|
|
1989 Corvette Air Conditioner by
CHUCK
Last year my air worked fine, this year after only using vehicle 2
times the heater air control inside car blinks sometimes then goes back
to normal operation. The problem is the compressor for the air won't
engage. The unit is charged, heater works. Why won't the air compressor
engage? Checked the...
|
March 28th 06 10:24 PM
by CHUCK
|
5 |
364 |
|
|
key stuck in ignition by
CHUCK
1989 Corvette has the key stuck in the ignition. I can start the car
but can't turn off. I had to diconect the ground wire on the battery.
The key will not go to the off position and I can't get the key out of
the ignition. Before I take it to the dealer any coments?
Thanks Chuck
( 1 2)
|
April 8th 06 10:03 PM
by 'Key
|
13 |
1,017 |
|
|
68 corvette motor by
chuck
i have a 1968 corvette 327 motor with a 3-speed manual transmission
4barrel carb i need to know what it is worth
|
December 15th 06 01:26 AM
by eslurf
|
4 |
209 |
|
|
|
October 11th 08 02:38 PM
by GeorgeC
|
9 |
345 |
|
|
New floor jack time. by
Chuck Tribolet
After over thirty years, it looks like my Hein-Werner O'Boy ton and a quarter floor jack is on its last legs.
It's leaking fluid even when it isn't under load, and it looks like there's no source for rebuild kits.
(Yes, I've tightened down the packing nut).
This time around I want to go with more...
|
March 31st 08 03:46 PM
by tomit
|
2 |
568 |
|
|
|
|
5 |
591 |
|
|
Coolant Capacity of '87 'vette by
Chuck Tribolet
What's the coolant capacity of an '87 'vette? I've been all through the factory service manual
and the owner's manual, and I sure can't find it.
Chuck Tribolet
|
|
1 |
300 |
|
|
Antifreeze for '87 'vette by
Chuck Tribolet
The factory service manual for my '87 says use "ethylene glycol coolant. meeting GM
specifications, 1825-M". Plain old Prestone claims to meet that spec. Any horor
stories about using plain old Prestone?
Chuck Tribolet
|
|
1 |
884 |
|
|
Removing the Luggage Shade on an '87 Coupe by
Chuck Tribolet
I need to remove the luggage shade on my '87 couple so I can get to the power antenna
grommet behind it. I found one post that talked about popping it out with a screwdriver, but
I sure can't see how to do that.
Chuck Tribolet
|
|
5 |
288 |
|
|
How to get the alternator pulley nut off? by
Chuck Tribolet
'87 'vette. 28K miles and the alternator gremlin has gotten me.
What the trick to get the alternator pulley nut off?
I put a socket on the nut, and an allen wrench through the hole oin the socket in to the
hex hole in the end of the shaft. Then grabbed the angled part part of the allen...
|
|
5 |
473 |
|
|
Keyless entry for '87. by
Chuck Tribolet
My '87 hatchback has electric door locks, but no keyless entry system.
Has anybody seen an add-on keyless system?
Chuck Tribolet
|
|
2 |
742 |
|
|
1966 corvette grounding problem by
Chuck Williams
I am having problems with the electrical system on my 1966 427 vette. The
car has no power to any portion of the electrical system (including the
ignition switch) even though I have just installed a new battery. I
understand this may be a grounding problem and that there is a diagram
showing the...
|
July 30th 05 10:15 AM
by Lou
|
5 |
318 |
|
|
1971 Corvette--Problems Starting by
Chuckyg
Have a 71 Corvette that has been sitting for about 6 years....Put a decent
amount of stableizer in the tank before it sat. Replaced the coil,
condenser and the points under the cap looked to be o.k.-- Any other
suggestions would be greatly appreciated as to what to look for to get the
car...
|
|
4 |
390 |
|
|
|
|
0 |
200 |
|
|
|
|
0 |
320 |
|
|
Please help by
ck
GET A JOP SLIME
"Ray" > wrote in message
...
> okay here it goes my name is ray and i just lost my job just this month
and i need help and i will not stand on a corner
> to ask for help like the bums. i am been trying to work...
|
August 22nd 06 10:50 AM
by ck
|
0 |
247 |
|
|
Looking for some nice interior shots..... by
Clams Canino
Of the '74 / 75 Vette.
Preferably Silver, but more importantly anything but black.
I'm a little hampered searching with a slow assed dial up - so if anyone
knows of some links I'll go check them out.
-W
|
|
6 |
702 |
|
|
Catalogs by
Clams Canino
I ordered them all online at the same time last Week.
So far in order.
Riks
then
Ecklers
and today
Zip
|
|
1 |
386 |
|
|
Update... by
Clams Canino
On the "underhaul" of my '68 vert. Goal is to *never* have to re-visit the
undercarrage in my personal lifetime.
All research and procurement is finally done. About 3k spent in total.
Another $500 on interior fix up parts.
Car will be *all* new underneath from the transmission tail seal back...
|
|
2 |
652 |
|
|
My living room today. by
Clams Canino
Rear end of "Old Thirsty" ready for final assembly.
http://www.pixentral.com/show.php?picture=1tiRzWsm0UoI0ARQcAEKviWYIMbg
|
|
0 |
674 |