|
|
R18 Tires Jetta GLI 2004 by
[email protected]
My 2004 Jetta GLI (1.8T) came with Goodyear Eagle F1 225/40Z R18 92Y
tires, which, are really good driving tires but at 30K miles 2 of them
need to be replaced. My quote for 4 tires mounted, balanced, and
aligned is $1000! I don't really want to spend $1000 every 18 months on
tires so if anyone...
|
|
2 |
493 |
|
|
throttle linkage type 4 bus by
ilambert
does anyone know where I can find a good diagram of dual carb linkage for a
72 type 4 bus so I know what parts I dont have? Please email me links or
respond to the NG to any site that may have the diagram I need. Thanks Steve
|
|
0 |
432 |
|
|
|
|
3 |
452 |
|
|
|
|
0 |
241 |
|
|
up-date on "77 servo to '71 Van by
Crusader george
they made changes, I switched the whole front end and the hose going to
the servo was larger, took a little diameter fitting.
and the inlet to the master cyclinder reservoir was moved 90º
better to switch reservoirs.
and it seemed they changed the "regulator" behind the master cyclinder.
again a...
|
|
2 |
369 |
|
|
65 bug with sunroof for sale in toronto by
TheChurchOfTheSilverBall
hi all.
i have to part with my 65 sedan. It's beige with faded paint, surface rust,
bad chrome on the bumpers, crappy interior.
But she runs well and has been a good friend.
Located in Mississauga, Ontario, 20 minutes west of Toronto.
$4000 cdn or best offer.
Next week i'll put it in the auto...
|
|
0 |
221 |
|
|
IL state test by
[email protected]
My 1968 VW bug is suppose to go through a state test...I bought it out
in California. Any advice as to what I should adjust to ensure that it
passes the test?????
Thanks!
|
May 5th 06 05:42 AM
by n5hsr
|
2 |
295 |
|
|
Three cars full of parts by
ThaDriver
My friend has moved out of town & says to sell the three Beetles he left
here. Thre are two supers - one flat window & one curved, & one reg.
Beetle. The reg Beetle is pretty rusty; borderline to restore. All three
cars are *full* of parts both new & used. I need a few parts out of them,
but...
|
|
3 |
308 |
|
|
95 Cabrio flooded! by
[email protected]
I was wondering if anyone could help me with a problem I discovered
when I returned home from vacation last night!!! The passenger's side
of my 95 VW Cabrio was FLOODED. there was a good 4-5 inches of water
on the floor in the front and back on the passenger's side only. The
seats were completely...
|
|
1 |
444 |
|
|
Vw Starters by
Zadamax
All,
Thanks for all the help recently, I have gleaned enuf info to
make my head hurt. (70 bug).
Had to replace my starter today. Found out that the folks
at autozone have just revamped their POS database. Interestingly
enuf, the starters and solenoid are going for 39 bucks.
So, if anyone...
|
|
3 |
374 |
|
|
type 3 to type 1 rear brakes by
george taylor
I have access to a set of type 3 rear brakes. I know that they will fit onto
the rear of a bug, but will I also need the stub axle (I think that is what
it is called)? What else should I grab off of the type 3?
thanks
|
|
1 |
510 |
|
|
62 bug: Need help with distributor identification by
bokuglen
My VW distributor has a strange rotor, and I'm looking for the correct
replacement tune up parts. (It is not the original unit that came with
the car.)
The rotor, instead of being rectangular when looking from above like
the majority of VW rotors, is mostly round, about 3/4" diameter, with...
|
|
0 |
314 |
|
|
Squid - FYI by
Dave Tosi
Hello,
Just an FYI.
Squid started in CA and was a combination of "Squirrelly" "Kid" = Squ-Id,
squid. It was a name for those with fast bikes and slow minds that crashed
a lot.
Remember this is an aircooled VW group.
|
|
1 |
225 |
|
|
subaru 2.2 into 71 bus home made adaptor plate? by
[email protected]
Hello group,
I have a subaru 2.2 engine.. what a nightmare of vacuum lines and
solenoids... I removed the carb, plugged all the vacuum lines..
cast an adaptor to bolt to the intake manifold, put my solex
on it.. It's a very small engine once you get all the crap off it.
Has anyone here ever...
|
|
4 |
682 |
|
|
Lock cylinder replacment by
JJW69Bug
Anyone know a trick for getting a lock cylinder out on a 69 bug. I
followed the haynes manual ( remove steering wheel, blinker assembly
and plate over the cylinder ) then it says insert key and turn it a
little and pull. I don't have a key, if I did I wouldn't be changing
the lock cylinder. I...
|
|
5 |
587 |
|
|
1971 Super Beetle Factory Sunroof by
Bill Goforth
I've gotta '71 Super with a factory sunroof. The "lifters" (whatever
they're really called) that pop it up into the final closed and sealed
position are shot. I understand that the current after-market replacement
systems (cable and all) are of poor quality and not dependable. I'd like to
fix...
|
|
0 |
259 |
|
|
Is this too much to pay for a Engine? by
Noice87
I took my 1971 Autostick Super Beetle in to be worked on and the repair
bill is getting high. the Engine is only firing on 3 Cylinders. He
has a rebuilt Autostick engine for 1500 + exchange for one of mine.
Anyeone know of a cheaper place ot get a rebuilt Autostick engine?
Will be happy when...
|
|
5 |
354 |
|
|
loud engine noise, dead coil, overheating, ... by
klashniv
I recently decided to revived my dad's '66 beetle that has been
hibernating for close to 4 years. Had to get it to drive 160km to my
place where (I hoped) I would slowly restore it.
Anyway, washed carburetor, checked valves, did a bit of timing and
attempted to drive it home. Along the way (about...
|
|
2 |
393 |
|
|
Camber Question by
Mike in Tampa
We (well, my money and the local VW shop) lifted the rear of my '74 Thing by
turning the torsion bars about 2 turns - to the point where we had to notch
out the spring plate.
The problem I'm having now is serious positive camber.
What's the solution? We were thinking maybe bend the trailing arms,...
|
|
1 |
221 |
|
|
ping Jan by
Tim Rogers
check your rocketmail
|
|
1 |
446 |