. How many valves does the...

I'm kind of beating myself senseless for this stupidity but it wasn't entirely my fault. Yesterday morning my car wouldn't start, so after work my friend took me to go get new jumper cables, we ended up having to switch parking spots due to the local of our batteries on our cars. I was...