|
|
Best Auto Repair Software / OBDII Code DB by
[email protected]
Best Auto Repair Software / OBDII Code DB
Autotree Pro Ver. 1.45 is a 32 Bit ( WIN95-XP) software Application
for automotive diagnostics. The program written in a Tree format to
make systematic and quick diagnostic checks a breeze, organized by
area (Engine, Transmission, Electrical, Fuel,...
|
|
0 |
524 |
|
|
probably a dumb question, but I have to ask.... by
[email protected][_2_]
I have an older car that sits a lot of the winter and I just fire it
up occasionally, then drive it in the summer.
The other day, I drove home, parked and then it would not start. The
engine would not even turn over. Then I stuck the key in again and it
almost threw the engine out of the car...
|
|
8 |
672 |
|
|
|
July 3rd 07 05:57 AM
by jbjeep
|
37 |
1,517 |
|
|
OUR COMPANY PROVIDES SOLUTION FOR VEHICLE TRACKING DEVICES by
sales
ELDA SARANA INFORMATIKA.LTD (ESI)
Our company provides solutions for GPS tracking devices for vehicles
and other telemetry devices based on radio, GSM, and satellite
communications.
Experience in building GSM based GPS tracking devices since 1999, we
are committed to make a better, robust, and...
|
July 3rd 07 10:25 AM
by sales
|
0 |
573 |
|
|
|
|
3 |
310 |
|
|
2000 Jimmy 4.3 vortec Hesitation by
troublecode
Problem: Hesitation/Lack of Power/Slow (Stumbling) RPM Increase on
Acceleration from Idle or Cruise at Moderate Speeds. Occurs 70 - 80%
every time. Can be Duplicated in Neutral in Garage. Condition occurs
with Hot or Cold Engine. Vehicle always starts and idles normally, as
if no problem...
|
|
3 |
379 |
|
|
Can an exhaust pipe be "epoxied"? by
Stan[_2_]
First the background...the vehicle is a 93 Nissan Quest minivan, 6 cyl
engine, with an exhaust leak.
It has about 270K miles on it, and living on borrowed time, so putting
in $500 to replace pipes is not very cost-wise. Yet I don't want exhuast
fumes coming up & I'll have to pass the state's DEQ...
|
|
5 |
409 |
|
|
bad mold smell from 1997 Honda Accord AC by
[email protected]
I have over 200K on my 97 Accord. I recently had one of the valves
replaced on the AC unit where they removed the evaporator. They found
a ton of mold in the evaporator case and cleaned it out with bleach. I
always did often have a mold smell come out of the AC when it started
up for a few minutes....
|
|
2 |
288 |
|
|
2000venture no start by
David Deeter
has new fuel pump
both crank sensors
cam sensor
plugs and wires
sound like its going to start when first crank it but then it just turns
over
|
|
1 |
252 |
|
|
|
|
0 |
488 |
|
|
Transmission Cable on 85 Porsche 944 Needs More Tension by
JD
I came into possession of the 85 Porsche in a convoluted way, and I am
looking to eventually sell it. A good mechanic has told me that the
cable hooked up to the transmission has become fused near the
catalytic converter in the tunnel between the front of the car and the
back and that it needs to...
|
July 3rd 07 10:02 PM
by N8N
|
1 |
350 |
|
|
1994 Ford Escape - low brake pedal height by
LinuxTester
hello all ...
1994 Ford Escape V6, front discs, rear drums, right at 35,000 miles.
replaced the front rotors and pads. the brake pedal moves closer to
the
floorboard than is usual. the brakes do stop the vehicle, but the
pedal
is much closer to the floor now (than is usual).
( 1 2)
|
|
10 |
559 |
|
|
Removal of evaporator core from 1997 Dodge full sized van by
No Name
I finally got a chance to get out and work on this one.
You must remove all the restraining bolts, from inside the vehicle and
outside,and then you
must disconnect all the controls, hoses, etc.
Then , you have to remove the sheetmetal which holds the hood latch
mechanism, and then
remove the...
|
|
0 |
312 |
|
|
Corvette Dollar. by
[email protected]
I just now saw a commercial on the AMC tv channel about it, if you want
to check it out. www.corvettedollar.com
General Motors is celebrating their 100th anniversary.There are other
models of the car coins available too.The whole set for $19.95.
cuhulin
|
|
5 |
442 |
|
|
Should head bolts be lubed or un-lubed? What about thread sealer? by
Doc
Getting ready to put a Toyota 7MGE engine together. A family member
insists the head bolts should be lubed before torquing. Agree or no?
If so, what's the lube of choice? Also, is thread sealer neccessary
for this engine? Do the head bolt threads encounter the water jacket
at all?
Thanks.
( 1 2 3)
|
|
28 |
1,128 |
|
|
Cyclops Car by
[email protected]
http://home.att.net/~Berliner-ultrasonics/autocycl.html
Now there was a real car, no doubt about it.
I have some old Road and Track magazines here which have some articles
about the Cyclops cars.
cuhulin
|
|
0 |
443 |
|
|
C-4 trans leaking from around shift lever by
Doc
Have a C4 in a Fairlane that's leaking from the case at the shift
lever assembly. Any opinions as to what the root cause probably is and
what can be done about it? Losing probably a quart a week or so.
Thanks.
|
|
6 |
329 |
|
|
99 Taurus Headlight "De-Hazing" Results by
Don Byrer
Like many of you with plastic headlamps, my 99 Taurus' ones were
hazed/fogged/scratched/pitted/etc....Not much light coming thru! Owned
the car since new, never did anything to maintain them...tho I
frequently cleaned them with a filling station window sponge/squeegee
(yeah, THAT didnt help!)
So,...
|
|
7 |
773 |
|
|
|
|
0 |
406 |
|
|
|
July 4th 07 03:42 PM
by *
|
2 |
457 |