A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Mustang Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
06 auto trans question by Bill & Gail
Lately I think I have noticed something a little different in the behaviour of the 5 speed auto transmission in my 06 Mustang. (21,000 miles) If I slow down at city speeds for a corner, roundabout or a yield etc. and then apply the gas to accelerate moderately again, the engine rev's as if it...
June 30th 08 03:28 PM
by Bill & Gail Go to last post
2 492
Recommend Cheap Tires for 98 GT? by Dave J
I've had my 98 GT Convertible since it was new, and in that time, I've worn down a lot of Z-rated, low-profile, sticky tires. It was good fun, but now I'm a family man and not as flush with the free cash as I once was, and the Mustang is more of an occasional commute and grocery getter, and I just...
June 29th 08 11:43 PM
by jonezzzman[_2_] Go to last post
3 650
ADVICE NEEDED: Removing Inner Tie Rod Ends - TWO QUESTIONS by EADGBE
I am going to start replacing the worn tie rod ends (inner and outer) and ball joints in my 1996 Mustang GT. I have heard that the inner tie rod ends that originally came with my car are screwed onto the ends of the steering rack and then held in place by a small pin. How do I remove this pin? ...
June 29th 08 06:09 AM
by Jim Warman Go to last post
3 545
96 GT 4.6 Will not Start by Stepford
I have a 1996 Mustang GT 4.6 I went out to run some errands today and it would not start. I just drove it earlier with no problems. It cranks over but will not start (like its out of gas) My mechanic stopped by and took a look at it. He says it might be the fuel pump or maybe a relay, he asked me...
June 28th 08 07:14 AM
by Jim Warman Go to last post
6 666
Bonjour! by Mysoft
Bonjour ! Étang propriétaire d'un Mustang V6 2002, j'aimerais savoir si quelques uns d'entre vous sont francophone sur ce site? Bonne journée à tous!
June 28th 08 02:28 AM
by Dudly Go to last post
1 459
Ford Mustang News by Paul[_25_]
Hello, It is real pleasure for me to invite you to new discussion board which I've found today. It is located at http://fordmustangboard.com Greets Paul
(Multi-page thread 1 2)
June 27th 08 06:49 AM
by WindsorFox[_4_] Go to last post
14 1,450
Seat Belt Alarm by news.cox.net
On: 2002 Blue Mustang Convertible How can I disable it? Thanks
June 27th 08 02:45 AM
by Babidi Bodi Go to last post
5 687
IPOD connection on 2006 Mustang by Dirk[_3_]
Hello All Im a new Mustang owner. My radio is equiped with an auxilliary input for IPOD use. I wondering if there is a non OEM cable available for me to install which doesnt require a lot of work? This is the standard AM FM radio not Shaker.
June 26th 08 11:21 PM
by ChrisB Go to last post
2 623
Sorry The Cobra's Not For Sale by [email protected]
What an odd day. I drive my car back and forth to work everyday. I also drive it occasionally on the weekends. On average it racks up about 250-300 miles a week. But I never notice anyone looking and/or pointing at my car, it's rare I hear anyone tell me "nice car", and even rarer that anyone...
(Multi-page thread 1 2 3)
June 26th 08 04:15 AM
by Andrew Schwartz Go to last post
20 1,148
PETITION TO STOP AL GORE AND LEFT-WING ENVIRONMENTAL WACKOS ! by Dwight D. Eisenhower
http://www.grassfire.org/106/petition.asp?PID=16641789&NID=1 SIGN THE PETITION GUYS- if you want to fight the CARBON TAX that Al Gore wants to put on GASOLINE- if he gets what he wants, gas will be $10/gallon and we can kiss hot rodding goodbye he wants to purposely add taxes to gasoline to make...
(Multi-page thread 1 2 3 ... Last Page)
June 25th 08 12:11 AM
by Michael Johnson Go to last post
53 2,707
supercharger by Shaun
have a 2001 mustang, close to stock k&n CAI, flows super 40 catback, want to supercharge, debating brands, need insight as i am a chev guy , first ford. car is like new, 33000 KM (20000 mile) , barely broke in
June 24th 08 03:48 AM
by GILL[_6_] Go to last post
4 723
QUESTION: Inner Tie Rod Ends On 1996 GT by EADGBE
It is time for me to renew the steering components on my 1996 Mustang GT (over 120,000 miles). I have purchased a set of new TRW inner tie rod ends, and I have rented the proper inner tie rod long socket tool that is needed to remove and install these parts. However, I won't be able to use this...
June 23rd 08 03:51 AM
by Frank ess Go to last post
7 572
2K GT single cylinder misfire mystery by Mark G7#9
I had an OBDII code check and it told me that cylinder#5 has been misfiring. Since I never changed the plugs (after 100K miles), I changed all 8, and the problem went away for a few weeks. Now, the same cylinder is misfiring again. What I also noticed is that when the car is in the garage for...
June 23rd 08 12:52 AM
by ah[_3_] Go to last post
5 504
Mustang Generations Magazine by wposner
Mustang Generations is a new Mustang is a publication dedicated to the capture and exhibition of some the finest vehicles, greatest events, and most innovative products - with emphasis on the people behind them. Our team is comprised of top creative photographers, writers, and editors in the...
June 20th 08 12:05 AM
by wposner Go to last post
0 595
Using auto trans as brake assist? by Bill & Gail
I was recently driving with a relative in their Mustang (6) with an automatic transmission. They were "shifting down" to decelerate for stop signs, curves, normal traffic etc. (Someone told them it saves the brakes) Is this wise? Is it necessary?
June 19th 08 06:40 PM
by Itsfrom Click Go to last post
9 632
Paging Michael Johnson by Big Al[_3_]
Do you have any links to dyno curves for the modded Cobra/Lightning engines? Looking for HP and torque and general "under the curve" specs. Nothing too outrageous, just the guy's that change injectors and do easy mods. Al 9.02 @ 153 MPH OT door car
(Multi-page thread 1 2 3)
June 19th 08 01:34 AM
by GILL[_6_] Go to last post
21 1,557
Shaker Hood Scoop Kit for 2006 V6 Mustang by C. E. White[_1_]
For some reason my Son is determined to install a Shaker Hood Scoop System on his 2006 Mustang V6. I've seen two systems. One from Classis Design Concepts used the OE hood after cutting a hole in the hood for the scoop. The other is from Aeroform and includes a replacement fiberglass hood. I'd...
June 18th 08 07:34 PM
by Spike Go to last post
2 405
Help us save usenet news for Time-Warner customers by Usenet user
Time-Warner corporate is dropping usenet news as of June 23, 2008. Please help by asking them to keep it. The person to call works for the TW president: Barbara Burroughs phone 203-351-2281 email: ** Posted from http://www.teranews.com **
June 17th 08 12:42 AM
by Usenet user Go to last post
0 607
BANKRUPTCY ATTORNEY by PREMA
http://bankruptcylawyer1.blogspot.com http://chapter7bankruptcy1.blogspot.com http://bankruptcyforms.blogspot.com http://circuitcitybankruptcy.blogspot.com http://bankruptcycourt1.blogspot.com
June 14th 08 05:43 PM
by PREMA Go to last post
0 910
caliper piston question by wowzer
I have a 1994 Mustang with a V-6. The brakes get a slight shimmy or pulse every now and again and I was told by the dealer it was a stuck piston in one of the front calipers. I was trying to decide between replacing the front calipers, replacing just the one that is sticking or replacing the...
June 14th 08 11:55 AM
by Michael Johnson Go to last post
7 439
Post New Thread


Display Options
Showing threads 1041 to 1060 of 6222
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:33 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.