|
|
|
June 20th 07 08:24 AM
by Noozer
|
9 |
396 |
|
|
Loud noise from Honda Accord 99 when driving above 40mph by
[email protected]
Can anyone help!!
When i drive my honda accord above 40mph, i begin to hear a loud
humming sort of noise from the front of the car. not sure if its under
the bonnet or to do with the wheel bearings.
Its fine below 40mph. The noise developed after i did some hundred
miles on the motorway last...
|
|
2 |
253 |
|
|
Wiring diagram for Power antenna on '93 Mazda 626 by
Noozer
I need to install a generic power antenna on my 1993 Mazda 626. The original
harness has five wires that went to the old antenna (which is long gone).
Anyone know where I can find a wiring diagram for this?
Wire colors a
- Red
- Blue/Red
- Blue
- Black/Yellow
|
|
2 |
601 |
|
|
Bad PCM? by
Friar Donk
Hi
I have a 95 Regal Custom that has been acting strange. The symptoms
include:
High idle and high rpm when in drive. Shut off/restart car appears
to fix it (for a while, anyway).
Air conditioning/heater/vents turn on and shut off inexplicably.
|
|
0 |
207 |
|
|
WTB: M4MED Carburetor for 1986 Chevy G10 van - 4.3l engine with auto. by
Noozer
I am looking for a high quality replacement carburetor for my 1986 Chevy G10
van. The van has a 4.3l V6 engine with overdrive automatic transmission. The
current carb is a modem M4MED Quadrajet that has been apart too many times
to count and still doesn't work right. I don't have any faith left...
|
|
1 |
351 |
|
|
repeaditely blowing ignition modules inside distributor by
[email protected]
i have a 1986 nissan pulsar, no ECU, just basic E16 engine. I've gone
through 4 ignition modules inside the distributor. once the first one
blew, the next one lasted 5 minutes. I had forgotten to put the di-
electric grease on the back. The next one i put in lasted 3 weeks, up
until yesterday when...
( 1 2)
|
|
17 |
791 |
|
|
O2 Sensor in 1998 Ford Escort by
John Perry
My O2 Sensor is failing in my 1998 Ford Escort. Is this a simple thing to
change? Any tips in changing it?
Any help will be appreciated.
- John
|
|
0 |
267 |
|
|
HELP! Hairline Crack in a Metal Fuel Tank! by
[email protected]
My 94 Toyota Corolla has a one inch hairline crack in the bottom of
the fuel tank that's leaking fuel. The vehicle has 140,000 miles and
is in great shape. The crack is on the bottom, near the center on the
tank. This part of the tank is flat. I used a fuel repair tank
epoxy, after cleaning and...
|
|
9 |
552 |
|
|
|
|
3 |
743 |
|
|
Any market for used oversize Toyota pistons? by
Doc
Having a 7MGE engine in an '89 Cressida overhauled after only 30k
since last overhaul. Am I likely to find any ebay buyers for the first
set of oversized pistons with low miles on them or do you just never
install used pistons?
|
|
2 |
226 |
|
|
Saturn SL1 Handbrake by
[email protected]
Hey everyone... !
I have a 1997 Saturn SL1 and recentley had it serviced where all
breakpads and fluids were replaced.
Today I drove the vehicle for about 15 minutes with the hand brake ON
(I know... stupid!!) and when I realized what had happened, the foor
breakes seemes really REALLY soft. So...
|
|
0 |
408 |
|
|
O2 Sensor in 1998 Ford Escort by
John Perry
My O2 Sensor is failing in my 1998 Ford Escort. Is this a simple thing to
change? Any tips in changing it?
Any help will be appreciated.
- John
|
|
2 |
268 |
|
|
|
|
1 |
244 |
|
|
I need help with OBD freeze frame data by
[email protected]
I recently purchased an OBD-II auto scanner. I understand the basic
obd codes, but there is also this freeze frame data that is completely
beyond me. It is stuff about short and long term fuel trim systems.
What do those percentages mean and how can I use them effectively?
|
|
3 |
372 |
|
|
|
|
2 |
1,075 |
|
|
21HP B&S Engine by
[email protected]
I have a Sears lawn tractor which is 6 yrs old. It came with a 21HP
B&S engine. A few days ago it started to run real rough at idle. If I
add about 50% chock, it run ok, but still at times can misfire.
At a 100% speed, it seems ok and can cut grass and move around ok. I
got this condition a few...
|
|
8 |
539 |
|
|
Engine Miss in Blazer S10 4.3 Vortec by
packard
My 1993 S10 Blazer is running low speed rough idle. I replaced the
rotor and cap, spark plugs (wires are 3 years old), cleaned the EGR
valve and put a new gasket in the EGR valve.
Can anyone give me an idea of what can be causing the problem?
|
|
4 |
1,571 |
|
|
Radial Pull on New Car? by
[email protected]
Have a new Expedition with 900 miles on it. Truck pulls to the right
slightly. Dealer said the alignment was dead on, and it maybe radial
pull. Is this possible on new tires?
|
|
9 |
496 |
|
|
Ford Van no power to start, battery and starter good by
[email protected]
I have a 1997 Ford E150 van and will not start. I have taken the
battery in and they say it's fine. THe starter was bad and I replaced
it, but still I get nothing. The interior lights, horn... nothing
works. There is power at the starter. When I turn the key I get
absolutely nothing. Anyone...
|
|
2 |
358 |
|
|
A thought on fixing a leaking heater core! by
psongman
Hi, I thought I would make this a separate thread from my other one
about a decent 12 volt portable heater. Now, that the in and out hoses
are pieced together in a bypass for the heater core leaking, I was
wondering.....what if later this summer I ran some Barseal (?) or
Stopleak just through the...
|
|
2 |
504 |