A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto newsgroups
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Technology Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Last Post Reverse Sort Order Replies Views
Have you ever heard this noise in an engine after a VCG repair? by Arthur Wood
Subject: Have you ever heard THIS SOUND inside your engine? URL: http://www.bimmerfest.com/forums/showthread.php?t=1181089 Nobody on Bimmerfest knows what is causing this noise and I can't use the car until I figure out how to figure out what the noise is. This only started after I did some work...
Today 08:10 AM
by Arthur Wood Go to last post
6 7
Is there a database online for the number of shop hours a car repair should take? by Frank S[_2_]
I was told that there is a manual auto repair shops look up to find the number of shop hours they charge for a job. To be fair, I'm told they all charge that many hours even if it doesn't take that many hours. For example if three jobs are done, and even if they associate with each other, they...
(Multi-page thread 1 2 3 ... Last Page)
Today 05:12 AM
by [email protected] Go to last post
40 41
Gas cap. by [email protected]
Lost gas cap key Youtube ...I missplacd mine, found it later. One guy on Youtube tried the same key on three locking gas caps. That key worked all three gas caps.
Yesterday 10:41 PM
by [email protected] Go to last post
0 4
How to Replace a Heater Core in a Dodge Spirit by K Wilson
replying to marc anthony, K Wilson wrote: Heater core -- for full context, visit http://www.motorsforum.com/tech/how-to-replace-a-heater-core-in-a-dodge-spirit-7536-.htm
Yesterday 03:18 AM
by K Wilson Go to last post
0 4
Kumho tires by [email protected]
I bought new about eight years ago for my 1983 Dodge B250 van. I had the van in storage for almost two years. Last week when I drove the van I heard a humming noise. I only drove the van about 2,240 miles since I had the new tires. Would the age of the tires cause the humming noise?
December 11th 17 03:50 AM
by [email protected] Go to last post
6 11
My 1983 Dodge van. by [email protected]
The drivers front door lock and passenger side door locks are electric Power Locks. The key in the drivers side door lock, most of the time it is hard to lock and unlock the door. One of my repair manuals diagrams shows two or three pull/push rods. Can I remove one of those rods so the key will...
December 10th 17 09:38 PM
by [email protected] Go to last post
0 6
Help!, Location of Inertia Fuel cutoff, Jeep Cherokee yr 2000? by [email protected]
Hi guys, and tnx for the help received from this group in the past. I have a friend who's 2000 jeep cherokee was popped in the rear the other day. It never cranked again after the incident so we suspect a inertia fuel cutoff. Could anyone point us to where the cutoff is located? I have...
December 8th 17 02:18 AM
by Heinous Anus Go to last post
4 102
Solved, valve stem seal by Ivan Vegvary[_2_]
My cylinder head must have been remanufactured with fatter valve guides. The guides are 0.01 fatter than the inside diameter of the seals. Having made the measurements the wonderful techs at Fel-pro specified a set that will be a correct fit on the stem but 0.005 too large on the guide. A stop of...
December 8th 17 02:03 AM
by Ivan Vegvary[_2_] Go to last post
0 10
Where to get car rear-deck speakers (haven't bought speakers in decades) by harry newton
I haven't worked on speakers in decades. <http://wetakepic.com/images/2017/12/04/speakers1.jpg> How do we debug a scratchy sound? We can isolate it with the balance to a single speaker. But is it the speaker? Or something else? If it's the speaker, where is a good place (other than the dealer)...
(Multi-page thread 1 2 3 ... Last Page)
December 7th 17 01:05 AM
by Ed Pawlowski Go to last post
36 51
Mazda B2300 steering column by [email protected]
I need to dismantle the upper part of the steering column on my 96 B2300. The part or parts that connect the ignition switch to the key cylinder has broken. I don't know how to get inside the steering column to check/replace parts. Anyone had need to do this, and can advise me?
December 6th 17 05:12 AM
by Steve W.[_6_] Go to last post
1 24
Valve stem seal help by Ivan Vegvary[_2_]
1991 Mazda B2600i Destroyed 4 new seals on the first valve (easiest to get to) These are thin copper (?) shells with a spring loaded runbber ring on top. Can't seem to drive them straight. I've installed thousands of large seals over the last 60 years, but this has me baffled. Using a socket and...
December 4th 17 03:38 AM
by Ivan Vegvary[_2_] Go to last post
2 14
Tesla by [email protected]
delivers the World's biggest battery - and wins a bet. www.wsj.com ...Not exactly car related though. The battery stores electricity from a wind farm and is capable of supplying 30,000 homes.. in Australia.
November 29th 17 01:03 PM
by [email protected] Go to last post
2 27
2.5 ton jack and a 6,900 lb truck by Michael[_23_]
I know that a 2.5 ton jack does not actually equal 6900 lbs, but since it's raising only one end, I'm wondering if it is safe to use it for a vehicle this size. Thanks Mike
November 27th 17 01:53 AM
by Michael[_23_] Go to last post
4 18
Noise Level On Directional & Asymmetric Tires ? (and, relative toNokian WR G3) by Bob[_53_]
Hi, Son and I are both using Nokian WR G3 tires.He has a Subaru Outback. He loves them in the snow and ice conditions, but is always complaining about the noise on a dry road. I have them too, on my 2009 Buick LaCrosse, but they seem pretty quiet to me. But my hearing isn't that great anymore.
November 24th 17 05:57 PM
by Paul in Houston TX[_2_] Go to last post
2 25
Helping neighbor's kids fix sunburned speaker in Toyota Camry by harry newton
Am trying to help a neighbor's kids by replacing the rear-deck speaker covers in a Toyota Camry, <http://wetakepic.com/images/2017/11/19/speakera.jpg> Have you done it? <http://wetakepic.com/images/2017/11/19/speakerb.jpg> It doesn't come out the top or the...
November 19th 17 09:44 PM
by Iggy Go to last post
1 13
Oil by The Real Bev[_5_]
I grew up on 10-30 or 20-40. This is SoCal. No freezing, lots of heat. Synth oil is nice, but expensive. The concept of 0-20 oil, although the manufacturer suggests/demands it, is just alien. We never freeze, we just have to worry about the oil thinning out when the ambient is over...
(Multi-page thread 1 2)
November 19th 17 05:45 PM
by The Real Bev[_5_] Go to last post
10 40
Car dealership rip off. Hidden camera investigation Youtube by [email protected]
cbc.ca ...It is fun to watch that stuff at Marketplace in Canada. Not only about cars, but many other things too.
November 18th 17 03:33 PM
by [email protected] Go to last post
2 18
Questions about choosing the right clutch kit from Marlin Crawler by harry newton
1. What's the practical difference between a 900 & 1200 foot pound pressure plate? (yes, I know, 300 foot pounds). 2. Do you bother replacing non torque to yield pressure plate bolts? 3. Do you change the teeth spacing in your flywheel? I called Marlin Crawler (+1-559-252-7295) today who does not...
(Multi-page thread 1 2 3 ... Last Page)
November 16th 17 07:43 PM
by Tekkie® Go to last post
30 76
2009 Buick LaCrosse Unlocking With Remote problem ? by Bob[_53_]
Hi, Have a 2009 Buick LaCrosse sedan. The Remote won't unlock the doors, or the trunk anymore. Have a new battery in it. Before I bring it in, thought I'd ask here first. What usually goes for this type of problem:
November 13th 17 01:15 PM
by Xeno Go to last post
1 30
What are some car-repair jobs you always wished you could do but have never done? by RS Wood[_2_]
What are some car-repair jobs you always wished you could do but have never done? Mine are, in this order of "I wish I could do it" order 1. painting 2. alignment 3. replace/rebuild engine 4. clutch replacement 5. tire mounting and balancing 6. timing belt
(Multi-page thread 1 2 3 ... Last Page)
November 10th 17 11:09 PM
by Tekkie® Go to last post
528 529
Post New Thread

Display Options
Showing threads 1 to 20 of 16643
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT +1. The time now is 02:14 PM.

Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright ©2004-2017 AutoBanter.
The comments are property of their posters.