|
|
to find out operating manual by
[email protected]
i am searching about the operating manual of engine analyzer MOT240
model 1994
i am using this anlyzer since last 8years this is a very use ful and
comprehensive machine
please help me or if you can provide me its detailed operating manual
copy or guide me the address of bosch automotive...
|
|
0 |
375 |
|
|
Which (economically priced) OBDII Scan Tool for occasional usage DIYer by
loadhawg
These things seem to range in price from $30 to $3K! I have no idea
where to begin and am looking for some reasonably priced
recommendations. I figure I might use it once maybe every few years is
all. I've got a 96 BMW currently that needs it. Late 90s GM would be
another app I might likely have....
|
|
2 |
598 |
|
|
1997 Lincoln Town Car: engine surges by
The Derfer
I've got a 1997 Lincoln Town Car, Cartier Series.
I notice that when idling in the Drive Gear, the car sometimes
surges ahead, occasionally with force a bit stronger than
the force with which I've got the brakes holding it back.
And sometimes, the engine dips really low, almost to the
point where...
|
|
2 |
319 |
|
|
|
|
2 |
517 |
|
|
Cressida engine idle/accelerating problem? by
Enil8r[_1_]
Hi there, I posted this message under cressida but think its more useful
posting it here;
I've got an 85 Cressida thats having rough idle problems. Not only
idle, but while accelerating or reving the engine, there seems to be
some hesitation and a vibration from 800 to 2500rpm or more. It is
having...
|
|
0 |
596 |
|
|
Cork Gaskets by
mbjj
I'm replacing the oil pan gasket on my 1.0 L metro and I will be
using a cork gasket. I've had several people tell me not to use
silicone with it and I've had some tell me to go ahead. I also
have a tube of RTV sealant that I had planned on using for a
bead seal with the cork gasket. What will...
|
October 30th 06 12:56 PM
by
|
9 |
582 |
|
|
DO NOT GO TO CARX by
[email protected]
WARNING: DO NOT GO TO CARX CAR X
I took my girlfriend's car to car x for brake service. They quoted me
$120 estimate over the phone.
I figured it might be a little more, maybe in the neighborhood of $200
or so. I know car x is expensive. After waiting for about 15 minutes
the mechanic came and...
( 1 2)
|
|
13 |
2,103 |
|
|
86 Chev 4.3l - Vibration at speed by
Noozer
I noticed someone on here with idle issues on their 4.3l chevy engine so I'm
posting my problem...
86 Chevy G10 van, 4.3l V6, automatic overdrive transmission.
When driving, moreso at higher speed, there is a "resonance" vibration and
it's driving me nuts. It seems to be more related to engine...
|
|
1 |
322 |
|
|
1992 nissan datsun GD21 sale Japan by
[email protected]
1.6(G) MT 170,000km mdel:GD21 fob Japan 245,000.-
-----------------------------
Photos not upped on homepage.
-------------------------------
Kuroyanagi Shouten Ltd Japan.
#510 Castle May, 3-1422 Ueda-Higashi
Tenpaku, Nagoya Japan 468-0006
|
|
0 |
650 |
|
|
Air-intake pump 1997 850 Volvos by
socraticquest
Hello,
My Volvo mechanic found that the Air-intake pump and valve in my 1997
850 Volvo model was broken; which has noticably decreased fuel economy,
and hence 'the check-engine' light ocassionally comes on.
The cost to replace the pump and valve is over $600. Are there (much
less-expensive)...
|
October 29th 06 10:13 PM
by M
|
8 |
716 |
|
|
Saints Unnamed on 11-10-05 by
[email protected]
Saints Unnamed say, "The additives are those things that give to what
you know, additional circumstances and manners of doing things that
nothing else created has the benefits of."
REVELATION DELIVERED THROUGH FRANCES M. KLUG
ON NOVEMBER 10,2005 AT 1:03 P.M.
There are Three around.
"No,...
|
|
4 |
554 |
|
|
92 buick lesabre by
enigmatt
I have a 92 buick lesabre,and it seems that after it runs for like a
half hour to 45 minutes,and has a chance to get warmed up,it wants to
start missing,or seem like it is missing it starts to act as though it
is not getting fuel,but yet it has a new gas tank,new battery,new
alternator,newcatalytic...
|
|
3 |
641 |
|
|
ingination will not turn off grand am by
[email protected]
Used a friends late 1990s model grand am. All was fine as we stopped
for gas minutes from home. Afterwards started the car and drove away,
when I noticed the highbeam indicator on. Tried to turn off but it
wouldn't respond. Then noticed we had no wipers, heat, radio or
anything else. At home...
|
|
2 |
302 |
|
|
98 B4000 A/C Clutch engages in FACE/FLOOR mode by
[email protected]
I kept hearing clicking in the engine bay and realized the (external)
clutch plate engages and disengages but while the positioning knob is
on the FACE/FLOOR position. This is not a position that should engage
the AC at all from what I know (only AC or DEFOG positions should)
|
|
0 |
250 |
|
|
|
|
0 |
315 |
|
|
Sealer for cold mixture heater block by
Art[_5_]
I'm replacing the carburetor on my 89 Toyota and the book I'm using
said not to remove the cold mixture heater block. Well, it came out
anyway and I cleaned it up. So, I'm wondering what kind of sealant I
should use on the upper and lower surfaces and on the gaskets. Any
recommendations? Thanks.
|
October 29th 06 01:06 PM
by N8N
|
9 |
512 |
|
|
Great site by
klara[_1_]
The easiest way to share your images with your friends.
No login required, just one simple step: upload and share.
www.imagehost.ro
|
|
0 |
532 |
|
|
|
|
3 |
465 |
|
|
2000 Mazda 626 timing belt sprocket marks... by
[email protected]
I'm in the middle of replacing the timing belt on my Mazda's 4 cyl.
engine. I've done this plenty of times on other cars, but this is my
first DOHC. I got all the marks lined up and after I pulled the old
belt the cams jerked a bit. No big deal so I pressed on replacing the
water pump and the...
|
|
0 |
407 |
|
|
'89 Maxima No Start by
pPhunk
So I'm working on an '89 Maxima that originally came in with a battery
drain problem. Found that the "main relay" had been grounded
constantly on (and was keeping the ECU powered up constantly), so I
disconnected the jumper-ground and that took care of the battery drain.
Without the relay...
|
October 28th 06 11:09 PM
by pPhunk
|
0 |
250 |