|
|
Need Advice: 93 Aerostar Rack & Pinion by
[email protected]
My 1993 Aerostar (170,000 miles) rack & pinion has been leaking power
steering fluid for quite a while. I plan on replacing it with an
Autozone or Checker rebuilt assembly and since the suspended wheel has
play when shook, the outer tie rod ends for both front wheels at the
same time. I do have...
|
July 24th 06 11:53 PM
by Kevin
|
4 |
655 |
|
|
Need Advice: Removing Ford Power Window Regulator? by
Josh[_8_]
The driver side power window motor on my 93 Ford Aerostar (171,000
miles) has gone bad. I know it's the motor or regulator gearing and
not the switch or wiring because when I put a good 12V and ground
directly to the motor wires inside the door panel, the motor still
won't turn in either direction....
|
|
1 |
239 |
|
|
Need advice: rust spots + painting by
[email protected]
Hi all,
This group has been particularly informative for me over the last
little while. One day, I hope to contribute with some answers of my
own...but for now....
I have a 10-year old car that has some rusty areas, mostly surface
rust. Looks like I can sand down to bare metal without...
|
|
0 |
478 |
|
|
Need advise on approaching an ECU design project. by
[email protected]
Hello All,
I'm not sure if my question is relevant to this group. If not, please
guide me.
I'm interested in learning and building an engine injection control
system. I have access to electronics companies who can design as per
theory given.
Specifically this is what I want to do: design a...
|
July 10th 08 11:02 PM
by N8N
|
3 |
359 |
|
|
need an advise 2000 2.0 Jetta slushbox flush by
[email protected]
how much atf do you get out of the turn of the century 2.0 liter jetta slushbox?
(jetta is 5 door golf outside the states I think)
a coworker is planning to get one. I advised him
to change the fluid first thing after the purchase but dunno
if he'd need another one soon afterwards :)
|
|
3 |
418 |
|
|
Need an expert... by
steamer
--We're building a couple of small cars from the keel up; i.e.
starting with transaxles off of a couple of garden tractors. It'd go a *lot*
faster if we knew what the heck we're doing!
--Location: Santa Rosa, CA. Ping me offlist if interested in getting
involved in a really strange couple of...
|
December 19th 07 05:48 PM
by steamer
|
0 |
506 |
|
|
Need assistance re-installing C-4 shift shaft & valve body by
HiC
Both sets of pics are the same pieces from different angles. How are
the arm A and little nub B supposed to interact with the valve body?
Looking at the depressions in the machined piece on the valve body, is
the nub supposed to nest in one of them? And if so how do you
determine which one? Or is...
|
|
2 |
386 |
|
|
Need Auto Repair questions answered right away by
[email protected]
Need Auto Repair questions answered right away, email me for an answer,
(Journeyman Tech). )
Home of AutoTree Automotive diagnostics software, Low priced $35.00,
includes exstensive OBD II error code database, buy with Paypal.
www.vehiclerepair.org
|
August 2nd 06 08:26 PM
by *
|
1 |
521 |
|
|
Need Auto Shop software recomendations by
Steve Smith
Can anybody here recommend some good auto shop software. I've been using
Auto Shop Controller from http://autoshopcontroller.com/ but it's buggy and
I'm ready to change to something else.
Thanks,
Steve Smith
|
|
0 |
545 |
|
|
|
December 29th 04 06:22 PM
by .
|
4 |
727 |
|
|
Need axles for a 2001 Impala - where? by
Peter Langevin
Does anyone know of an aftermarket manufacturer of axles for a 2001
Impala, 3.8L police model? OEM are $360 a piece, and I'm having a
hard time finding anything aftermarket.
Any help would be greatly appreciated.
Paul
|
February 4th 05 09:38 PM
by BOB URZ
|
1 |
710 |
|
|
Need Calgary Mechanic, 88 Bronco by
Djrealmz
Hey all,
I'm hunting for suggestions for a mechanic in Calgary for my
girlfriend's 88 Ford Bronco. There is an issue with one of the door
locks and it occasionally feels like the brake is squeezing on and
off lightly when going from stop to start. Any recommendations for a
place to take it would be...
|
|
0 |
271 |
|
|
Need Car Repair Advice by
[email protected]
We have a 96 Neon with two oxygen sensors. According to one mechanic,
the one by the exhaust pipe was not working properly and should be
replaced. Another mechanic said it wasn't necessary because it would
only affect emission. The computer would automatically follow the
preset air/fuel ratio. What...
|
November 8th 05 07:20 PM
by *
|
6 |
663 |
|
|
Need car wiring website links, please by
javelin
I bought a used Protege that was wired strangely: the gas and radiator
fan are turned on via a manual switch. These can be turned on even
when the car is off, so if you forget to turn them off your battery
dies.
Can someone refer me to a website that will give me information on
rewiring my car to...
|
|
4 |
337 |
|
|
need carfax by
Audrey[_3_]
can someone post report or email to add below for
JACDJ58X817J04577
if email, to triple M (three times the same letter) at utsjokelainen.com
|
May 11th 07 07:34 PM
by *
|
2 |
396 |
|
|
need cash? EASY, LEGAL, NO BS- IT WORKS! by
[email protected]
HOW TO MAKE EASY MONEY FAST AND LEGALLY!!!!!!!!
This seems to really have potential. This is the way the original post
appeared when I first found it. Read it all then decide for yourself.
It works for me! I found this on a bulletin board and decided to try
it. A little while back, I was browsing...
|
|
0 |
188 |
|
|
need civic tech for D16Y8 engine swap by
brian
I am looking for a Civic tech for a D16Y8 swap in either Delaware or
Philadelphia. I need an engine and gearbox swap, and have all of the
parts. This is nothing fancy, just strictly stock component work.
If you or someone you know can help me out, then please email me asap
at 'bdoreste at...
|
February 12th 05 11:48 PM
by brian
|
0 |
517 |
|
|
Need exhaust by
m.c
Anyone know of reasonable place to go? Located in Dallas area. Have 86 Chevy
truck, nothing beyond manifolds. Need catalytic converters and mufflers to
pass inspection
|
June 28th 06 10:39 AM
by m.c
|
0 |
357 |
|
|
Need expert advice (halide to halogen?) by
John Diamond
I have a 96 Lincoln Mark 8. I don't care for my current headlights, which
are metal halide bluelights.
My question: Is it possible to convert them over to regular halogen
headlights. If so, how would I go about this?
Thank you!
|
|
7 |
727 |
|
|
Need explanation for computer code for '93 Camry by
[email protected]
I have a '93 camry v6 that has a check engine light. When I go through
the procedure to get the computer code, it gives me one not listed in
the book!
I get a 28. The last code in the group listed in the Haynes manual is
27. Most of the 20s list problems with the oxygen sensors. This car
must...
|
|
1 |
358 |