we can discuss things on the forums about china cars www.chinacarforums.com

What..is...it? And why does Chrysler make such ugly boxy cars with such garrish and squarish grills? The Caliber is such an ugly chunky thing.. heres the Hornets pics a la BBCs Top Gear: http://www.topgear.com/content/news/stories/515/

Here's the situation. I bought a 1990 Jeep Wagoneer Limited a short while ago. I was in pretty good shape minus a known issue with the automatic transmission. It will not usually automatically down shift into first gear when starting or coming to a stop, but you can manually shift into the...

Has anyone else had their top front strut body mountings rust out? tnx Glenn

Can anyone reccommend a reputable transmission rebuilder in the Chicago area for the A604 tranny? I have heard one good comment about Roadmasters in Schaumburg. Any shops to stay away from?

Will Chrysler sill make the SRT8 available for 2007? Ken -- "Now Phoebe Snow direct can go from thirty-third to Buffalo. From Broadway bright the tubes run right Into the Road of Anthracite" Erie - Lackawanna

Ever notice all the older Neons, minivans, Intrepids and some Fords on the road suffering from opaque lenses? I even spotted an older Mercedes developing the problem. It is unacceptable that we have to constantly buff or replace cloudy, yellow polycarbonate plastic headlight lenses because Chrysler...

I recently took a trip to Louisville which was seven hours away. Going to there, the Cruise Control worked fine, but on the way back when I tried using it abruptly it stopped functioning in the middle of driving. I would like to know what solutions there are for this. I tried pushing the resume...

94 Grand Caravan, 180,000 Km's, 3.3L, rebuilt tranny with OD, newer battery, 2 sets of rims (winter on steel summer on alloy), new winter tires, good summer, newer brakes, rear brake lines, cables and muffler, Quad captain's chairs, grey interior and burgundy/grey exterior, power window's and...

I have found it impossible to get through the telephone and e-mail maze to reach the DaimlerChrysler President's office. Does anyone have the number or experience dealing with a high level executive when you cannot get someone to listen to you? They send nice e-mails saying to call...

If i leave it parked in the sun the temp is always about five degrees more than after a few minutes driving. Bud

same old same old.tranny stuck in 2nd gear.replaced both input and out put sensors changed tranny fluid and filter,same problem.was told it could be the tran control module .i believe it is located on the drivers side fender wall,under the hood and next to the battery.it is about 4in by 2-3in...

So I spent $200 and had the "detailed" inside and out before shipping it to my in-laws. I used to wax and in later years put NuFinish on my cars, but I have to say they never came out like this. It is incredible. Maybe I should keep it. LOL. I have to think that although the car is gorgeous,...

I have a question for the group. I have a 91 Plymouth Acclaim with a 3.0L and about 255,000 miles. It's been a good car but it has developed a problem that is driving me crazy. When you accelerate with the car, at about 38 mph the vehicle starts to shimmy. This continues until about 45 mph at...

Can anyone offer advise on installing a combination switch in a 1999 Concord

I'm replacing the Oxygen sensor in my 1995 3.0 Acclaim. I have read on here that the Bosch unit that everybody sells is not good for my car. None of the Napa dealers near me carry the Echlin unit either. I was wondering if the Denso unit I can order is any good? I'd rather pay 35 for that than...

I AM HAVING TROUBLE KEEPING TIRES ON OUR 2005 CHRYSLER 300. I HAVE HAD IT LESS THAT 1 AND 1/2 YEARS AND ALREADY HAVE PUT ON TWO SETS. AND IT IS NOT BECAUSE OF ABUSE EITHER. THEY ARE JUST WEARING DOWN, EVEN THE DEALER IS PERPLEXED WHY THIS IS HAPPENING, ANYONE HEARD OF SIMILAR PROBLEMS?

Type of car.. 1991 lebaron 3.0 My car is HARD to start (now) before it was running real sluggish.. acting like it wanted to stall out (actually did stall out).. but only while driving it (steady pressure on the gass peddle) when it started to act like it wanted to die out I would give it full...

I want to install some reversing sensor to the above vehicle. Does the rear bumper have a metal frame within the plastic moulding? The reason is I need to thread the sensor wires around and along the inside of the bumper and also drill 20mm holes in the bumper to fix the sensors into it. So at...

Bill Putney has me nervous. The steering wheel is slightly crooked after getting the clunk repaired but I hate to get the car aligned and wheel straightened and risk someone not knowing how to handle the front end of an LH car during an alignment messing up the bushings again . Also, looking...