Ted Mittelstaedt wrote: > Hi All, > > Just a short post for anyone who has this problem. > > Tonight I repaired the fuel level sender in my 94 T&C AWD. It was not > working at all and showed the tank > always empty. I pulled the tank and pulled out the fuel pump. On the AWD > the sender is on...

Chrysler often advertises a "Value Line" of brake pads, struts, shock absorbers and other assorted parts. Is the "Value Line" any different than the regular part that you would get if you looked up the part number on the parts list for your car? Is it cheaper / better / or just a marketing thing...

Does anyone have any recommendations for pads and rotors for Voyagers? I expect my Voyager's front pads to wear out soon (in fact, I'm surprised they have not already) and thinking about buying ahead, instead of a dash to the local store and getting whatever they have in stock. I have experienced...

Need to replace a ball joint. The FSM says the whole lower control arm assembly must be replaced. Is this true? I thought I could just press a new joint in.

Does the 300C Hemi require premium fuel? Also, where can I find the stats for 0-60, 1/4 and top speed? Thanks

I have been trying for months to figure out what this blue plug is for on my 92 AWD Voyager. It's square and hangs down from behind the fuse panel. It has 6 pins and goes somewhere. It appears previous occupants had removed it from somewhere, but I cannot find where, nor am I able to locate the...

thick wall 350 block- D port heads- timing cover- wire looms- balancer- alternator/ps brackets- ps pump- RAM AIR I-II-III NODULAR IRON CRANK standard uncut- hi perf clutch fan for A/C GTO- nodular iron armasteel connecting rods- 1970-72 455 HO WINDAGE TRAY KIT- much...

Hi, just bought a set of wheels and tires that were mounted on a Studebaker street rod, to use on my '55 Stude coupe. The rears appear to be MoPar police car wheels, about 7-3/4" wide (I assume a nominal 15"x8") and the fronts appear to be Ford 15"x6" my question is this, I thought cop car...

My 97 Lhs with check engine light keeps going on &off at times, Checked codes and came up with 12 battery disconnected recently , 21 which looks to be 02 sensor rich or lean other than that It seems to run perfect with 28 mpg. How do I test sensors or should I just replace them both , one...

"Nomen Nescio" > wrote in message ... > If American corporations have their designs on Third World wages for > American workers, they'll be looking at general strikes as are seen in > parts of Europe. First Delphi....then GM....and...

Mitchell , Alldata 2004, , , BMW, MERCEDES, AUDI, year 2005 - 2003 , total 107 CDs buy, risk-free purchase, working, tested, fully functional, very cheap discounted price, low cost, quality OEM...

I was told by my mechanic that the noise I am hearing is due to a bent flex plate. The noise is terribly loud. Prior to this disagnosis, he had told me the noise was exhaust issue. I paid him $1100.00 to fix that, only to find there was still this aweful noise, he claims it's a different...

I was at a junk yard that had nice 3 1/2 inch dash speakers so I bought them. The shop manual for the '95 Lebaron convertible shows that the wiring is already done for dash speakers, in parallel with the door speakers, and indeed the connector ws there, stuck to the inside hole cover. But when I...

About once a month (more some months, less other months) my ISP's source for newsgroups craps out. I started a thread about this a few months ago (piece the two lines together for complete...

My sister has a problem with the sunroof not closing all the way on her 2000 Cirrus. As I understand it, it doesn't happen everytime she tries to close it. She says that the Chrysler dealer wants around $200. to fix it. Is that a fair price and what causes the problem? Thanks, Ted in Mich.

With my 1995 Concorde, I suffered the transmission failure issue; replaced at 25,000 miles. Now I understand Chrysler has an evaporator issue. My local dealer, however, tells me that was fixed and the incidence of failure on evaporators is "normal." A friend of mine is an independent mechanic...

I know sounds like I'm stupid, but where is the oil filter on my 2005 Crossfire 3.2?

Just purchased a pair of Moog sway bar links and have some questions. I couldn't find a metric or sae wrench that would fit on the hex nut. Also, the nut will only screw on about two turns on the bolt before it starts binding. Upon closer examination, the threaded hole in the nut appears to be...

I HAVE A 1981 CHRYSLER IMPERIAL.WHEN IT STARTS UP AND PUT IN GEAR IT DRIVES OFF NORMALLY. AFTER STOPPING AND PROCEED TO GO THE TRANSMISSON ACT LIKE IT IS SLIPPING AND IT VIBRATES AND MAKE A GROWLING SOUND. AFTER DRIVING A FEW MINUTES ALL SEEM TO WORK WELL. CAN YOU HELP ME? THANKS IN ADVANCE

A little late but I originally posted about 3M making a film to protect headlights from UV damage. Can be used before and after polishing the headlights. 3M sells it to distributors, and it looks like the distributors sell it under there own brand names. Here is the 3M site for the product, and you...