A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Mustang Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
5.0 into 66 coupe...help get it running? by gcroix
Hello all. I have finished putting the 5.0 in my coupe. Everything is hooked up, I have plenty of fuel pressure. Spark is somewhat intermittent. I thought my distributor was 180 out, but that didn't help. Suggestions? Gary in GA
December 27th 06 08:31 AM
by Ironrod Go to last post
1 413
pitman arm by gcroix
Hello all. Anyone have a 65-66 v-8 pitman arm they want to get rid of? No, not free. I'll pay. Gary in NC
December 4th 04 06:16 PM
by gcroix Go to last post
3 878
AOD questions by gcroix
Anyone here an expert on AODs? I'm working a 91 version. I'm replacing the front and rear seals. The rear was tight, but I got the seal in. Trans pan/filter is easy of course. Problem is the front. There is a panel with about 7 bolts on the front of the trans (behind converter) that the...
(Multi-page thread 1 2)
June 7th 05 01:12 AM
by 66 6F HCS Go to last post
15 977
.boB by gcroix[_2_]
Hey, I need an address, I never sent you $ for the part, and I've felt bad about it ever since. Yes, it fit perfectly. Gary
March 7th 07 03:23 PM
by .boB Go to last post
1 350
5.0 EFI HO into 66 coupe by gcroix[_2_]
Hey everyone. Been working on this project for a long time, and I've reached a plateau. Engine will crank all day but not run for more than one second or so. Did KOEO test, getting codes 23 67 81 82 85 87. Engine will crank and catch, idle for about 2.5 seconds tops, but never really what...
(Multi-page thread 1 2)
March 2nd 07 03:58 PM
by gcroix[_2_] Go to last post
10 504
New carb for 66 Mustang 289 by gda
I am thinking of purchasing a 4V Edelbrock carb. However, I am unsure of compatibility with my original equipment Mustang; described below: 1966 Mustang Coupe 289 Engine, 2V carb, electronic ignition (after market) Automatic Transmission Air ConditioningWould appreciate any info on the following...
April 24th 05 08:47 PM
by Spike Go to last post
1 644
Platinum Plugs 66 Mustang by gda
I have heard pros and cons about using platinum plugs in my stock 66 Mustang 289 with A/C and auto trans. Should I just stick with Autolite? Any recommendations? Also, I would be interested in recommendations for replacement spark plug wires for this car. Thanks
(Multi-page thread 1 2)
May 1st 05 12:55 PM
by gcroix Go to last post
12 644
Equal length header - burning my plug wires!!!!! by gdriver
Has anyone experienced an issue with the equal length header burning your plug wires?? I have a 95 GT and have recently installed some equal length headers. The only problem is that one of the plug wires is very close to the header and it is suffering the consequences. I have tried adding a...
(Multi-page thread 1 2)
August 13th 05 12:28 AM
by gdriver Go to last post
17 1,154
2005 Butt-Ugly Mustang by GEB
Anonymous via the Cypherpunks Tonga Remailer wrote: > Ford really helped GM by bringing out this ugly Mustang. The new Pontiac GTO greatly outclasses the retro Mustang. > > One Who Knows > Come back at the end of the year when the year end sales figures are out, and tell us that again! I'd be...
(Multi-page thread 1 2 3 ... Last Page)
November 16th 04 03:21 AM
by WraithCobra Go to last post
42 4,509
2005 Mustang TV Ad by GEB
Fir those who haven't seen the 2005 Mustang ad in the corn field, right click on the link below and select "Save Target As". This video is 2.0 megs. http://avs.epix.net/cornfield.wmv Gary
December 13th 04 09:20 PM
by gqgumshoe Go to last post
9 1,459
ISO Adapter / help connecting a new car stereo to a 1978 Mustang by Geir Eivind Mork
A friend of mine has a 1978 Mustang and i suppose it's way before they introduced a standarized adapter. the back consists of power cords and connectors to each individual speakers. Anyone who have a connection scheme or knowledge of an adapter that fits?
April 11th 05 05:51 PM
by Avanti Go to last post
1 403
96 GT Starting Problems by Gemini
Thanks in advance for any advice on this one. Year ago I picked up a 96 GT (4.6L) so I would have something to tinker with. Heres the situation: When I got the car it ran fine with the only problem a code being set for the canister purge solenoid. Drove the car approx 1000 miles with no...
March 10th 08 01:39 AM
by Gemini Go to last post
0 272
Mustang Intake Manifold by Gene Sawyer
I took my car in for an oil change and I just found out that my 2000 Mustang Gt with 70,000 miles on it has a cracked intake manifold. Research shows that this is a common problem and that Ford has been doing everything that they can to not have a recall. The original one was made of...
April 21st 05 01:42 AM
by Garth Almgren Go to last post
5 748
RIP Ford!!! by Gene Stonerly
Rest in pieces, Ford, you have been good for a while, but now you're dead. In the future, we'll all buys Indian or Chinese cars, so please rest in peace...
March 1st 09 02:35 AM
by Zombywoof Go to last post
6 316
65 emergency brake by Gene Wagenbreth
With my 65 I have to pull very hard on the emergency brake handle to get it to hold very well. If I am parked on a hill so it wants to roll backwards, its worse. I have a 4-speed and leave it in reverse. That usually holds it. With it in gear, if I don't pull hard enough, it will groan and creek...
May 8th 07 01:49 PM
by walt peifer Go to last post
2 549
hydraulic to mechanical brake light switch by Gene Wagenbreth
I have a 64 1/2 . For the umpteenth time the brake lights quit working. The hydraulic switch seems to last less than a year. I read somewhere that it isnt difficult to convert to mechanical switch from a later year. Anyone have a link to the relevant part and whats required ? Does the pedal mount...
January 14th 05 10:07 PM
by Gene Wagenbreth Go to last post
0 429
Transmission Question - "clunk" noise when shifting by Gene[_4_]
We have a 1992 Ford Mustang Convertible with a 2.3L L4 FI OHV engine and an automatic tranny. We love this old car and really hate to sell it. It has always been very dependable and fun to drive. We only drive it with the top down, which is only a day or two each month. We have recently purchased...
April 5th 07 08:13 PM
by Gene[_4_] Go to last post
1 782
1995 mustang runs hot by genius
Hey All, Need some advice again. I have a 1995 mustang gt, 5.0L, ~90k miles that, all of a sudden, runs hot according to the in dash temp gauge. 4 years ago I replaced the ECT and all hoses, belts, coolant and thermostat (180 degree unit). Never had a problem with overheating and it never got to...
(Multi-page thread 1 2)
July 1st 10 07:21 PM
by genius Go to last post
18 796
Driving a Lemon Car? Free Lemon Law Guide! by george
Free Lemon Law Guide on the Net -- lemon law, new jersey lemon law, pennsylvania lemon law, pa lemon law, nj lemon law, massachusetts lemon law, ma lemon law, maryland lemon law, md lemon law, delaware lemon law, de lemon law, ohio lemon law, oh lemon law, washington dc lemon law, dc lemon law,...
December 31st 07 12:43 PM
by george Go to last post
0 761
Free Lemon Law Guide! by george
Driving a Lemon Car? Free Lemon Law Guide! Free Lemon Law Guide on the Net -- lemon law, new jersey lemon law, pennsylvania lemon law, pa lemon law, nj lemon law, massachusetts lemon law, ma lemon law, maryland lemon law, md lemon law, delaware lemon law, de lemon law, ohio lemon law, oh lemon law,...
January 1st 08 02:26 AM
by george Go to last post
0 402
Post New Thread


Display Options
Showing threads 2041 to 2060 of 6222
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:09 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.