Today while driving slowly the car just died and wouldn't restart. After about 15 minutes it started ok. Drove to my local garage to check. They advise that no fault codes were evident and the car ran well for them. Later on (a few hours later) I drove a few blocks and stopped for a few...

Why is it bad - so I've heard - to start your car (5-spd 5.0) from a stop in second gear? With the stock 2.73s I can still easily start moving in 2nd, and being that 2nd has a top speed of 70mph, I never have to shift on the brutal commute home... It's pretty nice. Should I not do this? Thanks...

If anyone would be kind enuff to send one. Let my daughter use my car and the seat adj fuse blew. She took it upon herself to pull all the fuses which are now sitting in a pile on the floor. Searched the net and couldnt find one. no markings on the cover to help. Drivers seat is so far forward I...

I'm wondering, are these snake oil on an otherwise stock vehicle or do they actually give some extra HP? They look kinda nice but I don't see wasting the money if it's just cosmetics Thanks in advance -- _ 2005 Mustang V6 Convertible (Mineral Grey) |_| ...

HAYNES FORD MUSTANG REPAIR / SHOP MANUAL 1964 1/2 thru 1973 V 8 Covers engines: 260 ,289, 302, 351, 390, 427, 428, and 429 cubic inch. Manual is in good condition with no pages missing or torn. Not greasy. Covers complete teardown and overhaul instructions. 288 pages. illustrated. Published 1979

Anybody interested in V-6 bumper covers. Replaced with GT Dealer take offs. South Georgia Area. Building a Gt350 Replicar. Let me know if interested. Don't have the storage space to keep them.

Is the color dot mark on the tire sidewall have any significance? I thought that the dot was to be lined up with the valve stem so as to better match the rim weight imbalance with the weight imbalance of the tire itself. Asking as I just had new tires installed and the color dot and valve...

I have a 93 ford Mustang and the tach isn't working, the check engine light is on. It's the 2.3 with the eight plugs. Any one have any suggestions on what to look at ? I mean, what usually causes this on this car ? I might add that the head gasket was replaced. When I got the car it was all apart,...

I have an '04GT standard shift, and sometimes it cannot find reverse. I have to press/depress the clutch a couple of times until the shifter can find it. Is this normal with this tranny, or do I have a problem. TIA...Gumby

is there any real benefits to adding a hypertech power module to speed density 86 lx 5-speed or any problems with this upgrade input would be very appreciated

1989 5.0 LX hatchback, AOD, air, power steering/power brakes, non-California Mustang ------------------------------------------------------------------------ Ok, so I've lurked here off and on for several years, even posted a time or two. I'm no mechanic. Don't get me wrong, I do most of my own...

Hey Guys & Gals, I was just curious if anyone can tell me the best way to take out the Washer tank and the pump.. I have a 90 LX 2.4L and the chilton manual is a piece of crap I'm finding out. The guy who I bought the car off of had j-rigged the pump wiring.. I figured I should just take out...

So I just installed a new wiper motor but I hooked something up wrong. In the start position the wipers have to be up all the way and then they come down to the hood. When turned off they go back to the full up position. Any ideas?

Any reason I can't mill away the lip on the 289 crank and use it in a later block. Other than the lip, the crank appears to be dimensionally correct. Thanks.

Is there a place that we can do searches on specialty Stangs (ie Saleen, Roush, etc..) and see the going rate? For example what a 2005 Roush stage 1 with 3k one owner miles on it. Any help appreciated thanks. Nick

CDL: Commercial Driver's License Manual, interactive software with all endorsements, study/exam mode. Amazon: http://www.amazon.com/gp/product/B0009DYMHU/qid=1147924455/sr=8-3/ref=pd_bbs_3/002-6410114-7145669?%5Fencoding=UTF8&v=glance&n=229534

I just bought one and am not sure about installation. I understand it's just 2 wires, but in the specs, it talks about a 1.65L ballast resistor. WTF!?!?! This is going on a '69 with a 351W. Ford didn't use ballast resistors did they? I thought they used the pink resistor wire. I'm not even sure my...

My Capri was relieved of the deck lid louvers a few months ago by a vicious windstorm. I have all the pieces - what is the best adhesive to use? The original looks like super heavy duty, black double sided tape.

"Blue Mesteno" > wrote > Just remember that it eats the tire more quickly to run it underinflated > and > that is decreases fuel efficiency. The problem with this is whether you should use hot or cold tire pressure. Most websites I've been to say to use a "cold tire" to...

Group URL: http://groups.myspace.com/wildheartsmustangcrew Turning heads and corners! A brand new group for grrrls who own a too hot to trot Mustang! But this is only for the ladies who rock the new retro styled 2005-2006 models - the modern revival of the '67-'69 Mustangs. And of course, any...