|
|
03 Explorer - Looking for a new stereo by
Martini
OK, I have a 2003 Explorer EB.
This vehicle has the 6 disk CD w/ Sub, Rear Seat DVD, and the steering wheel
controls.
I'm thinking of upgrading the head unit. I'm looking for a stereo model that
would still interface with the DVD and the steering wheel controls as well
as the sub. I would like it...
|
|
1 |
709 |
|
|
FS: Saleen Ford Explorer XP8 Front Sway Bar by
JLA
Back in October - a Saleen Front and Rear Swaybar package was
purchased from a gentleman parting out his XP8. This fits 1995 -
2001 Ford Explorers and very heavy duty and gives much improved Ride
and Handling.
The rear swaybar was used in an upgrade application but the front was
not due to...
|
April 18th 08 07:01 PM
by JLA
|
0 |
1,821 |
|
|
03 Explorer - Looking for a new stereo by
Martini
OK, I have a 2003 Explorer EB.
This vehicle has the 6 disk CD w/ Sub, Rear Seat DVD, and the steering wheel
controls.
I'm thinking of upgrading the head unit. I'm looking for a stereo model that
would still interface with the DVD and the steering wheel controls as well
as the sub. I would like it...
|
|
0 |
449 |
|
|
Stuck CD by
Jarrod Smith
I realize there is a newsgroup for Ford trucks, but there are hardly ever
any posts there. My father in law has a 2006 F150 he recently bought used.
He just noticed the other week that there is a CD stuck in the stereo. I
tried popping it out using another CD, but didn't have any luck. Any...
|
|
3 |
479 |
|
|
ATF Replacement on a 1994 by
[email protected]
Hello all,
Well, my baby has served me for nearly 2-years and 50,000 miles but
now I believe I may have screwed-the-pooch. My tranny had always been
iffy; it took a good 5-miles of driving in the morning in 2nd-gear
before it'd drop into the higher ones. Well, this weekend, I decided
against...
|
|
2 |
608 |
|
|
|
April 15th 08 01:40 PM
by hillpc
|
4 |
612 |
|
|
Rust on '03 Mountaineer by
D.D. Palmer[_2_]
I noticed today that there is a "rust bubble" of paint on the passenger
side above the rear wheel well. I looked in the wheel well and can see
some rust forming...on both sides. My '03 now has 70,000 miles and is
garage kept, but is in the "rust belt" of Pittsburgh. I would like to
get another...
|
|
5 |
406 |
|
|
1999 4.0 OHV gauge goes to hot and steadys out about midway by
Lance
All,
I have a 1999 Explorer 4.0 OHV. Mileage is around 135,000. Had the heads
replaced around 120,000. Both heads had a fine crack. This was done about
14 months ago.
Fast forward to 3-20-08. While driving the Explorer after it had been
sitting for a few hours and engine was cold, the temp...
|
April 2nd 08 01:37 PM
by Lance
|
2 |
449 |
|
|
97 Explorer - Center console & Speakers by
KYFHO
Couple of questions
1) can someone tell me or direct me to where I can find out what the stock
sizes of the speakers in the non-jbl sound system are.
2) My center console has developed a pretty good shake, how is that unit
secured into the car ?
TIA
|
April 2nd 08 03:51 AM
by KYFHO
|
4 |
677 |
|
|
skid plate by
mab6680[_2_]
i have a 04 xls 4 door 4wd with the 4.0l flex fuel. im looking for a skid
plate any ideas where to get one
--
Message posted using http://www.talkaboutautos.com/group/rec.autos.makers.ford.explorer/
More information at http://www.talkaboutautos.com/faq.html
|
|
1 |
817 |
|
|
ACR Performance Chip by
Esteban
I am almost ashamed to ask this question.....wait, my neighbor just came
over for a visit and wanted me to ask this group if any of you had heard of
the ACR Performance Chip, seems as tho' good ol Bubba was drooling over some
of the many bargans found on eBay and came across an ad from ACR...
|
|
6 |
427 |
|
|
Exhaust Manifold Removal 96 5.0 AWD by
Vito
Been trying to get the left (driver side) manifold out to replace gasket.
I tried following the removal procedure from alldatadiy.com, but can seem to
get the necessary clearance to get the manifold past the steering shaft.
Has anyone else done this procedure and know of some trick that the...
|
March 30th 08 02:54 AM
by Vito
|
1 |
389 |
|
|
|
|
0 |
602 |
|
|
1999 Explorer Transmission by
Allan[_2_]
My wife was driving our '99 Explorer, 4wd SUV to town the other day.
When she got back she said the OD light had come on. I asked if she had
inadvertently pushed the button in, she said no. After shutting off the
vehicle and restarting, the light went out.
I took it for a short drive and...
( 1 2)
|
|
12 |
1,108 |
|
|
97 ford explorer dome lights ? by
Dana[_3_]
Hi,
I have a problem with my dome lights. They just quit coming on when i
use my remote unlock, lift door handle or open any of the doors. They
still work manualy though. I checked the fuses already.
This problem just started since i had it serviced yesterday. The tech
installed a mass airflow...
|
|
3 |
471 |
|
|
2000 Speedo problems by
ken1
Today I changed both front wheel bearings in my 2000 Explorer Eddie Bower and
when I too it for a drive I noticed that I had no speedo all of a sudden. The
Speedo wasm working before I changed the wheel bearigs, does anyone have any
ideas. Thanks en
|
March 23rd 08 04:43 AM
by ken1
|
0 |
374 |
|
|
FREE BLUEBOOK PRICE EBOOK by
Jeff[_42_]
FREE BLUEBOOK PRICE EBOOK
Good information and it's free.
Was updated in January.
http://aofra.com
Jeff
|
|
0 |
603 |
|
|
Service memos by
S/B 954RR
My dealership is claiming that there is a brand new memo that came out
stating that remote starters kill the battery for in 2006-2007 Explorers.
Is there anywhere I can find this information on Ford's website? Is there a
national service hotline? The vehicle ('07 Eddie Bauer) was in two weeks...
( 1 2)
|
|
12 |
978 |
|
|
Check gauge light by
Esteban
Hi folks,
I have a 1998 Mountaineer 5.0, AWD. I recently noticed the Check gauge
light illuminating when I was very low on fuel. Was that a coincidence?
All the other gauges were in their normal limits. I am unable to find
anything in my owners manual about a low fuel warning.
Once again,...
|
|
2 |
655 |
|
|
02 Ford Explorer 4WD won't work by
low66396
My wife's Explorer's 4WD won't work. I tested all the fuses, found
everything in good shape. Tested the motor and it tested bad, so I
replaced the motor and still nothing. Doesn't even sound like it's
trying to engage. I am wondering about the module, but I have no
idea where it is. ...
|
|
2 |
646 |