|
|
Jammed power window by
jeffcoslacker[_7_]
jeffcoslacker Wrote:
> Sounds like you have a tooth or two broken off the regulator...I think
> it's plastic on yours. Easy enough to replace, though...
http://www.speedyautoparts.com/images/products_large/M462904.JPG]
It's not the style I was thinking of, have to replace the whole
assembly, I...
|
|
0 |
619 |
|
|
Jammed power window by
Davealan
I have had a problem with the driver's window in my 1994 Mitsubishi
Galant for the past year. The window stops half way down when either
going down or up. It makes a grinding sound but if I apply some
pressure it will continue going down or when going up if I pull it it
will continue to close...
|
|
0 |
398 |
|
|
"Glowing" ex manifold on a 2.5L S-10 by
[email protected]
It's a 91 2.5L TBI ... the rig became progressively sluggish until it would hardly move. Any throttle movement would stall
the engine. And the exhaust manifold was red hot before I chose not to
drive it!
Towed it home ... checked for a leaking TBI - NO CHANGE. Dropped the
exhaust pipe - NO...
( 1 2 3)
|
|
29 |
1,969 |
|
|
toyota directionals by
mawa
1993 Toyota Corolla (lost manual years ago) Both directionals stopped
working today. Checked the 7.5,15 and 20 fuses and all seem to be
working. Any ideas? Thanks.
|
|
1 |
641 |
|
|
brake rotors keep warping by
[email protected]
Hello. My brake rotors on my civic keep warping. I had my front brake
pads and callipers replaced. About a year later, they warped again,
and the dealer resurfaced teh rotors. It's now about a year later, and
they have warped again. I only drive about 5000 miles per year. What
could be...
( 1 2 3 ... Last Page)
|
July 7th 06 03:45 PM
by *
|
35 |
2,403 |
|
|
EATX Relay Physical Location 91 Voyager by
ron
Does anyone know the physical location of the EATX Relay in the 91
Plymouth Voyager 3.3L? The trans intermitantly goes into limp-in and I
want to try changing this relay before replacing TCM. Thank you for
your help.Ron
|
July 7th 06 03:29 PM
by ron
|
0 |
690 |
|
|
1984 AMC Eagle won't start by
Siege
Okay here's the problem. Initially the starter would not stop cranking
after the ignition off after trying to start. Replaced the ignition
switch, still did it anyway. Replaced wires: ground cables, starter
cable from solenoid, and the solenoid itself. Fixed the starter
problem, we thought. ...
|
July 7th 06 12:52 AM
by Siege
|
2 |
548 |
|
|
727 Torqueflite locking up by
[email protected]
I am very inexperienced with transmissions and hope that someone has an
idea on where to start with a problem we're having with the
transmission in my father's 1965 Coronet. It has the original '65 727
transmission and a 440 engine. The only mods known to the transmission
are a high stall converter...
|
|
3 |
464 |
|
|
Olds Aurora A/C service port location. by
gfulton
Was wondering if anyone knew where the low pressure service port was for the
A/C sys. on a '99 Olds Aurora? Before I start removing wheels and fender
well spash shields. I flat can't find it under the hood, and it's not shown
anywhere in the factory serv. manual or on Alldata that I can find. ...
|
|
0 |
539 |
|
|
Total Jeep Burn Out.................not recommendable by
Hansi
I don't know if this is planed this way, but to me it looks like this
guy is destroying his Jeep. They call it "Total Jeep Burn Out", but it
almost looks like Jeep Burn Up :
http://www.jumpingpixels.com/jeep.html
|
|
2 |
454 |
|
|
|
|
28 |
1,178 |
|
|
1994 Trans Sport 3.8 missfiring by
tp
O.K. I have new info on my problem. I decided to power brake it when
i got home tonight. I just slowly increased the R.P.M.s Sure enough
right at 1600 it started to miss, then went away at 1800. No miss above
or below that range. It sounds like it is just one cylinder, not
multipull misses. ...
|
July 6th 06 03:36 AM
by Kevin
|
1 |
422 |
|
|
Cooling system bubbles, help! by
Metalaid
I have a 2000 Mitsubishi Eclipse GT with a V6 engine.
About a month and a half ago, my radiator cracked at the top so I
changed it for a new one. As I did and started up my car to take it
home, I noticed that the water in the radiator reserve tank was being
sucked into the engine very quickly. The...
( 1 2 3)
|
July 5th 06 10:41 PM
by *
|
25 |
1,684 |
|
|
1994 pontiac trans sport missing by
tp
Sorry, I never said what engine was in the van. Its a 3.8 . The plugs
did look very white when i replaced them. My thoughts are the throdle
position sensor. Maby a little weak spot right in the common cruising
position. Thanks, TP
|
July 5th 06 10:11 PM
by
|
1 |
480 |
|
|
ac cycling on/off at weird intervals by
inetquestion[_1_]
I'm having problem with the ac on my 1998 ford explorer cycling on/off
at weird intervals. My first thought was that it had leaked and was
low, but after buying a gauge it was found to be in the middle range of
"full". Sometimes it will cut on when I first get in the car and may
run for an hour...
|
July 5th 06 10:01 PM
by Kevin
|
4 |
697 |
|
|
Vac Gauge Connection?? by
Harry Face
Looking for a place to connect the vacuum gauge line/hose for manfold
vacuum. Have an Auto Meter Vacuum Gauge for under the dash.
Can't seem to find anything that resembles a rubber vacuum hose for
tapping into, on this engine. 2005 Buick 3800 V6.
Harryface
05 Park Avenue 41,698
|
|
5 |
626 |
|
|
Depreciation by
[email protected]
How much does an automobile depreciate from a mechanic's wear and tear
during a repair job?
Belt buckle scratches due to not using fender covers, soiled tires from
greasy hands, grease on the upholstery / floor mat / doors from greasy
hands. scratched / damage interior molding.
damaged / broken...
( 1 2)
|
|
19 |
830 |
|
|
availability of repair manuals SOMEWHERE at no cost by
Santana5
I went and got replacement seatbelt motors that go up inside the doors, from
a salvage and got a really good deal. Now the problem is I have no clue how
to install them & don't want to pay out the butt now to get them in. If I
had instructions, I know i could pretty much do it myself, but am...
|
|
6 |
781 |
|
|
CFR Engine by
[email protected]
Is there anyway I could get the valve timing diagram for a standard CFR
engine running on gasoline? Will these valve timing values change if a
different fuel is used?
|
|
0 |
368 |
|
|
AMAZING NEW LIQUID FUEL CATALYST!!!!!!!!!! by
Zillionaire
THE BIG OIL COMPANIES DON'T WANT YOU TO KNOW ABOUT THIS:
AMAZING "" Breakthrough Product "" !!!!!!!!!!!!
YOUR GOVERNMENT EPA HAS TESTED THIS!!!!!!!!!!!
EPA CERTIFIED TEST RESULTS!!!!!!!!!!!
|
|
1 |
692 |