|
|
|
August 20th 05 01:01 AM
by Bryan
|
1 |
410 |
|
|
vert door? by
D&LBusch
Anyone know where I can find a right hand door for my 79 convertible. It
must be rust free ( Yes I know I'm asking a lot here). David
|
|
0 |
234 |
|
|
Front torsion bar removal by
Not sure it is a good idea removing an entire front torsion bar. I have a
beck spyder and removed the four "smaller bars" from the upper torsion
housing because of the weight of the spyder. I did find that I had to use
the adjustment nuts to reset the height i wanted. I also would be
interested...
|
August 19th 05 07:39 PM
by
|
0 |
727 |
|
|
Glad to be back by
Chris Snyder
I used to post here on a fairly regular basis back in 2001, but haven't
been here hardly at all in the past few years, mainly because school
and work got in the way of my project. After contracting out the
rewiring and engine work, I'm finally getting my '77 T1 ready to go,
and have caught the...
|
|
9 |
591 |
|
|
VW looking for opinions. by
Bill Berckman
VW lost $1.29 bilion in North America last year and for some reason
VW's chairman has a problem with that. There is some group of people
that will be traveling around (hopefully in a Toyota) looking for
peoples oponings about what people want in cars. (how about aircooled)
Article is here....
( 1 2 3 ... Last Page)
|
|
67 |
2,026 |
|
|
|
August 19th 05 12:23 AM
by Shag
|
2 |
625 |
|
|
Channel, firewall and crossmember replacement question by
remco
Hi all
Besides my channels, I also need to replace my front firewall. Found that
out when I took the body off the pan recently and started poking around.
Also, half of the rear cross member (that piece welded to the rear firewall,
what the channel is welded to) is rusted out, so will also need to...
|
August 18th 05 05:01 PM
by Remco
|
2 |
443 |
|
|
Wiring diagram by
JohnE
I have a 1960 bug. I have been unable to find an accurate electrical
diagram. All of the diagrams that I have seen for 1960 do not look
like my car. I have a fuse panel with 4 banks and then mounted to the
inside of the left front fender is another fuse block with four banks.
I have found...
|
|
2 |
564 |
|
|
|
|
1 |
467 |
|
|
Headliner install w/ metal sunroof by
Mel P.
I'm in the process of installing the headliner in my 77 Bug which has a
metal sunroof. I have some articles and webpages that describe installing
the headliner on Bugs w/o the sunroof. Is there any tricks or special
procedure for the sunroof opening?
--
Mel
77 Revived Bug & 70 Ghia...
|
August 18th 05 03:27 AM
by Mel P.
|
0 |
594 |
|
|
Decklid Quick-Release Hinge Pins by
[email protected]
Deck Lid - Quick-Release Hinge Pins
Hi!
My Empi brand Decklid Quick-Release Hinge Pins came today from Cip1.
Can someone please give me some simple instructions on how to install
them?
Is it better to install them with the deck lid installed or removed?
|
|
1 |
508 |
|
|
|
|
3 |
590 |
|
|
KonK out under load by
TonyO
Hi, Anyone know what might be going on with my T2... perfect on a short
trip but on a hot day on a motorway for example when the engine is running
hot & the van's under load it will start juddering - and then konk out.
After letting the engine cool - It will get me a few more miles down the
road....
|
|
1 |
452 |
|
|
Bleeding brake lines 66 vw by
Tom Nakashima
Greetings,
what size tubing (ID) is used to bleed the brake lines for 66 vw?
thanks,
-tom
|
|
2 |
554 |
|
|
FS OEM Sport Wheel by
Wolfgang
FS: I have one 4 1/2x 15 4 lug steel x pattern bug sport rim. This was the
spare so still near perfert OEM pain on it - no tire. $15. plus shipping
(suspect about $12). Also have green lighted knob (not switch ) for VW gas
heater $8. Email me off list - remove obvious. wolfgangNOdieterSPAM at...
|
|
0 |
306 |
|
|
Good tires? Looking for tire source by
[email protected]
I was wondering if anyone had purchased those cooper tires from the
real source, I think they are $200 plus S&H. The belts are showing on
my tires and 2 are flat, so it's off the road until I get new ones.
Would kinda like to get them sooner than later. Are these a good deal
or is there some other...
|
|
4 |
778 |
|
|
Hard starting 74 beetle. by
[email protected]
Hi everyone ! When cold the engine starts intantly 99% of the time.
Once warm engine is hard or slow to start much of the time. It seems as
if its flooding. HELP!
|
|
3 |
575 |
|
|
66 Bug Door handles by
Patrick
okay now I'm frustrated. I've been trying to get the door handles out so I
can trouble shoot why the buttons are loose and the key wont lock the doors.
I have went thought my Bentley Manual and the Muir manual and can't find
anything.
Can someone please tell me how to get the darn things out. In...
|
August 15th 05 01:54 AM
by Shag
|
2 |
681 |
|
|
|
August 14th 05 10:29 PM
by Tricky
|
0 |
302 |
|
|
Frame head replacement by
Tony Bennett
Hi
I am having the framehead on an IRS RHD car replaced with a new one from a
beam car.
I appreciate its got to be right so the local VW top man is doing it.
I'd like to save a bit of his time and my money by cutting the holes in
the right for the master cylinder and fitting bolts, since the...
|
|
7 |
458 |