Fir those who haven't seen the 2005 Mustang ad in the corn field, right click on the link below and select "Save Target As". This video is 2.0 megs. http://avs.epix.net/cornfield.wmv Gary

In searching for subframe connectors (google) I see a wide variety.. I have a '96 coupe with no go fast options. Will subframe connectors make a difference in body flex? Is the something you have done at body shop (as I'd assume you'd want to make sure everything is level/flat to begin with.) The...

I am a newb to this whole Newsgroup (NG?) thing. However, I feel like I am in the right place to ask a very serious question. I have, among a few other things, a 2001 Ford Ranger. I am curretnly schemeing to put a better engine in it than the 4.slow SOHC that currently resides under the hood. I...

Not a big deal to some I am sure, but it is not something we see around here everyday. This was Wed. night about 10:30pm or so on Highway 44 North (East). www.mwcmustangs.com/roush_semi.jpg Don Manning

Any recommended d carb, intake 4bbl. set up for a 72 Mustang with a 351C 2v. Totally stock ,needs to fit under stock hood air cleaner. Why do lots of Mustang guys bad talk the 351C? This car a strong runner with ASSUME midrange! Thanks Fritz

The Mustang's Rack & Pinion is getting a bit long in the tooth. Looking to repair or replace. Looks like the right-hand tie rod is getting worn, I've never been in this area before so I need the kind of advice you give first timers. Can the rack be easily repaired or do I need to go with...

AAAAARRRRRGGGGGHHHHHHHHHH! The foul filthy foul filth 18G part filthy shortage foul filth! Grrrrrrrrrrrrrrrrrrrr! Sorry. Had to vent. :(

would anyone happen to know if an 18x10 wheel with a 275/40 tire clear all around? thanks

A young redhead goes into the doctor's office and says that her body hurts whenever she touches it. "Very rare but not impossible," says the doctor. "Show me." She takes her finger and pushes her elbow and screams in agony. She pushes her knee and screams, pushes her ankle and screams. Everywhere...

Could I get some insight on the differences and the opinions from this group on which is the best engine and why? Al

Hi Folks, My '87 GT broke after I stopped to check the mail. I try to start it, it cranks but doesn't start. Then I notice I can't hear the fuel pump energize when I turn the key on. I checked the inertia switch to see if it had somehow popped but it seemed ok. I'm going back for it tomorrow....

For those of you that store your car over the winter, do you drain the oil and put fresh in and then change it again come spring? I was told once that oil turns acidic through time and that it wasn't a good idea to let it sit for more than three months. Is this true? Thank you, -- Sean

Ford's blue color they have looks more purple to me. Any thoughts?

I have a 98 GT Mustang and I have noticed that occasionally I get water collection in the "diaper" behind the rear seat. I water does not always collect there, it seems to only appear after slow drizzle type rain when parked and not in down pours or when the vehicle is in motion. Any suggestions?

DONALD TRUMP wrote: > Bill, all you had to do was make the new mustang with the same > exterior as the show cars you you were parading around all year. > instead u give us this narrowed up p.o.s., wider is better. > > oh i almost forgot, your fired. > > regards, theDonald Obviously written by...

I am just wondering if anyone else has had a problem with a whining noise that sounds like it is coming from the power steering? Took it to ford and they said all 2004 mustangs whine...do they?

>Subject: Santa Clause like you have never seen him before >From: >Date: 12/29/2004 8:38 AM Eastern Standard Time >Message-id: > > >Santa Clause like you have never seen him before, this is a must see for >everyone:...

My '05 GT has two 'dimples' in the front, plastic bumper for the purpose of mounting a license plate. I assume that means drilling the plastic bumper and bolting a plate on. I can envision sheer ugliness. Any ideas or better mounting tips. Anyone know of frames which would match body colors...

very nice. the stripes should really be a factory option. On Wed, 05 Jan 2005 03:35:05 GMT, "Ryan West" > wrote: >Here is our 05 Mustang with Mach stripes. I put the vinyl stripes on myself. >Comments are welcome > >Ryan >

Could someone be so kind as to point out the differences between these two vehicles. I believe they are close in power but SOHC vs DOHC ? -- 2.3Sleeper: "Anyone know how to disable the daytime running lights on a 2001 Crown Vic or on a 2002 GMC?" SVTKate: "A ball peen hammer?"