A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Chrysler Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
1996 Concorde 172K broken strap on fuel tank by GrtArtiste[_2_]
Anything unusual/difficult about repairing this? What would be a fair price if I pay to have it done? Thinking I will be taking it to my local (trusted) NAPA garage. Thanks for any assistance. GrtArtiste
January 31st 12 01:42 AM
by GrtArtiste[_2_] Go to last post
2 491
different clusters on 91 cars by u c coskun
Hello, I was looking at ebay auctions and come across two different clusters for the same car. this is one of...
January 30th 12 05:40 AM
by u c coskun Go to last post
2 462
2.5L voltage regulator by u c coskun
Hello All, I have a question about 2.5L 4cycl engine on 91 Acclaim/spirit. I observe something weird and if possible i want to confirm it with somebody it is normal. When I crank engine, the voltage-meter stays at ~10V(or ~11, this is the cranking low voltage) and it stays at this value for...
January 30th 12 05:37 AM
by u c coskun Go to last post
2 646
removing plugs from aluminum heads by Rob
http://youtu.be/_oUsFFkH1io some good info here I hadn't heard before
January 24th 12 10:28 PM
by Rob Go to last post
2 478
2.4 Headgasket failure by KirkM
I have a 2000 Chrysler Cirrus with a 2.4L engine. It only has 76,000 miles on it. Today, it started running rough. I opened the hood, and the spark plug wire for Cyl #2 was completely off. I started the engine, and the plug wire came off again, and moved up and down with piston movement. The...
January 10th 12 12:43 AM
by u c coskun Go to last post
5 402
2013 Dodge Dart - First Look by Rob
http://youtu.be/wrdxDk_jWkQ
January 9th 12 04:23 AM
by Rob Go to last post
0 371
1993 Voyager stalling. Code 43 with check engine light on by KirkM
My 1993 Voyager with 3.3L engine is stalling upon acceleration. I did the key sequence, and a code 43 has been set. The check engine light is also on. The code has something to do with the dwell being off. Could this be cause by the crank sensor, or a bad coil pack? Thanks, KM
January 9th 12 03:33 AM
by u c coskun Go to last post
2 407
1986 Fifth Avenue-Cold Start-crank 3 times-Start on 4th try by Bob AZ
My 1986 Chrysler Fifth Avenue takes 4 trys to start in the morning. Simply does not start on the first 3 tries. Starts right up on the 4th try. Starts and runs throughtout the day without problems. Then after sitting all night back to the 4 crank mode. New plugs and wires, rebuilt carburetor and...
January 9th 12 03:30 AM
by u c coskun Go to last post
3 485
PT Cruiser NO low beam headlights by [email protected]
After work last night when I got in my PT the low beam headlights wouldn't come on. The highs and the fog lamps all worked as well as the rear lights. My book shows two low beam circuit breakers. Can anyone advise ad to how I should go about diagnosing this? Thanks (dark in here)
December 17th 11 07:31 PM
by [email protected] Go to last post
0 338
Sergio Marchionne on Time front cover by DAS[_2_]
The head of Fiat/Chrysler is on the front page of Time mag. The article recounts that this fusion shows all the signs of working well and Chysler is recovering well so far. Opinions? DAS -- To reply directly replace 'nospam' with 'schmetterling'
December 15th 11 01:49 AM
by Patok[_3_] Go to last post
8 372
Chrysler reopens Detroit plant in preparation for next Viper by Rob
December 13, 2011 - 2:19 pm ET DETROIT -- Chrysler Group said today that it has reopened its shuttered Conner Avenue assembly plant in Detroit to produce the next generation of the SRT Viper sports car starting in late 2012. The plant was idled in July 2010 when Viper production ceased....
December 14th 11 01:26 AM
by Rob Go to last post
0 306
Fiat 500, in another setback, gets 3-star safety rating by Rob
-- December 9, 2011 - 10:19 am ET UPDATED: 12/9/11 2:59 pm ET DETROIT -- The slow-selling 2012 Fiat 500 now has another obstacle in its sales path: It has been tagged by the National Highway Traffic Safety Administration with a three-star safety rating, the lowest of any new model tested so...
December 12th 11 12:44 PM
by DAS[_2_] Go to last post
1 418
Top-line Chrysler 300 is a rebadged Lancia Thema by Rob
November 21, 2011 - 12:01 am ET LOS ANGELES -- The Chrysler brand is moving its 300 flagship sedan upscale with the 300 Luxury Series. Production of the 300C Luxury Series has begun in Brampton, Ontario, and the cars will go on sale in February. The 300 Luxury Series essentially will be a Lancia...
December 2nd 11 12:34 AM
by GP49 Go to last post
2 446
T&C will soon be the only minivan from Chyrsler by QX[_2_]
http://www.foxnews.com/leisure/2011/10/10/dodge-to-kill-its-minivan-in-2013/
November 27th 11 04:33 AM
by Joe Pfeiffer Go to last post
3 474
Eliminating PT Cruiser "smell" by [email protected]
I have an original '01 PT LTD. Unfortunately I had to leave it stored outdoors for over 4 months. Now that its back in service I noticed that some critters may have set up house under the hood. I blew out all the nuts, leaves, etc that I could see, but when driving there is an acrid smell...
November 22nd 11 03:22 AM
by [email protected] Go to last post
2 371
Bought new 2012 Charger by sctvguy1[_2_]
Just got this car last night, Black/Black, 3.6/292HP/8speed auto. This car is off the scale wonderful. It is just like a regular American car, large 120.5 wheel base, rear wheel drive, smooth, and loaded. We got the SE model with the UConnect goodies(this is my wife's car). The Chrysler...
(Multi-page thread 1 2)
November 21st 11 03:46 PM
by sctvguy1[_2_] Go to last post
10 717
Chrysler saving Fiat? Odd, but true by rob
November 14, 2011 - 12:01 am ET TURIN, Italy -- If someone had told me that Chrysler would rescue Fiat within two years of their tie-up, I would have said, "Smettila di bere prima di pranzo" -- stop drinking before lunchtime. What has happened since 2009, when Fiat took control of Chrysler?...
November 14th 11 03:07 PM
by rob Go to last post
0 345
Dual-clutch put on hold at Chrysler by rob
Move follows criticism of Ford's transmission November 14, 2011 - 12:01 am ET DETROIT -- Chrysler Group has delayed introduction of a fuel-saving automatic transmission so it can make the shift patterns more palatable to U.S. drivers -- the latest sign that a key tool in automakers' plans to...
November 14th 11 03:06 PM
by rob Go to last post
0 308
3.8L Bypass hose by Bob Bogar
Does anyone have a method for replacing the thermostat bypass hose behind the water pump on a 2003 T&C 3.8? Choices seem to be cutting out the old one and either bending the the replacement around to stuff it on the 2 pipe ends, or pushing it down the left side pipe, and then pulling it back to the...
November 13th 11 03:25 AM
by u c coskun Go to last post
1 421
91 NY Serpentine slippage fixed! by sctvguy1[_2_]
After reading about the 3.3/3.8 belt slipping off in wet weather, I took my New Yorker Fifth Avenue to the dealer. There was a TSB from 92 that had several parts, including a flanged tensioner and repositioning a bolt. As I understand it, this problem is still going on. After four slippages,...
November 13th 11 03:23 AM
by u c coskun Go to last post
1 348
Post New Thread


Display Options
Showing threads 201 to 220 of 6934
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:58 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2004-2018 AutoBanter.
The comments are property of their posters.