A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Chrysler Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
99 Dodge Caravan-problem with very poor lit headlights. by Swatmedic5
I have a 1999 Dodge grand caravan which has very dim headlights. Anyone know how to improve the headlight quality? My other auto is a Nissian Xterra and its headlights are awesome, can see for almost a mile on dim and i cant see the lines with the dodge. Any ideas would be helpful. Thanks in...
(Multi-page thread 1 2)
April 3rd 14 12:50 PM
by [email protected] Go to last post
11 1,043
1997 Plymouth Voyager Stalls by W. eWatson
My Voyager stalls from time to time while driving. It did it today as I was turning on to my street. It fired up easily. It isn't driven much. About once a week down to the grocery story about two miles away. A stall may occur once or twice a year. It hasn't been serviced for several years....
March 29th 14 01:02 AM
by James Rau[_2_] Go to last post
1 455
97 Grand Voyager with annoying electrical problem by danny burstein
Every so often I'd "lose" the dashboard display. This is a well known problem and I could drive ok without it (I just had to be extra careful about my speed and not to run out of gas). And after a day or two it would come back ok. Note that the tach needle would be at something like 1,000 rpm and...
March 24th 14 10:55 AM
by Rob Go to last post
1 349
Is a torque converter available to replace fluid coupling on 1950 Gyromatic by Gene Walker
I have a 1950 Dodge Coronet with the M6 Gyromatic transmission. The car is going to have a substantial restoration and this will be a good time to incorporate any major mechanical changes. If it is feasible I would like to upgrade the transmission from a fluid coupling to a torque converter. Is...
March 11th 14 10:14 PM
by sctvguy1[_2_] Go to last post
1 549
2015 Chrysler 200 looks to put Pentastar's cars back on track by MummyChunk
From AB All-new 2015 Chrysler 200 Engineered with Pride for an Exceptional Driving Experience
(Multi-page thread 1 2)
February 15th 14 03:52 AM
by Rob Go to last post
14 1,122
Dodge Stratus Instrument Cluster Question by greybuck
I have 2003 Dodge Stratus SE. The little "squares" that display around the currently selected gear in the instrument cluster, no longer display for "Drive" or "3." Is it most likely that the LED's are burned out, or can the panel be reset. If I were to obtain a used cluster from a salvage yard,...
January 9th 14 03:39 PM
by Ashton Crusher[_2_] Go to last post
1 367
05 Neon cuts out under heavy acceleration what is the fix? by James[_17_]
Have installed crankshaft & camshaft sensors. No change in performance. What do I do? -- posted from http://www.motorsforum.com/chrysler/05-neon-cuts-out-under-heavy-acceleration-what-is-the-fix-71988-.htm using MotorsForum's Web, RSS and Social Media Interface to rec.autos.makers.chrysler...
January 8th 14 04:43 AM
by Rob Go to last post
1 278
Chrysler recalls small number of 2013-2014 cars and trucks over engine debris by MummyChunk
From ESPN Report Receipt Date: NOV 06, 2013 NHTSA Campaign Number: 13V552000 Component(s): ENGINE
January 4th 14 06:19 PM
by MummyChunk Go to last post
0 355
Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission by MummyChunk
From AB RECALL Subject : Transmission Output Shaft may Fracture Report Receipt Date: DEC 06, 2013 NHTSA Campaign Number: 13V610000
January 2nd 14 07:36 PM
by MummyChunk Go to last post
0 318
glad they caught it now before someone had an issue....... by Rob
Chrysler has issued a voluntary recall for select 2013 models of the Chrysler 300, Dodge Charger, and Ram 1500. According to a statement from the automaker, transmission shafts in some of those vehicles could be prone to breakage: Output shafts installed in some model-year 2013 vehicles were...
December 10th 13 12:15 PM
by Rob Go to last post
0 232
electrikal wiring by [email protected]
On Monday, October 4, 1999 2:00:00 PM UTC+7, news.rwth-aachen.de wrote: > Hi Jeep fans, > > can anybody tell me, where I can get an electrical wiring chart for a 96 > Grand Cherokee. > > Thanxs for your help > > Alex Hemmerich
December 10th 13 05:57 AM
by [email protected] Go to last post
0 296
2002 300M PCV hose not sold separately by Percival P. Cassidy[_2_]
I changed the PCV valve on our car while I had the cross brace out to get at the brake booster, but the PCV valve end of the hose was rather hard, and I'm not sure that it's sealing well to the new PCV valve. The rubber hose is larger at the PCV valve end than at the end that goes to the...
November 2nd 13 01:01 AM
by Percival P. Cassidy[_2_] Go to last post
8 729
Chrysler highlights Mopar lineup for SEMA by MummyChunk
From ESPN Chrysler Group LLC Reveals Mopar-Modified Show Vehicles Ahead of 2013 SEMA Show
October 31st 13 03:52 PM
by MummyChunk Go to last post
0 294
Chrysler reports $464M net income for Q3 by MummyChunk
From AB Chrysler Group Reports Third-Quarter Net Income of $464 Million Modified Operating Profit for the Quarter was $862 Million, From $706 Million a Year Ago Chrysler Group LLC net income for the third quarter of 2013 was $464 million, an increase of 22 percent from $381 million a year ago
October 31st 13 03:52 PM
by MummyChunk Go to last post
0 317
Red locking tabs for electrical connectors by Percival P. Cassidy[_2_]
When I pulled one of those red locking tabs it came all the way out, and when I was trying to push it back in I dropped it and cannot find it. I "borrowed" one from another connector, but I cannot get it in far enough. Is there anywhere to buy those things? Perce
October 30th 13 10:51 PM
by Percival P. Cassidy[_2_] Go to last post
0 396
'00 300m suspension (questions, observations, my experience) by MoPar Man
My 2000 300m has 185k km on it (114k miles) and here's what I've had to deal with regarding suspension issues: - About 2 years ago in January, before I put the snow tires on, I was coming down a slight hill that had a curve and I spun out, with the rear passenger-side wheel hitting the curb hard. ...
October 24th 13 02:50 PM
by MoPar Man Go to last post
0 319
99 Chrysler 300M 3.5L - Cranks, will not start by [email protected]
Ok, I am at a loss. Son called me from a friends house and said car wouldn't start, was running fine when he shut it off, got ready to leave 2 hours later and nothing. Went over to check things out, motor turned over normally, almost started "kinda acted like it is just not getting enough fuel"...
(Multi-page thread 1 2)
October 19th 13 04:17 AM
by Combat Missionary Go to last post
10 664
Headlight cover for 300m - replaceable? by MoPar Man
Looking at the headlight units on the 300m, it looks like the cover should just pop off if you undo some clips on the bottom edge. Instead of messing around with cleaners and polish, is it possible to just buy a new cover? I see many listings on ebay for complete headlight units (typically...
October 15th 13 04:21 AM
by MoPar Man Go to last post
0 321
SWMBO and the noise I can't hear by Percival P. Cassidy[_2_]
'02 300M. ~130K miles. My wife is telling me, insistently and forcefully, that there is a high-pitched sound that is driving her crazy every time I apply the brakes -- and (often but not always) even when I keep my foot on the brake pedal after the car has stopped. I cannot hear it at...
October 13th 13 07:26 PM
by Percival P. Cassidy[_2_] Go to last post
9 494
Chrysler 300m -> do you really need a power-steering fluid cooler? by MoPar Man
I finally found out where my power-steering fluid was leaking from. After taking off the front plastic facia (which was easier to do than I thought), the leak was easy to see. The so-called power-steering fluid cooler is just a 4-ft long piece of aluminum tubing bent into a long U shape and...
(Multi-page thread 1 2)
October 7th 13 10:17 PM
by Nate Nagel[_2_] Go to last post
11 549
Post New Thread


Display Options
Showing threads 81 to 100 of 6936
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:43 AM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 AutoBanter.
The comments are property of their posters.