|
|
engine pull by
Jeff Barnes
Jeff 1974 vw bug looking for the bottom engine bolts to pull the motor. ARE
THEY on to of the engine tin that protects the valves connected to the
heater boxes? lots of oil and junk leaking from the old tubes for 120,000
miles
|
|
9 |
942 |
|
|
Jim Mais by
Speedy Jim[_2_]
On 5/18/2011 9:20 PM, Joey Tribiani wrote:
> How are ya buddy?
Still kickin'.
Thanks for the thought. :)
I still keep my finger in the VW pie,
but haven't had the time to stay on RAMVA.
|
|
0 |
941 |
|
|
78mm crank? by
Anthony W
any recommendations on where to get a good 78mm crank. The one at
Aircooled.net is rather expensive and I'm not yet convinced that I need
to spend that much.
Tony
( 1 2)
|
|
17 |
941 |
|
|
|
|
10 |
940 |
|
|
|
|
0 |
940 |
|
|
Modifying a VW for the postapokalyptic future .... by
Robin-Louis Clevis
You know, 2006 is near, the nuclear war with Iran is only a few months
ahead.
After that, the Earth will be a desert, radioactive and most parts
uninhabitable.
So how can I modify my VW so that I can still use it in the desert
world of tomorrow ? You know, some Mad Max "The Road Warrior" -...
( 1 2)
|
|
16 |
940 |
|
|
Hesitant 1972 Bay by
Gareth Edwards
Recently started having this problem with my Bay 1600cc. It is very
hesitant at low revs, and even if I put my foot down or pump the throttle a
bit too get some fuel in there, it still takes a little while to pick up.
Once the revs pick up it pulls strongly. It needed a service anyway so I...
( 1 2)
|
|
14 |
939 |
|
|
|
October 26th 04 09:14 PM
by vwluvrs
|
0 |
939 |
|
|
|
November 12th 04 07:14 PM
by Mark
|
6 |
939 |
|
|
71 super beetle brake problem by
xeon19
I have changed everything on this car. Master cylinder, metal lines,
rubber hoses, wheel cylinders and still have the same problem that I
started with the pedal goes to the floor if I pump quikly they will
get tight I can even move back alittle on the pedal and push forward
and it will hold but...
( 1 2)
|
|
15 |
939 |
|
|
Type I Clutch Cable by
Doug
I have a 1967 Type I Beetle with a stock diaphragm clutch. The clutch
cable breaks every couple of years. It always breaks at one of the ends
where the cable is crimped into the fitting. It never breaks anywhere in
between. I always grease the cable upon installation. Is this common to
break this...
( 1 2)
|
|
11 |
938 |
|
|
Old computer program "VW Mechanic" by
SeventyOneBug
Hi... I'm new to the group and wanted to first say "Hi". I have been a
long-time bug owner (for about 20 years) with miscellaneous bug over
those years. Most recently a '71 standard bug. My last one was a '58
that I had to get rid of because I moved and it just wasn't going to
work out. (Wish I...
( 1 2 3)
|
|
24 |
938 |
|
|
Brought another VW home today... by
Project Magnet #1
I ran across this in someone's signature on Samba:
"1960 VW bug/pickup conversion (junk)"
I sent him a message asking if he had pics of it. He sent me a few and I
offered a trade of a tacked together rolling sand rail chassis for it,
Today, after 276 miles and 3/4 tank of diesel, the Baja...
( 1 2)
|
|
14 |
937 |
|
|
Rear diagonal arm -- fasterner question by
Remco
I'm looking to take my 72 rear diagonal arm off. With the tranny out,
the frame is almost bare so taking this piece off gives me a good
chance to get rid of all the rust and re-paint it all.
That 17" allen bolt is to be "peened" according to Bentley.. What does
this mean, exactly?
I noticed it has...
( 1 2 3 ... Last Page)
|
|
43 |
937 |
|
|
Fuel Smell by
Spike
Hi all,
Quick question....
If you can smell petrol/gas is it at a combustible level?
I have a very faint smell of it when I open the bonnet in my 68 Type1.
Cheers
Spike
( 1 2)
|
|
10 |
936 |
|
|
Hydraulic Valve lifters... by
devilliers
I have a 1979 Type 2 bus that has been laid upm for 7 years.
The valves had been set with a gap.
In then correcting the hydralic setting to 2 extra turns there was
then no compression since the valves were now not seating.
How does one cure this problem?
Wioll the hydraulic sleeves leak away...
|
April 12th 07 05:50 AM
by Karl
|
2 |
936 |
|
|
she says 53 beetle has to go by
fullopiss
THAT **** SHE SAYS I HAVE TO SELL IT, CAN YOU BELEIVE THAT!!!! ANYWAY IT HAS
HAD A GROUND UP RESTORATION AND NO RUST WITH ONLY 10 MILES ON THE NEW
ENGINE. I AM WILLING TO SELL IT FOR $5 - I LIVE IN ****ING FINLAND
( 1 2 3 ... Last Page)
|
|
30 |
936 |
|
|
Alldata 2004, [4 DVDs], [53 CDs], Mitchell CDs, year 2005 - 2003 , 53 CDs, total 107 CDs by
ola
Alldata 2004, , , Mitchell CDs, year 2005 - 2003 , 53
CDs, total 107 CDs
-----------------------------------------------------------------------------------------------------
Alldata 2004, ,
ARRIVED IN BETWEEN 31/MAY/2004 to 28/JUNE/2004
FULLY FUNCTIONAL, AND GOOD FOR UNLIMITED SEATS.
|
May 7th 05 08:26 PM
by ola
|
0 |
936 |
|
|
no start by
my 74 type one will not start i turn the key and NOTHING no click nothing
battery is good any suggestions on where to look?
jerry
|
August 8th 05 04:21 AM
by Funkie
|
3 |
935 |
|
|
Painting a VW, please help a naive person: by
Mike
For sometime now, I have been tempted to rattle can my VW. I do not
have a compressor, but I have the desire to get a good, but cheap paint
job complete. Any ways, I was wondering if anyone could walk me
through the paces on painting a car?
I imagine it goes something like this: sand the paint...
|
|
7 |
933 |