What might a 93 GT (5-spd) totally stock with a Vortech V-2 SQ S-Trim High-Output system, 3.55s, and shorties run in the 1/4 and trap at? Just curious. Thanks. Brad

After noticing water collecting in one of my headlight units, I removed it and pressurized it using some of the hot air God gave me and I observed air passing through the left and right seams between the lens and housing. The top and bottom seams were noticably better glued than the left and...

How dare all of you who sit at your computers, never knowing Stephen and write this garbage not knowing what this family is going through. How dare you call this young man an idiot. Stephen was my 2nd (adopted) son, he spent everyday at my house with my son and my family. He was full of life and...

does anyone know if ford used tail lights that came on cobras and put them on some mach 1`s? i found a orange 04 with 12000 miles on it, and thnkingof buying it. well the tail lights have the small amber squares in the bottom outside corners. i know these came on cobras but i have never seen them...

oiiiiiiiiiiiiiiiiiii

"Is there anyone here who thinks this new Mustang is anything less than a game winning grand slam, touch down or a slam dunk? " Yeah, ME! The damn thing is way too big and heavy. It would have been better to bill it a a T-Bird or a Lincoln MKIII or something at that size and weight. A pony car...

Request information on how to change a fuel sending unit on a 1966 Mustang. /S/ Jimbo

I want to replace the fuel filter on my 88 GT and was wondering where is the filter located???

Have 89 5.0 with stock rims. Need 225/60/15 tires. Haven't replaced recently and that size is getting a little hard to find. Looking for H rated in 60-90 dollar range. What in group member's experience are decent tires available now. Last ones I got were Michelin Pilots but currently Costco will...

Hi All I am having a problem with my ignition on my 1990 Mustang GT. When I go to start it, I turn the key and the engine fully turns over and starts but then the car immediately dies. I keep trying and the same thing happens. I was finally able to get it to start by revving the engine as it...

Hi, what is price for Shelby GT500 in USA? I saw advertisements on local car dealer here in Finland where GT500 price was 174000 euros !!!! It's like almost 200000 USD. Is so damn expensive to import those new or low mileage cars overseas :-(

Hi On my '89 2dr hatchback there are these metal trim moldings on the outside top of both doors. On mine there used to be some sort of black plastic finish on them. This plastic has deteriorated and I peeled it off on the worst side. What is left looks to be a standard aluminum trim that I...

My rear deck louvers ('80 Mustang) blew off in a windstorm and I saw that they had been attched with thick double sided "sticky tape." The fact that this stuff lasted 27 years is somewhat amazing. I have been unable to find anything like the original. It seemed to be rubber based rather than...

After all these years, there is Mustang number 3 parked in my driveway..... #1 was a 64.5 convertible.... in my youth, it didn't take long for me to trash this poor car.... #2 was an 88 LX coupe with the 5.0... wife was afraid to drive it in the winter so it had to go.... #3 is an 05...

Hi Everyone, My name is Buzz Haze, I used to post here back in the day but my ISP dropped usenet and that was the end of that...I have finally found a way to post on the web so here I am. oh joy...he's back ha-ha!! Actually, I had many friends here and I look forward to catching up.

Hi, Can somebody help me get a CarFAX Vehicle History Report? The VIN# is 1FMEU15H4TLB67037 Thanks, Dan

I've been struggling to install an aftermarket complete dashpad on my 67 Mustang.It seems that the passenger side is shrunk and I can't seem to get the dash panel above the glove compartment back on. Is there a means of stretching the pad such as applying heat from a blower? or are these pads...

Jeremy has a 1969 429 Mustang and I was wondering how many Ford made? Thanks, Logan Editor www.musclecarsociety.com

Regarding fox Mustang body style '87-93, I was hoping somebody would know the answer to this question. What is the clearance from a stock valve cover to the intake of a GT40 vs. a Cobra vs. stock with out using any spacers? If unsure would you happen to know which would give the most clearance...

Hey guys.... Went by Unlimited Performace here in Calgary to look at some parts for my 93 GT. The quotes I got seem high to what I've seen online, but I also know that half of the stuff online isn't complete and you need install kits, etc., to get a true idea of the price. I like Unlimited...