|
|
test by
pmhine
this is just a test
|
August 15th 07 02:59 PM
by pmhine
|
0 |
297 |
|
|
dash lights by
labtech_one
I've ready that the bulbs in the dash, on a C4 can be replaced
with 194 bulbs and appropriate bulb holders.
good side is the bulbs are cheaper, and easier to get
but the down side is the dash is dimmer.
has anyone, replaced the bulb holders, and used
those high intensity LED replacement 194...
|
|
4 |
703 |
|
|
1976 corvette original dealer brochure. by
:\
Hey guys:) I have had this since I looked to buy one back in 1976. It
has been in a folder and just found it. The poster car of that year was
orange and very nice. Has all the specifications,options and so on and
lots of pictures. You can email if you are interested in it and I will
sell it...
|
August 14th 07 05:15 AM
by :\
|
0 |
396 |
|
|
Interesting problem to try... by
Wes[_2_]
Hello everyone,
Here is an interesting thing to try. I have a 2007 Corvette with OnStar and
Hands-Free Cell Phone using Verizon Family Plan.
Try this... Dial 511 (for Road Information in most States)
Dial 911 for Emergency
From what I have tried it CAN NOT be done.
|
|
9 |
490 |
|
|
Ping : Butcher by
Dave in Lake Villa
Howdy. Did you get your overheating problem solved, or lessened ?? I
see that Texas is approaching the stage of heat only found in Hell !
In addition to the 1970 BB, i also have a 2006 LS2 with a 160 f. stat
installed ; this cooling system is remarkable as when its 98 f. outside
, i can still...
( 1 2)
|
|
18 |
815 |
|
|
double camel back heads by
Carl K
I hear the 327 I have came from a 'vette. I hear the heads are 'nice.' I put
the thing in a 350 monza, but never got around to finishing that project.
How special are the heads anyway?
Carl K
ps, please reply-all so that my email gets hit, otherwise I may forget to check
back here.
( 1 2)
|
|
14 |
913 |
|
|
Source for lug nuts and washers for ET-!V wheels on 63? by
lib
I would like to purchase new hardware for the above 15' X 6.5" set of 4. The
rims cleaned-up well but the nuts+washers had some deep rust. The car is
nearly finished, w/new Goodyears, and looking good so would like to replace
the rusted pieces. Any clues on who I might contact to purchase these...
|
August 14th 07 01:27 AM
by lib
|
0 |
456 |
|
|
Thinking of upgrading to C5 by
Garry Horoupian
Hey Everyone
I currently have a '90 C4 red/black 6-speed and am thinking of upgrading to
a C5.
Is there a particular year that was better than others in terms of
reliability? Are there things I should look out for when looking at C5's?
Thanks in advance for any advice
Garry
( 1 2 3 ... Last Page)
|
|
59 |
3,280 |
|
|
C3 Front Sway Bar Bushings by
[email protected]
Hello All
Rebuilding the front suspension (1977) and noticed that the front sway
bar upper bushing (on both sides) is smashed like a pancake. What
would cause this, and is there anything I can do about this? Possibly
improper installation procedure? By the way, the bushings are rubber.
Thank you...
|
August 12th 07 11:39 PM
by pete
|
1 |
685 |
|
|
Rear Spindle / Bearing Tools - Used by
Koilmaker
I would like to purchase used tools to rebuild my 72 Vette rear
spindles. I am looking for al of them - bushing flaring tool, spindle
setup tool, etc.
Please email me if you have any C3 Corvette specialty tools for sale -
used only
Thank You
|
|
2 |
420 |
|
|
|
August 9th 07 02:43 AM
by Bob I
|
0 |
645 |
|
|
Ignition Switch by
[email protected]
I have a 76 that needs the ignition switch changed. I have the wheel
off, but can't figure out how to get the next piece off to get access
to the key clinder and switch. It looks like a flat plastic cover.
Thanks for your help
Mike
|
August 8th 07 08:36 PM
by 'Key
|
9 |
988 |
|
|
C6 Reaview Mirror by
Joe[_76_]
Have a 2006 C6 with the manual rearview mirror.
When I exit the car the instrument lights shut off immediately as
expected but the reading lights on the mirror remain on for about 15
minutes.
There are two buttons under each side of the mirror that are supposed
to control the lamps.
When is the...
|
|
4 |
321 |
|
|
1963 250hp timing specs? by
lib
What is the initial timing of the distributor (w/vac. adv. plugged) @ 600
rpm? I have the shop manual and can't find this setting in it. Can anybody
relay to me the page this setting is on, if it is in the manual. I've went
thru the specs' page and can't find it anywhere. Thanx- lib
|
|
6 |
438 |
|
|
2007 Vette Time by
Wes[_2_]
Hello,
I drove from Nebraska to Indiana this last weekend. I expected the time on
the radio to change when I went from Illinois to Indiana (CT to ET). The
time did not change.
I believe the clock gets its time from the GPS, so why doesn't it change
time?
Thanks ahead of time,
|
August 5th 07 06:53 PM
by PJ
|
3 |
408 |
|
|
Incentives yet on 07's and question Supplier Discount by
ScottO
Anyone heard of any incentives on left over 07's? I was at the dealer today
and there were 5-6 07's and one 08. Manager said he'd sell any 07 for
$500.00 over invoice, whatever that is.
Also, I'm eligible for the GM Supplier Discount. Anyone know if they
discount as much off the 08's as the do...
|
|
1 |
329 |
|
|
Engine shutdown by
rigger
I have a 95 Vette with 77k on it. I bought it 2 1/2 yrs ago. It had 75k. A
couple of months after
getting it I was at a stoplight and it stalled. When I restarted it would
only turn over and over. I waited 10 minute's or so and it fired up with
no problem. This happened a couple of times. Last week...
|
|
2 |
551 |
|
|
clap clap I'm out by
RS[_1_]
Selling my 94 Vette. Because I need a year-around car that combines
performance and style that the vette gave me + winter security that my 4x4
ranger gave me. But only want 1 car (room + insurance are factors). had
listed the vette in paper, response was light due to high asking price. I'm...
|
August 3rd 07 01:05 AM
by 'Key
|
3 |
317 |
|
|
Painting 1977 Corvette by
Mark French
I have a 1977 Corvette that I am considering repainting. I have a
shop that will work with me and help me through the job, as I have
repainted cars etc. over the years with good results. I am going to
do the prep work and they will paint it. The questions I have a
The car has the original...
|
|
1 |
260 |
|
|
1975 Stingray Corvette Convertible... want to sell by
[email protected]
I have a 1975 Stingray Conv. that I have to sell. I have no idea what
she is worth. I bought her a little over ten years ago. The Stingray
is solid but needs tender love. Rebuilt with 28k miles, new interior,
brakes. Can someone guide me in a direction. I paid $10K. I will be
moving to Key Largo...
( 1 2)
|
|
13 |
878 |