A Cars forum. AutoBanter

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Go Back   Home » AutoBanter forum » Auto makers
Site Map Home Register Authors List Search Today's Posts Mark Forums Read Web Partners

Post New Thread
Threads in Forum : Ford Mustang Forum Tools Search this Forum Feed Icon
  Thread / Thread Starter Reverse Sort Order Last Post Replies Views
Convertible care by 66 6F HCS
"William Claude Dukenfield" <William Claude > wrote in message ... > Question to all the experts: > > What's best to use on the assorted "rubber" seals on the 2005 conv.? > (window tops, front seal, etc.) > > Armorall used to be the...
June 1st 05 12:01 AM
by 66 6F HCS Go to last post
0 966
1966 mustang charging problems by 66bluefb
My alternator was still working but the bearings were going out and making noises so I got another new one. I install it and now the car won`t charge.I took the alternator back to the parts store and they checked it and it was charging. So I buy a new voltage regulator and put it on with the new...
December 12th 05 03:23 AM
by kenG2 Go to last post
8 577
PROTOTYPE 1967 PONTIAC 400 HEADS-CAST#061-EBAY-ONE CENT ! by 66fourdoor
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=8029510871&sspagename=STRK%3AMESE%3AIT rare one-year only "spherized wedge" cast iron Pontiac D-port heads, casting #061 will fit 350-389-400-421-428-455 Pontiac engines low mileage untouched castings- never had a valve job or...
January 13th 06 01:07 PM
by 66fourdoor Go to last post
0 337
1949 OLDS 303 ENGINE/HYDRAMATIC TRANS-EBAY-ONE CENT ! by 66fourdoor
http://search.ebay.com/_W0QQfgtpZ1QQfrppZ25QQsassZ66fourdoor
November 20th 05 02:52 PM
by 66fourdoor Go to last post
0 292
large lot of Pontiac & Ford musclecar parts-Ebay by 66fourdoor
http://search.ebay.com/_W0QQfgtpZ1QQfrppZ25QQsassZ66fourdoor
October 25th 05 12:02 PM
by 66fourdoor Go to last post
0 247
more 1961 Ford Thunderbird parts-ebay by 66fourdoor
starting tonite at 9:45 EST PM http://search.ebay.com/_W0QQfgtpZ1QQfrppZ25QQsassZ66fourdoor Ford nine inch rear power window motors, cranks, and switches for door windows side door window glass- tinted- including wing window
October 21st 05 12:12 AM
by 66fourdoor Go to last post
0 418
TONS of Pontiac engine parts-ebay-$10-25 each-CHEAP by 66fourdoor
thick wall 350 block- D port heads- timing cover- wire looms- balancer- alternator/ps brackets- ps pump- RAM AIR I-II-III NODULAR IRON CRANK standard uncut- hi perf clutch fan for A/C GTO- nodular iron armasteel connecting rods- 1970-72 455 HO WINDAGE TRAY KIT- much...
October 17th 05 03:14 AM
by 66fourdoor Go to last post
0 153
still parting out- 1961 T-bird air conditioning system, etc. by 66fourdoor
now listing factory air conditioning system parts on ebay for 1961 Ford Thunderbird http://search.ebay.com/_W0QQfgtpZ1QQfrppZ25QQsassZ66fourdoor A/C compressor w/mount condenser w/receiver drier center chrome dash A/C vent
October 1st 05 01:19 PM
by 66fourdoor Go to last post
0 385
PARTING OUT-1961 FORD THUNDERBIRD-FACTORY AIR-P/W-P/SEATS-EBAY by 66fourdoor
many rare factory options on this 1961 Ford T-bird, many more listed on Ebay today http://search.ebay.com/_W0QQsassZ66fourdoorQQhtZ-1QQfrppZ200QQfsopZ1QQfsooZ1QQrdZ0? this car has a good title and only 63,000 miles. factory equipped with AIR CONDITIONING- SWING AWAY STEERIG COLUMN- 4 WAY POWER...
September 6th 05 07:27 PM
by 66fourdoor Go to last post
0 355
PARTING OUT-1961 FORD THUNDERBIRD-FACTORY AIR-P/W-P/SEATS-EBAY by 66fourdoor
I HAVE A COMPLETE 1961 FORD THUNDERBIRD- FACTORY EQUIPPED WITH AIR CONDITIONING- POWER WINDOWS- POWER SEATS- MUCH MORE- 100% COMPLETE CAR- HAVE JUST LISTED A/C COMPRESSOR- FRONT BUMPER- MARKER LIGHTS- HUB CAPS- ALSO A '73 4-BARREL MOTORCRAFT CARBURETOR FOR A 460 LINCOLN CONTINENTAL/MARK IV- EMAIL...
September 5th 05 01:40 PM
by 66fourdoor Go to last post
0 520
huge lot of musclecar parts-antique shop manuals-Brit sports car books-etc-EBay by 66fourdoor
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=7995819089&sspagename=STRK%3AMESE%3AIT http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=7995822967&sspagename=STRK%3AMESE%3AIT http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&rd=1,1&item=7996662846&ss...
August 29th 05 04:27 PM
by 66fourdoor Go to last post
0 457
1966 two speed motor by 66stang
I need to get my wipers working again. I dont know if theres a short or if the motor/switch is bad. So I need to order a two speed wiper motor, and a two speed wiper switch with washers. Anyone know where i can purchase either item? Tanks Evan
October 17th 06 08:03 PM
by 66stang Go to last post
2 280
Brake Failure by 66stang
Coming home from work Monday night my brakes quite working on my 66 stang. The pedal feels like it hits the floor but probaly is just maxing out its stroke. The stang has manual brakes, granada front disc's and stock rear drums. The first pump goes straight down with no resistence, each pump after...
January 27th 06 01:22 PM
by Ritz Go to last post
7 183
9" diff install by 66stang
I'm planning on installing a new diff over Thanksgiving weekend. I'm going to buy a "drop out" unit which comes with a third member, a Detriot Tru-Trac diff, and a new ring and pinion (with my choice of gear ratio) all pre-assembled and ready to be installed. Its going in the 9" underneath my 66...
November 16th 05 05:26 PM
by [email protected] Go to last post
4 480
New differential recommendations for 9" by 66stang
I have a 9" diff under my 66 stang. I believe its an open differential right now as a can leave a black mark with only the right tire. But I can leave two marks in reverse.(I wasn't trying too it just slipped) Possibly a burnt out Tracloc?? I am currently looking into the TracTech DetriotTrueTrac....
September 25th 05 10:40 PM
by 66stang Go to last post
6 332
Future of Ford by 72 Mach1
If the administration of Ford were interested in ensuring the future of this automotive company, wouldn't it make sense for them to voluntarily take a pay cut in an effort to make Ford sustainable. I realize that going from $10 million plus or even $20 million plus to perhaps a lowly $1 million...
(Multi-page thread 1 2 3)
December 1st 08 06:10 PM
by [email protected] Go to last post
26 1,285
Engine Swap and Mileage by 84_mustang_5.0
I am considering swapping my 302 for a 351W in my manual '84 mustang. I currently have a four barrel carb and I was wondering what kind of mileage I would get with a 351W with either a two or four barrel carb.
March 27th 07 03:26 AM
by JS[_3_] Go to last post
2 356
Where to get T Top Keys?? by 84_mustang_5.0
My 84 mustang has T tops and they have locks but i don't have the keys. I was wondering if anyone knew where I could get keys to lock and unlock the T tops.
April 27th 07 08:37 AM
by 84_mustang_5.0 Go to last post
0 452
Where to get T Top Keys?? by 84_mustang_5.0
My 84 mustang has T tops and they have locks but i don't have the keys. I was wondering if anyone knew where I could get keys to lock and unlock the T tops.
April 27th 07 08:37 AM
by 84_mustang_5.0 Go to last post
0 305
Where to get T Top Keys?? by 84_mustang_5.0
My 84 mustang has T tops and they have locks but i don't have the keys. I was wondering if anyone knew where I could get keys to lock and unlock the T tops.
April 27th 07 08:37 AM
by 84_mustang_5.0 Go to last post
0 330
Post New Thread


Display Options
Showing threads 181 to 200 of 6222
Sorted By Sort Order
From The
Forum Tools Search this Forum
Search this Forum :

Advanced Search

New posts New posts More than 15 replies or 150 views Hot thread with new posts
No new posts No new posts More than 15 replies or 150 views Hot thread with no new posts
Closed Thread Thread is closed  
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT +1. The time now is 05:51 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright ©2004-2024 AutoBanter.
The comments are property of their posters.