|
|
Need Help, Advice, Information - Possible purchase of '65 Mustang by
Willis
Good morning all,
First off, before I even get a single response I want to thank anyone
who gives me some of the advice I need.
Anyways, a guy I work with is selling a 65 Mustang Coupe, and I'm
hoping someone can tell me whether or not it might be worth my time.
This would be my first ever...
|
February 11th 05 04:39 AM
by Mark C.
|
5 |
934 |
|
|
1988 5.0 cruise/horn by
[email protected]
Can anyone help me. I just purchased a 1988 mustang gt conv. It is in
excellent condition, but the horn and cruise don't work. I have no idea
where to start (not the best mechanic). Thanks a bunch!
|
April 14th 06 02:44 AM
by TM
|
2 |
354 |
|
|
P0171 and P0174 by
willie
I have a 2002 Ford Ranger - 4.0 L with 67,000 miles. Keep getting the
codes P0170 and P0174 fuel banks too lean. However, engine does not
run rough at all, and no hard starts. Thought that it may be clogged
fuel injectors, but that was not the problem. Now thinking that it
may be sensors. ...
|
|
3 |
1,451 |
|
|
1991 Mustang GT by
William Everette via CarKB.com
Wife said car(and I verified) that she lost speed control, got a check
engine light, and the transmission doesn't want to respond correctly (ex.
slow to engage when accelerating after having slowed down for an off ramp,
or speeding up to pass).
First engine scan gave the following errors:
KOEO...
( 1 2 3)
|
|
21 |
877 |
|
|
Supercharger on 5.0 "GT" engine by
William
I have the crate GT-40 engine in my '88 notch back coupe along with other
goodies (MAC shorties, BBK cats, aluminum driveshaft, Auburn 3.83, 32
spline axles, 4-wheel disk brakes, etc.). I'd like to know if I should O-
ring the heads prior to installing a (approx) 14LB boost supercharger.
Mr. Bill
|
February 7th 05 07:07 AM
by Mr.Bill
|
4 |
274 |
|
|
8.8 disassembly by
William
If one only needed to change one singe alxe, what would be the
cheapest easiest procedure for swapping them?
My son decided to steal my wifes car, slamming into something and
shattering the rim, rotor, and bending the rim-mounting flange. I have
ordered the correct axle but have never been inside...
|
|
8 |
216 |
|
|
|
|
0 |
7,107 |
|
|
Mustang driver hits 150 mph outside Glenwood Springs,troopers give up chase by
Will Your Prius Do This?
An unknown motorist hurtled west along Interstate 70 outside of
Glenwood Springs early Friday morning, driving a dark-colored,
older-model Mustang so fast that state troopers couldn’t get a
read on its license plate.
The driver was going 140 mph on a stretch of Interstate 70 about
10 miles...
|
|
0 |
7,598 |
|
|
67 rear backspacing for largest tire by
Will
I have heard that 255/60/15s can fit on the back of a 67 coupe, but my
4 1/4" backspace cragers leave the tire sticking out past the fender.
Does anyone know if I can have more backspacing, if so, what is the
most I can have. Also, what would allow me to fit this tire?
|
January 18th 07 10:07 PM
by Spike
|
3 |
694 |
|
|
Got new wheels, now brakes shudder by
Will
HI, I got new wheels for my 67 mustang and I am pretty sure they were
put on with a torq stick to prevent overtightening and therefore
warping of the drums, but still when I stop the brakes and brake pedal
shudder to the point where I am scared to drive. Could this be
something else or does this...
|
|
3 |
517 |
|
|
67 raised rear suspension to fit bigger tires? by
Will
HI, I bought some 255/60 rear tires for my 67 coupe, after recieving
completley incorrect advice about tire fitment, and now they stick
outside of the fender where if I lowered the car off the lift the lip
of the fender would cut into the top of the tire. Could I raise the
rear suspension so the...
|
|
8 |
761 |
|
|
big wheels 67 by
Will
Hi, I'm trying to fit bigger wheels on my mustang, the biggest it can
fit actually, but I can't find out what is good. I've decided on 15''
in the front and the back, and I want to be the back to be a little
bigger than the front. What can I fit, I want 275/60's but I'm pretty
sure that's too much....
|
October 30th 06 11:23 PM
by Will
|
0 |
185 |
|
|
289 Street Beast Build by
Will
Hi, I just got a '67 289 2bbl and I want to build it up to be a
powerfull street racer, I don't intend to race it on the strip so I do
still want it to be streetable (somewhat of a smooth idle, good low end
torque). I have already decided on the eldebrock performer rpm air gap,
try-y headers, and I...
|
October 19th 06 09:50 PM
by Will
|
3 |
279 |
|
|
2001 Mustang - Fuel Pump Options by
Wildatom
Hello!
My 2001 mustang 3.6 fuel pump died. I've looked at the local auto
stores and only one carries such a pump for $190 (comes with straner,
fuel sender and other parts I already have from the old unit). Is there
a pump out there I can just replace the current one with (model number
and place to...
|
February 18th 05 12:03 AM
by Rein
|
3 |
405 |
|
|
ADVERTISE YOUR AUTOS!!! by
[email protected]
Hi, Hope this message is not inappropriate for this forum, but take a
_moment and check out .
http://www.why2buy.com for free classifieds.
That's free exposure for an item you want to sell Not a lot of ads
right now, _but you could change that and posting is free.
Please take a moment to check it...
|
|
1 |
575 |
|
|
ADVERTISE YOUR AUTOS!!! by
[email protected]
Hi, Hope this message is not inappropriate for this forum, but take a
_moment and check out .
http://www.why2buy.com for free classifieds.
That's free exposure for an item you want to sell Not a lot of ads
right now, _but you could change that and posting is free.
Please take a moment to check it...
|
|
0 |
596 |
|
|
Difference between pre 2005 and later? Purchasing advice needed! by
whoeva
this is jsut an assignment which i was told to do, please do not reply
back
Glenn Carlsen wrote:
> Hello all!
> I am considering a 2005+ Mustang vert with a V6 or possibly a hard top GT.
> I can afford either the vert or the GT but not a GT Vert :(
>
> I have been scoping out the dealers and they...
|
June 20th 06 02:23 AM
by whoeva
|
0 |
360 |
|
|
just passing through... by
WhiteCobraSVT
Hello all. Maybe some of you remember me from a couple years ago. My name
was RioRedGTS. Remember it had gotten burned down by a jeep that caught
fire by my car? Then I got the replacement 95 GT and that too was stolen 2
months later. Any of you remember that? Well, then got it fixed and...
|
|
8 |
956 |
|
|
Leaf Spring Selection by
white68fb
Has anyone with a 68 installed leaf springs from Mustangs Plus in the
last year or so? If so, how many leafs did you get and with which eye
position? Also what is the distance from the center of the wheel to
the top of the wheel opening? I can’t think of a good way of choose
without a...
|
|
2 |
633 |
|
|
cleaner by
wf81
Any recommendations on a good chrome cleaner?
I've got 33 yrs. of oxidization. I'm trying to clean the exterior door
chrome molding.
I've tried rubbing compound, goof off, "never dull" (which worked
fantastically on the interior chrome) and a couple off the shelf 3m chrome
cleaners. All cleaned the...
( 1 2)
|
February 26th 06 08:57 AM
by Spike
|
10 |
672 |