|
|
97 GMC Sierra misfire by
zman13
My truck started ideling rough and engine light came on. I had it scanned
and the code was a misfire on cyl. 5 I have replaced the plugs, wires,
cap, rotor, pcv valve, and fuel filter. It is still running rough till
about 2000 rpm and engine light is on . I had it scanned again and came up
with...
|
March 31st 05 05:21 AM
by zman13
|
0 |
480 |
|
|
performance with headers and dual exhaust on 350 by
joelmary4
I would like to install headers and dual exhaust on my 1995 GMC Sierra 2WD
350. I've been told this will hinder my performance, gas mileage and
power.
Any truth to this or will this installation actually improve these things?
|
March 31st 05 05:50 AM
by .boB
|
1 |
649 |
|
|
HELP 1986 F250 4WD Clutch by
[email protected]
My 1986 F250 clutch does not disengage completely. What needs service,
replacement? Why? The transmission is 4sp, clutch is hydralic. The hyd
resovoir is full. There are no leaks at the master or slave. Peddal
"feels" normal both in compression & release, not too soft or hard. The
clutch doesn't...
|
|
4 |
293 |
|
|
1985 toyota pickup by
[email protected]
I need to find a new (good condition) bench seat or bucket seats for my
85 toyota 2w drive longbed. I have looked but was unable to find any.
Any suggestions???
|
|
0 |
363 |
|
|
Anybody here a Suzuki Samurai fan? by
AT Commander
I've got an '87 Samurai with humble mods (tires, catback, headers,
cage). It hasn't been driven much in the last 5 years, but now it's
my daily driver in addition to fun adventure vehicle on the weekend.
I've got an idle problem. Either it's racing at 3,000 or stumbling
along at less than 1,000...
( 1 2)
|
|
14 |
965 |
|
|
WTB: Factory Spare Tire Mounting Bracket by
websurfer
WTB: Factory spare tire mount for underbed of 1997 Ford F-250 4x4, 8' bed.
Any of you guys who've jacked up your truck "baha" style and have your
spare mounted to the rollbar and want to get rid of the factory mounting
bracket, please respond. Prefer clean, usable parts, no rusted out...
|
|
0 |
478 |
|
|
'95 Blazer 4X4 Diagnostic Codes. by
Munchkin
Engine is 4.3L V6 Vortec fuel injected. Does anyone have a list of the
diagnostic codes? Can't seem to find them in the Haynes manual. Any help
would be appreciated.
|
|
2 |
306 |
|
|
Tow Hooks for an '02 ram 1500 by
js
I'm looking for front tow hooks for an '02 dodge ram 1500. Mopar has a bar
with 2 hooks for the front of '03's on up, but they say it doesn't fit an
'02!
Thanks,
Jerry
Check email address if replying directly.
|
|
2 |
462 |
|
|
Diesel for 86 Nissan by
be3805
I am trying to find an engine and tranny for my 86 nissan so I can
experiment with bio diesel. anyone out there know where I can look.
|
|
5 |
325 |
|
|
87 Dodge W150 Spicer 44 rebuild by
AlaskanFishGuide
HELP!!! I am trying to rebuild my spicer 44-8FD front axle on my 87
Dodge W150. I am comfortable around tools and don't mind getting
dirty... however I cannot seem to get the ring and pinion free from the
housing. I have removed the bearing caps, pried, pulled, smashed, etc
and can't seem to get...
( 1 2)
|
|
13 |
592 |
|
|
97 nissan 4x4 se driveability problem by
plummer
check engine light on will not go over 2500 rpms acts just like a rev
limiter, apply gas and steady in time surge between 2100 and 2500 rpm.
exhaust free flowing major tune done 8000 miles ago.
|
|
0 |
188 |
|
|
Old Man Emu by
Walker
Anyone care to give me their thoughts on Old Man Emu suspension systems. My
hopes are for a better ride on rocky and rutted roads with no intentional,
or extreme, rock climbing. Thanks
Bob Walker
|
|
3 |
192 |
|
|
Landcruiser 1990 PZJ73 5 cylinder? by
Lauren
Hello, we are near Cairns and have a 1990 PZJ73 5 cylindar medium
wheel base cruiser we are looking to sell. As this is a rather unusual
model, can anyone recommend a good place to list this car? if anyone
also has a resource I can use to find a value on it, that would be
great.
Many thanks,
chris
|
April 3rd 05 12:44 PM
by Lauren
|
0 |
190 |
|
|
electrical issue - help by
minpinmama
about 6 mths ago we had a dead short on batt cables. Since then we have
replace: starter, alt, new batts, batt cables and have done cks on fuses.
The pkup has power to the system but will not turn over. We hear clicking
like the cellinoid in starter working. We have hit a wall. Any ideas
would...
|
|
1 |
360 |
|
|
1988 Toyota 4 runner v6 by
julius
I have this car and I rebuilt the engine and everything is back in place.
I turned the starter on and all I hear is a clicking sound. also. what do
I do even if the stater was hooked on right? How do you feed the fuel
manually through the system? And if possible does anybody have the fuel
and...
|
|
1 |
306 |
|
|
|
|
0 |
196 |
|
|
|
|
0 |
254 |
|
|
FA Kenwood Excelsion Z919 MP3 Car Stereo by
[email protected]
Kenwood Excelsion Z919 MP3 Car Stereo
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=5765310675&rd=1&sspagename=STRK%3AMESE%3AIT&rd=1
Thanks for looking
Unit is in PERFECT condition, Sold Vehicle and New one dosent need it.
Has Remote with it and great graphics and auto tilting face for...
|
|
0 |
284 |
|
|
Personal Computers in 4x4s by
Kenner Costen
I am in the process of adding a computer to my truck ( I spend 60 hours a
week in my truck as my mobile office). If anyone has any links to web sites
w/ what others have done or hardware designed for extreme duty, please let
me know. I will be documenting my installs on a web domain I just...
( 1 2)
|
|
11 |
667 |
|
|
Coolant filter on eBay, Fram PR3304 by
Alan Petrillo
For any of you dieseleros who run coolant filters:
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=7966365741
AP
|
|
0 |
642 |