A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
1989 Buick Park Avenue instrument cluster not working by [email protected]
I have a 1989 buick that was stored over the winter. When he found the battery dead my dad hooked up the battery charger to it and kept trying to start it. After charging for about 6 hours without interruption the car started ok. The problem is the instrument panel does not work, so no...
March 24th 10 01:16 AM
by hls Go to last post
2 301
advice - 1993 chevy lumina sedan , headlight dimmer switch not working by [email protected]
Back in march I had some fluid leaking in the steering column and causing little bits of smoke. Dealer said oil from the switch block and a huge price to replace it. I got a local nechanic to replace the switch and all seemed ok. Now I find the headlights will not dim and are stuck on high beam....
September 20th 12 02:41 PM
by Steve W.[_6_] Go to last post
7 416
help with 1993 chevy lumina sedan, trailer wiring , whats needed by [email protected]
Hello, I am in a bit of confusion. I have had a type 1 hitch mounted so I can tow a light trailer for snow thrower or lawn tractor and the mechanic mounting it could not do the wiring. I contacted three parts stores for a wiring kit and was told 1. there isnt one for that car 2. a 4 wire flat...
August 26th 10 01:17 AM
by m6onz5a Go to last post
2 416
cost ? timing chain replacement 1989 buick park avenue 6cyl 3.8 by [email protected]
Hi all, I took my car in today because of the amount of noise it was making , thinking exhaust pipe shot, and was told the muffler was bad AND the timing chain was bad , making lots of noise at idle. Since the cars performance was very poor I am willing to believe that ( mechanic not good...
December 20th 07 11:22 PM
by [email protected] Go to last post
2 298
99 Cavalier by [email protected]
Hi, I am not the best with cars so I am hear to ask questions. My cavalier has a hard time starting. When it starts for a brief moment the engine light will flash on and then i will hear a quick tick tick and then it starts up no problem. Idles fine, doesn't stall. No noises that I can hear. Any...
September 26th 06 02:01 AM
by [email protected] Go to last post
4 340
1995 Toyota Camry Freon leak in aluminum tubing? by Mark[_1_]
1995 Toyota Camry Freon leak in aluminum tubing? I have a 1995 Toyota Camry with a slow freon leak. I can see the oil exiting from the vertical section of the foam rubber insulation that surrounds one of the aluminum freon tubes. It is the tube that runs across the car along the bottom of the...
(Multi-page thread 1 2)
April 25th 08 06:13 AM
by [email protected] Go to last post
14 880
2000 Ford Taurus in tank fuel pump, make access hole in floor? by Mark[_1_]
I have a 2000 Ford Taurus, the in tank fuel pump needs to be replaced. Instead of dropping the tank, I am considering cutting an access hole in the floor as is commonly provided on many cars. Questions.. Anybody try this on this car? Can anyone provide information about the correct location to...
December 31st 17 04:38 PM
by [email protected] Go to last post
8 829
95 Toyota Camry AM2 fuse blew due to suppression capacitor in distributor by Mark[_1_]
Hi guys, 95 Toyota Camy 105,000mi 4 cyl I had no spark, no check engine light. The distributor did turn, the timing belt was good.
September 23rd 07 06:25 PM
by Mark[_1_] Go to last post
0 2,421
How much pressure is in the transmission cooler hoses leading to the radiator by Mark[_1_]
Mark wrote: > I just replaced the radiator on my 95 Camry 4 cyl. I used new hoses > for the upper and lower radiator feeds and 2 new hoses for the > transmission cooler. I had a little trouble with the new transmission > cooler hoses engaging them as far onto the fitting as I would like. > The...
November 3rd 06 03:35 AM
by Mark[_1_] Go to last post
8 739
95 Camry Ignition problem hard to start by Mark[_1_]
Car runs great but difficult to start sometimes when warm.... No codes are set.. I put a 2 channel Oscope on the IGT and coil primary. I can see that when cranking and when the RPM is very low, that the pulses are all there but that the IGT pulse gets very WIDE and this retards the spark timing....
(Multi-page thread 1 2 3 ... Last Page)
March 2nd 11 02:43 AM
by Mark[_1_] Go to last post
39 2,162
Engine swap - 2001 T&C by Mark[_26_]
I have a 2001 Chrysler Town & Country that needs the engine swapped with another I recently picked up... the 'new' motor is used and complete and I was planning on swapping it myself, but I don't have a lift and raising the frame to get the motor in/out so I'll have to pay someone to do it for...
October 15th 07 04:45 PM
by Mark[_26_] Go to last post
0 181
Problems after replacing master cylinder by Mark[_27_]
Hi, I have a lexus es300 with 128K miles. I had taken my car to the mechanic as I felt the brakes needed work. I had to press the brake pedal all the way down to stop the car. The mechanic suggested replacing the master cylinder which I did. Now, I have 2 unique problems and I am looking for...
(Multi-page thread 1 2 3 ... Last Page)
May 7th 10 03:23 PM
by jim beam[_4_] Go to last post
41 1,299
P0135 and now P0420 CEL by Mark[_27_]
I have a '97 Lexus ES300 with 112K miles. I had got a CEL with P0135 code. I replaced the bank 1 sensor 1 O2 sensor with a OEM sensor. Two days later, I get another CEL and now the code is P0420 - catalyst efficiency below threshold. I had the P0420 code about 6 months ago and I had replaced the...
October 7th 08 04:32 PM
by Mark[_27_] Go to last post
2 478
Which Aftermarket Catalytic Converter To Buy for Lexus es300? by Mark[_27_]
I have a 97 Lexus ES300 with 114K miles on it. I have a CEL with P0420 code, catalyst efficiency below threshold. I have replaced the cat twice with aftermarket ones. In both cases, the CEL came back after a couple of months with the same code. So looks like the previous ones were garbage. In...
(Multi-page thread 1 2 3)
October 27th 08 06:31 PM
by [email protected] Go to last post
29 819
Adaptive variable suspension (AVS) in '97 Lexus ES300 by Mark[_27_]
I have a '97 Lexus ES300 with 112K miles on it. I have the adaptive variable suspension (AVS) that allows you to change the dampening of the suspension via a switch located in the center console area (next to the gear shifter). I have been getting a lot of 'thumping' noise when I go over even small...
September 9th 08 05:11 PM
by Mark[_27_] Go to last post
0 409
Check Engine light - code P0420 by Mark[_27_]
I have a '97 Lexus ES300 and got a check engine light 2 days ago. I got it checked and it comes up with a P0420 code. The code description says "Catalyst System Efficiency Below Threshold (Bank 1)". As I understand, it could be due to a defective catalytic converter, damaged O2 ensors,...
(Multi-page thread 1 2 3 ... Last Page)
December 18th 07 09:29 PM
by Mark[_27_] Go to last post
44 1,879
Emissions test failure - no OBDII communication by Mark[_27_]
I have a '97 Lexus ES300 (131K miles). My Connecticut Emissions test failed today due to no OBDII communication. The guy said he couldn't get a reading. He suggested it could be as simple as a blown fuse or as complex as the computer itself. I did some search on google and various forums. It was...
August 8th 18 11:35 PM
by Hank Rogers[_2_] Go to last post
8 1,044
hign Nox emissions, help appreciated by [email protected]
my 94 accord is having problems passing the emissions test. i've had it analyzed and told it's the cat. it was replaced and still failed. have been told the egr is fine and ports aren't clogged. had the combustion chamber cleaned last year after if failed (high nox also, new cat fixed and passed)....
(Multi-page thread 1 2)
March 4th 05 12:26 AM
by [email protected] Go to last post
12 1,130
we learn them, then we wanly comb Valerie and Nell's dirty carpenter by [email protected]
I was lifting plates to clever Samantha, who's pouring under the car's fog. every stale forks solve Paulie, and they locally irritate Estefana too sq5ln6xKul9rs/4uFiNdoqk10YcRDPGLVSia9BNLfg2mIt12TuGcPh9EyFXsBDCz MlUkhQEak812bT== =av9B
January 17th 05 01:12 PM
by [email protected] Go to last post
0 287
Does Armour All cause damage to the dash and other plastic parts ? by [email protected]
About a year ago, I got a 2006 Buick Terazza, 140,000 miles. It was in good shape, but it needed to be cleaned. I Armor-All'ed the dash, and 2 days later there was a 6 inch vertical crack. I bought a 2014 Chrysler 300 yesterday. The salesman told me not to use Armor All as it will crack the...
August 18th 17 03:58 PM
by Percival P. Cassidy[_2_] Go to last post
1 395
Post New Thread


Display Options
Showing threads 10001 to 10020 of 16938
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 12:35 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.