|
|
Buick AC Clutch Jingles by
Rodan
(1992 Buick Roadmaster 350CI 170k Miles)
The AC works fine, but a jingling sound comes from the
compressor clutch while it is engaged. When it releases,
it is silent. Can anyone tell me what is occurring and
what I can do now to prevent a failure?
Thanks for any information,
Rodan.
|
July 29th 07 08:38 AM
by Rodan
|
0 |
261 |
|
|
Why Is This The Best Program Online ? by
roberts325
If You Want To Make Money ..This Is What You Do.
I Spent 2 Years Trying To Make Money And Thankfully Now I Am No Longer
Trying ,I Am Actively Doing So.
This Is What It Takes..
http://trakclix.com/ct/t.php?l=353
|
|
0 |
501 |
|
|
car dies,stalls or hesitates when fueling by
Scott Dorsey
Bruce K > wrote:
>Weird problem. To me anyway. Just purchased a 94 Grand Prix 3.1 litre 2
>weeks ago. When I fill up with a tank of gas, whenever the fuel guage is
>over half the car acts like the problems in the subject line. Half of tank
>and under it doesn't do this and runs...
|
|
4 |
324 |
|
|
anyone tried new Kumho's? by
Sammy
Hi,
Need a decent tire without spending too much (don't we all).
Something brough my attention to Kumho so I did a lot of searching on them.
Hard to find an objective opinion. People either love 'em or hate 'em, there
doesn't seem to be any middle ground.
Anyway, I think I'm going to give them...
|
|
2 |
240 |
|
|
EGR Valve Beginner Question by
Ninja[_2_]
I was helping my brother in law with his '94 Saturn (failed smog for "EGR
Function") when we came across this symptom that I don't understand. There
are many things I don't understand, but cutting straight to the chase . . .
When applying vacuum (sucking on the hose to the EGR valve, it holds...
|
|
5 |
347 |
|
|
Transmission Problem? by
Regan
Hello,
I have a '94 GA with a 3.1 L engine. When I am driving on the highway
and my car is in 4th gear all is good. The problem I am experiencing
happens when I have to climb a hill and my car needs that extra umph
to make it up. It shifts down into 3rd gear (normal so far) but never
goes back to...
|
|
2 |
214 |
|
|
Did you own a flood-damaged Katrina car? by
[email protected]
There have been periodic warnings that cars damaged in the hurricanes
that swept through Louisiana and Mississippi might have been retitled
and sold around the country, rather than scrapped. Did you end up
owning one of these flooded cars, either as a buyer or seller? I am an
auto writer for a big...
|
|
0 |
293 |
|
|
|
|
0 |
477 |
|
|
Chevy G2500 Transmission by
Jay
Whenever I drive my van and reach about 45 to 55 miles per hour. It
feels like it looses the gear that its in and the engine revs up and
the van doesn't do anything but slow down. I recently changed the
transmission fluid and filter but that didn't help. I normally shift
to third gear, to get...
|
|
3 |
206 |
|
|
|
July 30th 07 03:00 PM
by qslim
|
2 |
279 |
|
|
parts of a regenerative braking system by
[email protected]
Hi!
I'm planning to modify my motorcycle to turn it into a hybrid bike (an
experiment).
I'm thinking of adding an electric motor mounted on the swing arm
which would then drive the chain and the rear wheel.
Most of the electric vehicles I've read about use brushless motors.
Should it be an AC or...
( 1 2 3)
|
|
29 |
1,236 |
|
|
|
|
2 |
377 |
|
|
Kumho KH16 tire - any good? by
Sammy
Hi,
Anybody out there care to rate the Kuhmo Solus KH16?
I got a price of $75 mounted, balanced etc. out the door price.
Is it a decent tire and is the price right?
Thanks,
|
July 30th 07 09:01 PM
by Sammy
|
2 |
203 |
|
|
CV Joints--Problems / Symptoms by
MAB
Vehicle: 2000 Pont. Grand AM 3.4
Just wanted to ask besides the common "clicking" noise in turns what
other systems would be present if you had bad CV joints?
The reason I'm asking is that the car has been aligned, spin balanced
and 2 new hubs/bearings put in and I'm getting a chugging noise...
|
|
9 |
467 |
|
|
96 Isuzu Rodeo fast idle by
George Brims
Our Rodeo (3.2L V6) idles very fast - about 2200 rpm. We had it worked
on before for this and they replaced the "idle motor" (which is actually
a solenoid and not a motor). That fixed it for a while but then the idle
speed gradually crept up again. It's now at the stage where heads turn
in a...
|
|
0 |
540 |
|
|
TIG Welders by
[email protected]
I am planning to build a tube chassis vehicle and I want to invest in
an AC/DC TIG welding machine.
The thing is, there also is a similar TIG welding machine with a Pulse
feature.
Is this feature necessary?
or do I just buy the AC/DC TIG without the pulse feature?
|
|
7 |
416 |
|
|
Megane stalling at 4000rpm and hard acceleration by
[email protected]
Having just completed a DIY head gasket and timing belt change I took
the car for a spin.
I found it lurched violently when I accelerated hard (foot to the
floor) in 1st gear and also did the same in any gear when it hit
4000rpm. Some of the lurches resulted in a dead stall, which were easy
to...
( 1 2)
|
|
13 |
900 |
|
|
auto tranny fluid check question? by
[email protected]
I have a 2000 pontiac grand am with the 3.4L and auto tranny.
I thought a while ago that people had told me that the engine must
be running to check the fluid level in this tranny.
Checking my Haynes manual it says that the vehicle must be
run to op temp and cycle the shifter through the gears...
( 1 2)
|
|
13 |
603 |
|
|
Standard driver's license terminology? by
LurfysMa
Is there any standard driver's license terminology in all states?
Here in California, the DMV website talks about Class A, B, C, and M
licenses.
Class A & B are commercial licenses, even though it looks like theu
yse the same test. Is this standard language? I checked a few other
states and they...
|
|
6 |
487 |
|
|
|
|
0 |
545 |