A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Mustang Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Leather Seats by Bob Lewit
Greetings All, I'm looking for front & rear, black leather seats for my 98 V-6 Convertible--any suggestions? Can anyone confirm that seats from a 94-04 convertible will fit just fine? Thanks, BOB
April 4th 05 05:12 AM
by Spleen Merchant Go to last post
3 789
New Reality Show Pinks - WTF? by Jimmy
Anybody see this? A new reality show on TV. Actually looking for people to put their 1/4 mile killers head in the guillotine. Lose the race and you lose title to your car? Yeah, right. No matter what car you have, somebody's always faster. Just like no matter how well you think you can fight, you...
April 4th 05 06:01 AM
by [email protected] Go to last post
4 856
Another rear end I am considering... Thoughts? by Thomas Cameron
CobraJet was kind enough to wave me off of the last one I was looking at for my 1968 Mustang. This one is 31-spline but it is 8.8 inch (not 9 inch which I understand is better) and I do not know how to tell if it is an N case. How can I tell? Does this look like a good rear end for a big block...
April 4th 05 08:15 AM
by .boB Go to last post
2 325
SN65 project by Robert Julian Jr.
SNIP... > Whoa, let me set the record straight. I'm not the guy doing the work, I just > ran across it. While my wife and _most_ friends will attest to me being nuts, I'm not _that_ nuts!! Well... Only time will tell just how nuts you really are. Maybe we will meet one day at bellview. :-) >...
(Multi-page thread 1 2 3 ... Last Page)
April 4th 05 02:58 PM
by [email protected] Go to last post
31 2,986
'05 Mustang, installing aftermarket stereo?? by Mike Villeneuve
I am considering purchasing the new 05 mustang. My question is if it is possible to install an aftermarket stereo in these cars....I ask this because most GM's that i've looked at you cannot install aftermarket audio because it contains some security chip stuff...I do like the 05 Mustang's and if...
April 4th 05 03:45 PM
by Mike Villeneuve Go to last post
5 560
05 Ford Mustang Shaker 1000 and Dead Battery by Rick
Howdy, We just bought our first Mustang (05 GT Premium) and it came with the Shaker 1000 upgrade. We have two issues being worked at the dealer and if you've ran across these issues, please post a reply. 1. The stereo will not stay at a constant volume. We've turned off the "speed volume" but...
(Multi-page thread 1 2)
April 4th 05 04:10 PM
by Rick Go to last post
10 1,136
Ford Lightning not the fastest truck by [email protected]
Go to www.postnewsmarketplace.com, click on autos, then look for article entitled "Viper-powered Dodge Ram SRT-10 fastest". A junky Dodge truck with a Viper V-10, 500 horsepower engine. I guess I will have to supercharge my Mustang. Aghnis
(Multi-page thread 1 2 3 ... Last Page)
April 4th 05 08:41 PM
by Fao, Sean Go to last post
35 2,404
H-pipe w/o cats and Check Engine ! by mustangGT_00
Hey fellows, I was trying to save some $ of buyin aftermarket H-pipe and installin it. So I just went to a mechanic and ask him to take off the 2 back cats and empty the first ones, but later Check Engine light came on. I think it's the O2 sensors! i got the flowmaster mufflers too. Is there any...
(Multi-page thread 1 2)
April 4th 05 11:26 PM
by me Go to last post
12 635
ping nazi fox by hurricane 575 @ihotmail.com
hey when is telus goiing to terminate me lmfao U GO GIRL hurc ast
April 5th 05 03:44 AM
by hurricane 575 @ihotmail.com Go to last post
0 284
67 Overcharging!! by SteveT
I had an issue a year ago that my car was not charging at all. I ended up replacing my front wire harness. Cleaned all my grounds, got nice thick cables to run my ground to the chassis (bare metal) and to the block. I tried to use a common ford regulator and still could not get it working for the...
April 5th 05 06:56 AM
by Wound Up Go to last post
5 521
Rear Main Seal by SandMan
Approximately how long should it take to change the rms on a 1987 5.0L ? I believe the tranny is backed off so it shouldn't take too long .... maybe 2 hours ? Anyone know what the 'Ford Book' says ?
April 5th 05 10:02 AM
by SandMan Go to last post
0 723
GM: Kill Pontiac by Auto Prophet
Hi, I have started a blog devoted to the automotive industry. Please take a look. My latest article is "GM: Kill Pontiac". http://theautoprophet.blogspot.com/
(Multi-page thread 1 2 3 ... Last Page)
April 5th 05 12:26 PM
by C. E. White Go to last post
36 1,879
Rebuild instead of buying by Dave Combs
My ride is a '90 LX 5.0 which I've owned since new. I have been thinking about the '05 GT but then again I only drive ~6,000 miles per year (the LX just went over the 100,000 mark). So why spend almost $30,000 when all I want to do is to keep my LX California emissions compliant yet pick...
April 5th 05 02:05 PM
by [email protected] Go to last post
2 287
Recommended carb by Joe
I have a 1972 Ford Mustang fastback with a 351C-4V Cleveland, 4-speed manual with a Hurst shifter, and an Autolite 4300D 4bbl carb (D2ZF-AA) (I don't know the cfm rating). It currently has stock intake manifold and cam, but I plan to eventually upgrade it performance. I was thinking about either...
April 5th 05 05:19 PM
by Mike R Go to last post
5 548
04 stang dual exh by Pamela Hawkins
Can you put dual exhausts (safely) on an 04 mustang 6 cylinder? No one wants to do it for me.
(Multi-page thread 1 2 3)
April 6th 05 02:00 AM
by Jafo Go to last post
24 1,508
Wire to manual transmission in 1972? by Joe
I have a 1972 Ford Mustang, 351C-4V, 4-Speed manual with a Hurst shifter. There are two wires that connect into the manual transmission - purple and light green. I can't find these wires anywhere in the wiring diagram. Anyone have any idea what these are? The reverse sensing switch is on the...
April 6th 05 03:54 AM
by TM Go to last post
5 843
2001 GT FOR SALE in Northern Illinois (Chicago Area) by Mr. Mustang
2001 Mustang GT 36,000 mi All GT options MACH Sound System Leather 17" Preimum Wheels K&N Tri-Ax Shifter Garage Kept
April 6th 05 04:12 AM
by Mr. Mustang Go to last post
0 655
Big Ford recall - catches fire even with ignition off ! by Burnt
In January Ford issued a recall of 800,000 vehicles. But I just heard from a guy whose car (a 2000 Navigator) caught fire in his driveway a few days ago. He hadn't heard about the recall. That is why I am mentioning it here. If you have a Ford with cruise control, it could catch fire. The...
April 6th 05 06:21 PM
by Burnt Go to last post
0 910
Door won't stay open by Steve Smith
My 1994 Mustang convertible's driver's side door won't stay open. Apparently the door check mechanism is worn out. How do I fix this? Is there a spring that needs to be replaced? Where can I get the necessary replacement part(s)? Thank you, Steve Smith
(Multi-page thread 1 2)
April 6th 05 09:01 PM
by Garth Almgren Go to last post
10 857
Finally saw a new Mustang GT by Big Al
Yesterday I saw my first 05 Mustang GT on the street. This makes about a hundred sixes and one V8. Yes, it was a teenage guy driving:) Al
April 7th 05 03:13 AM
by MadMango Go to last post
7 373
Post New Thread


Display Options
Showing threads 1121 to 1140 of 6222
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 07:55 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.