|
|
|
|
1 |
533 |
|
|
How to raise rpm when A/C is on? by
Yvan@office
I have '87 BMW 316 carb engine. I bought complete A/C set from a wrecked
car, and am about to fit it in mine (without factory installed A/C).
One of the problems I am facing is how to raise rpm to compensate for
additional load when A/C compressor is on.
My idea is to try to cut vacuum to the...
( 1 2)
|
|
10 |
1,184 |
|
|
1995 Thunderbird "?" by
Ern
Okay here goes, I am just looking for advice, I am trying to help my
roommate with her 1995 2-door Ford T-bird LX. All I know is she needs a
new motor for it . It is 3.8 v6 supercharged automatic car. Where would
I begin looking for this? I've looked online and have priced them at
approx....
|
|
2 |
444 |
|
|
Ultrasonic Cleaning by
[email protected]
I recently obtained a used benchtop heated, ultrasonic cleaning unit. I am
hoping to use it to clean carburetors, bearings and other small misc parts.
One thing I have heard about is "flash rusting" as a result of the reaction
of the cleaning chemicals with the surface of the metal. Have any of you...
|
|
0 |
481 |
|
|
Catalytic converter by
Bill Johnston
Hello,
I have a '78 Buick Regal with a 3.8 l 231cc V6. The catalytic
converter, due to corrosion and to a rather unfortunate recent incident
with a railroad crossing, is in a very badly mangled condition. I am
told it costs $300 to replace. I also vaguely recall hearing that on
old cars like...
|
July 23rd 06 07:18 PM
by
|
1 |
782 |
|
|
1987 Nissan Stanza (oil leak) by
gilmoreguy
Just purchased a 1987 Nissan Stanza, 4 cylinder. It's in amazingly
good condition inside and out. I've only owned the car for a week. On
two occasions I've noticed a small spot of oil on the garage floor
after parking the car for the night. I'm only using the car to get to
and from work which is...
|
|
2 |
414 |
|
|
Painting Help by
1978CJDon
Hi,
I'm looking to give my 78 CJ7 a fresh coat of paint. Since i plan on
replacing the body in the semi-near future, i'm not looking for it to
be a professional job so i'm going to try to tackle it myself. My
question is this... It's currently black with a clear top-coat. Its
seen better days....
|
July 23rd 06 05:19 AM
by ray
|
1 |
536 |
|
|
Noisy window, 1996 Ford Taurus by
mc
The front passenger-side window always sounds as if it's not quite closed;
it's actually a little quieter if I back off 1/8 inch from maximum closed
position.
What should I look for? Not having looked yet, I'm wondering if it's a
misadjustment to the door latch so that the whole door isn't...
|
July 23rd 06 05:05 AM
by mc
|
5 |
372 |
|
|
Is This A Bad Computer Module? by
jim
I went to start up my 1998 Chev Prism LSI and it immediately began
acting wierd. I heard a sound like a relay clicking on/off rapidly plus
the car wouldnt start. I turned off the key then tried starting again
with the same results.
After the fourth time I smelled smoke. I turned off the...
|
July 23rd 06 04:27 AM
by Kevin
|
1 |
406 |
|
|
toyota spacecruiser autogas(lpg) problem by
mechanicalmartin
i have cleaned the carburrettor out on my cruiser as it wasnt running on
petrol very well now i am having the opposite problem, it wont run very
well on gas, it is as if the gas isnt getting through properly anyone have
any ideas
|
|
0 |
351 |
|
|
Vacumn pump adapter by
[email protected]
I need to vacumn my R134a system, and I have a good vacumn pump, but I
can't find an adapter to go from R22 to R234, does anybody make an
adpter for that?
|
|
5 |
730 |
|
|
92 Pontiac Cooling Fan Problem by
[email protected]
Can anyone tell me what switch causes the electric fans to turn on in
front of the radiator on a 92 Pontiac GrandPrix? It's a V6 3.1L engine
and generally runs okay without the fans however, recently I noticed
that when it was running warmer than usual with the air conditioning
on, the electric...
|
|
2 |
260 |
|
|
Bleeding Hydraulic Roller Lifters by
[email protected]
I have a question about the roller lifters in my 96 Mitsubishi 2.4L 4
cyl SOHC engine. I just had the head and valves ground after my timing
belt broke. Due to some bad information I had for timing the camshaft
gear, I bent some of the intake valves during the cylinder head
reinstall process. I...
|
|
2 |
430 |
|
|
High HC emissions by
tutr
I have a 1996 Chev S10 4.3L V6 auto 2wd 104,000miles.
Passes smog test, but HC is at limit. In neutral at 1500rpm there is a
slight roughness. Runs ok, no lights or codes.
How do I fix the HC? Maintanance, oil changes, etc up to date.
|
|
2 |
384 |
|
|
car stalling when shifting to 2nd gear by
[email protected]
so i have a 2000 vw cabrio, manual transmission, and just last week it
started stalling/hesitating whenever i shift up to 2nd gear. the best
way i can describe this is it hesitatates/stalls. kind of like if the
fuel injector's were clogged. but obviously if that was the case it
wouldn't only happen...
|
|
1 |
324 |
|
|
how do i conect my cooling fan to a toggle? by
[email protected]
Ok here is the storie I have an 83 toyota camry and the fan wont
come on, So the first thing i do is connect it directly to the battery
and it worked. So my thing is how do i connect my fan to a toggle
switch so i can manually turn it on and off?
running redhot
Willie_jspec
|
|
8 |
466 |
|
|
Tuning by
Edena
That's a good tuning!
http://gratis.zu5.net
|
July 22nd 06 02:19 AM
by Edena
|
0 |
536 |
|
|
94 honda accord, ignition problem by
[email protected]
Hi,
recently I have encountered the following problem
on my Honda Accord '94.
|Sometimes|, when I try to run the ignition
it cranks, seems to start for half a second (speedometer shows
something)
and then nothing (dies). Also all indicators seems to go off after
that.
|
|
9 |
524 |
|
|
Noise in front by
muster
Hi,
My car is a standard gear '96 Honda Civic.
It has a big noise when going at low speed, especially when going up
hill or making a sharp turn. The source of the sound is under the car,
between front wheels and close to right wheel (probably).
Do you have any clue what the problem could be?...
( 1 2)
|
July 21st 06 07:53 PM
by muster
|
12 |
704 |
|
|
Need Parts????? by
d1racing
::*Need parts?? We probably have them! We have headlights, shocks, Earls
fittings, Holley performance products, K&N filters, True Flow filters,
chrome accessories, Racers tape, Amsoil, Racing parts & accessories.
Will ship ups or usps!!*::
::::
::::
::* Contact us...
|
July 21st 06 05:16 PM
by *
|
2 |
469 |