A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Corvette Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
test by pmhine
this is just a test
August 15th 07 02:59 PM
by pmhine Go to last post
0 289
dash lights by labtech_one
I've ready that the bulbs in the dash, on a C4 can be replaced with 194 bulbs and appropriate bulb holders. good side is the bulbs are cheaper, and easier to get but the down side is the dash is dimmer. has anyone, replaced the bulb holders, and used those high intensity LED replacement 194...
August 15th 07 02:20 PM
by PJ[_4_] Go to last post
4 683
1976 corvette original dealer brochure. by :\
Hey guys:) I have had this since I looked to buy one back in 1976. It has been in a folder and just found it. The poster car of that year was orange and very nice. Has all the specifications,options and so on and lots of pictures. You can email if you are interested in it and I will sell it...
August 14th 07 05:15 AM
by :\ Go to last post
0 385
Interesting problem to try... by Wes[_2_]
Hello everyone, Here is an interesting thing to try. I have a 2007 Corvette with OnStar and Hands-Free Cell Phone using Verizon Family Plan. Try this... Dial 511 (for Road Information in most States) Dial 911 for Emergency From what I have tried it CAN NOT be done.
August 14th 07 05:05 AM
by Butcher[_2_] Go to last post
9 488
Ping : Butcher by Dave in Lake Villa
Howdy. Did you get your overheating problem solved, or lessened ?? I see that Texas is approaching the stage of heat only found in Hell ! In addition to the 1970 BB, i also have a 2006 LS2 with a 160 f. stat installed ; this cooling system is remarkable as when its 98 f. outside , i can still...
(Multi-page thread 1 2)
August 14th 07 04:28 AM
by Butcher[_2_] Go to last post
18 793
double camel back heads by Carl K
I hear the 327 I have came from a 'vette. I hear the heads are 'nice.' I put the thing in a 350 monza, but never got around to finishing that project. How special are the heads anyway? Carl K ps, please reply-all so that my email gets hit, otherwise I may forget to check back here.
(Multi-page thread 1 2)
August 14th 07 04:02 AM
by Eugene Blanchard Go to last post
14 895
Source for lug nuts and washers for ET-!V wheels on 63? by lib
I would like to purchase new hardware for the above 15' X 6.5" set of 4. The rims cleaned-up well but the nuts+washers had some deep rust. The car is nearly finished, w/new Goodyears, and looking good so would like to replace the rusted pieces. Any clues on who I might contact to purchase these...
August 14th 07 01:27 AM
by lib Go to last post
0 451
Thinking of upgrading to C5 by Garry Horoupian
Hey Everyone I currently have a '90 C4 red/black 6-speed and am thinking of upgrading to a C5. Is there a particular year that was better than others in terms of reliability? Are there things I should look out for when looking at C5's? Thanks in advance for any advice Garry
(Multi-page thread 1 2 3 ... Last Page)
August 13th 07 05:21 PM
by Ric Seyler[_2_] Go to last post
59 3,218
C3 Front Sway Bar Bushings by [email protected]
Hello All Rebuilding the front suspension (1977) and noticed that the front sway bar upper bushing (on both sides) is smashed like a pancake. What would cause this, and is there anything I can do about this? Possibly improper installation procedure? By the way, the bushings are rubber. Thank you...
August 12th 07 11:39 PM
by pete Go to last post
1 668
Rear Spindle / Bearing Tools - Used by Koilmaker
I would like to purchase used tools to rebuild my 72 Vette rear spindles. I am looking for al of them - bushing flaring tool, spindle setup tool, etc. Please email me if you have any C3 Corvette specialty tools for sale - used only Thank You
August 11th 07 12:03 PM
by Bob G.[_2_] Go to last post
2 409
Advanced hosting solutions by Bob I
Not a chance in hell ya spamming bunghole!
August 9th 07 02:43 AM
by Bob I Go to last post
0 601
Ignition Switch by [email protected]
I have a 76 that needs the ignition switch changed. I have the wheel off, but can't figure out how to get the next piece off to get access to the key clinder and switch. It looks like a flat plastic cover. Thanks for your help Mike
August 8th 07 08:36 PM
by 'Key Go to last post
9 911
C6 Reaview Mirror by Joe[_76_]
Have a 2006 C6 with the manual rearview mirror. When I exit the car the instrument lights shut off immediately as expected but the reading lights on the mirror remain on for about 15 minutes. There are two buttons under each side of the mirror that are supposed to control the lamps. When is the...
August 8th 07 07:07 PM
by Joe[_76_] Go to last post
4 311
1963 250hp timing specs? by lib
What is the initial timing of the distributor (w/vac. adv. plugged) @ 600 rpm? I have the shop manual and can't find this setting in it. Can anybody relay to me the page this setting is on, if it is in the manual. I've went thru the specs' page and can't find it anywhere. Thanx- lib
August 8th 07 03:07 PM
by Tom in Missouri Go to last post
6 433
2007 Vette Time by Wes[_2_]
Hello, I drove from Nebraska to Indiana this last weekend. I expected the time on the radio to change when I went from Illinois to Indiana (CT to ET). The time did not change. I believe the clock gets its time from the GPS, so why doesn't it change time? Thanks ahead of time,
August 5th 07 06:53 PM
by PJ Go to last post
3 402
Incentives yet on 07's and question Supplier Discount by ScottO
Anyone heard of any incentives on left over 07's? I was at the dealer today and there were 5-6 07's and one 08. Manager said he'd sell any 07 for $500.00 over invoice, whatever that is. Also, I'm eligible for the GM Supplier Discount. Anyone know if they discount as much off the 08's as the do...
August 4th 07 03:45 PM
by Fred C. Dobbs Go to last post
1 326
Engine shutdown by rigger
I have a 95 Vette with 77k on it. I bought it 2 1/2 yrs ago. It had 75k. A couple of months after getting it I was at a stoplight and it stalled. When I restarted it would only turn over and over. I waited 10 minute's or so and it fired up with no problem. This happened a couple of times. Last week...
August 3rd 07 06:37 PM
by PJ[_4_] Go to last post
2 545
clap clap I'm out by RS[_1_]
Selling my 94 Vette. Because I need a year-around car that combines performance and style that the vette gave me + winter security that my 4x4 ranger gave me. But only want 1 car (room + insurance are factors). had listed the vette in paper, response was light due to high asking price. I'm...
August 3rd 07 01:05 AM
by 'Key Go to last post
3 313
Painting 1977 Corvette by Mark French
I have a 1977 Corvette that I am considering repainting. I have a shop that will work with me and help me through the job, as I have repainted cars etc. over the years with good results. I am going to do the prep work and they will paint it. The questions I have a The car has the original...
August 2nd 07 08:40 PM
by Tom n Missouri Go to last post
1 258
1975 Stingray Corvette Convertible... want to sell by [email protected]
I have a 1975 Stingray Conv. that I have to sell. I have no idea what she is worth. I bought her a little over ten years ago. The Stingray is solid but needs tender love. Rebuilt with 28k miles, new interior, brakes. Can someone guide me in a direction. I paid $10K. I will be moving to Key Largo...
(Multi-page thread 1 2)
August 2nd 07 06:43 PM
by Dad[_1_] Go to last post
13 871
Post New Thread


Display Options
Showing threads 961 to 980 of 3896
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 04:36 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.